- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Bobby, oil pan bolt torques for 4.0 Wrangler.
Oil Pan Bolts 1/4
84 in-lbs
Oil Pan Bolts 5/16
132 in-lbs
As far as sequence, see last link, start in center, criss cross pattern tighten snug all, then repeat to torque spec.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info." Oil Pan Gasket leaking http://jeephorizons.com/tech/99_40l_torque_specs.html 98 jeep 4 0 oil pan bolt torque sequence specs Google Search
jack it up, drain oil from drain plug on oil pan when drained remove and replace oil filter also. remove the pan bolts pull off pan and gasket.put new oil pan gasket on if needed.when oil pan bolts are back in, screw them in hand tight, then torque them down to specs and alter nate the tightening so it wont damage pan seal. any auto parts store can tell you the torque on the bolts for your car. good day!
easy job. Just loosen pan bolts enough to let the fluid start draining from one end. As more drains, keep loosening the pan bolts till you can remove pan and finish draining what's left in the pan. At this time, most people would also change the transmission filter body: it's right on bottom of trans. when the pan is removed, easily accesible. Parts stores sell a kit with new filter and pan gasket included. Anyway, now you are ready to install new pan gasket. Clean gasket mating surfaces as clean as you possibly can. let no oil or fluid get back on there. Place gasket on (most don't recommend adding sealant or gasket compound). Put pan on with all bolts fingertight. Then starting from center outward, start tightening them down to torque specs-it'd be pretty light torque, like around 20 ft-lbs-might want to ask a ford mech. what torque specs are. When done, refill ****** and check for leaks after running car.
Well first of all you need to drain your oil. You also need a new oil pan gasket and oil pan. After you put on you new gasket you need to make sure you torque it with a torque wrench to your cars specs. You can rent a torque wrench if you need from almost any parts store if you need to save money. Also you need to torque them in an order. Usually it's inside out but yours may vary. I would suggest getting a book to show you the order for tightening. Good luck!
not oil pan but gasket remove oil pan scrape off all old gasket and put on new one the best thin to do is glue it on the oil pan first and let dry with bolt holes in line the glue it to block but this might no be the problem headgasket could leak oil pump gasket valve cover gasket
×