Question about Cars & Trucks

1 Answer

I have a 1995 ford taurus sho that will not start. The fuel pump was changed but still not getting any fuel pressure

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 2,101 Answers

Have you checked the fuel pressure regulator on the fuel rail

Posted on Dec 05, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: engine stalls out intermitently

First I would replace the fuel filter if it hasn't been changed recently, might check the fuel pump relay, might be going out. Lastly, it might just be the fuel pump going out. I just had to replace mine on a '96 SHO. Hope this helps

Posted on Nov 28, 2008

  • 36 Answers

SOURCE: basics on where and how to change fuel pump

yes the fuel pump is in the tank and you will need to drop the tank to get to it.

Posted on Jan 04, 2009

litoshop
  • 298 Answers

SOURCE: I have a 1995 Ford Taurus SHO 3.0 liters. I

Hi did you do a continuity check check if there's a wire shorted or open you'll need a volt meter check if the wires on the crank sensor going to the control module and also the one from the coil to the module there has to be a shorted or open wire check this and get back to me good luck

Posted on Sep 04, 2009

  • 484 Answers

SOURCE: where is the fuel filter on a 1994 ford taurus sho

Under the chassis below the fuel filler, you will see a plastic cylinder with two hoses going into it. This is the fuel filter. Before you remove it, depressurize your system by opening the gas cap.

Regards,
matt

Posted on Sep 15, 2009

emissionwiz
  • 74945 Answers

SOURCE: 1995 Ford Taurus Sho 3.2 check engine light blink

Code 33 is EGR opening not detected, this is caused by a plugged EGR exhaust passage in the upper intake manifold, this is a common SHO engine fault, the valve works but the engine does nothing that the computer can sense, since no gas flows, to verify this is the problem open the egr at idle, the engine should almost die, if nothing happens or only a tiny change in idle speed or quality the passages are plugged, if it does stall or get real rough the egr position sensor (usual code for sensor is 32) may be faulty or the valve is sticking. I was a ford dealer tech for 30 years and did quite a few of these, there is a TSB (technical service bulletin) about this problem

Posted on Oct 21, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 Taurus 3.8 SHO wont start replaced everything fuel pump to big relay is buzzing even new one im lost need help


Run tests. Fuel pressure correct? Spark at plugs when cranking? Fuel injector pulse working? Compression test?

Apr 06, 2015 | Cars & Trucks

1 Answer

My 1996 Taurus sho cranks but won'tstart up change


Try replacing the camshaft position sensor usually solves the problem.

Jul 03, 2012 | Cars & Trucks

1 Answer

1995 taurus.. bleeds fuel pressure when car is off


Either the fuel pressure regulator is defective or the fuel pump is on its way out. Either way bring it to a repair shop fuel checks are dangerous and this type of repair is beyond a DIYer.

Mar 30, 2010 | 1995 Ford Taurus

2 Answers

1995 Ford Taurus Sho 3.2 check engine light blink 3 3 1 3 3


Code 33 is EGR opening not detected, this is caused by a plugged EGR exhaust passage in the upper intake manifold, this is a common SHO engine fault, the valve works but the engine does nothing that the computer can sense, since no gas flows, to verify this is the problem open the egr at idle, the engine should almost die, if nothing happens or only a tiny change in idle speed or quality the passages are plugged, if it does stall or get real rough the egr position sensor (usual code for sensor is 32) may be faulty or the valve is sticking. I was a ford dealer tech for 30 years and did quite a few of these, there is a TSB (technical service bulletin) about this problem

Oct 12, 2009 | 1995 Ford Taurus

2 Answers

Taurus SHO wont pass emissions: 95 Taurus SHO 3.2L Failed emissions badly- hydrocarbons in grams/mile=1.68 where .80 is pass carbon monoxide in grams/mile=44.80 where 12.00 pass. oxides of nitrogen in...


If the fuel regulator is seeping gas, replace it first. There is a good chance the diaphragm has a hole in it and is feeding fuel through the vacuum line directly to the intake, causing extremely rich fuel mixture. (Hence the strong exhaust and burning eyes) As a matter of fact, if you pull the vac line off and turn on the key, I bet fuel sprays out. Be careful not to start a fire on a hot engine. Once you get this repaired, erase the codes and retest. You could find yourself with only one code, maybe even none. I wish you luck. Emissions can make you pull your hair out.

Sep 16, 2009 | 1995 Ford Taurus

1 Answer

I have a 1995 Ford Taurus SHO 3.0 liters. I


Hi did you do a continuity check check if there's a wire shorted or open you'll need a volt meter check if the wires on the crank sensor going to the control module and also the one from the coil to the module there has to be a shorted or open wire check this and get back to me good luck

Sep 04, 2009 | 1995 Ford Taurus

1 Answer

Rattling sound inside engine on acceleration


possibly the bearings in the water pump,but that should have been replaced when the timing belt was done,because of the work involved

May 16, 2009 | 1995 Ford Taurus

1 Answer

Engine stalls out intermitently


First I would replace the fuel filter if it hasn't been changed recently, might check the fuel pump relay, might be going out. Lastly, it might just be the fuel pump going out. I just had to replace mine on a '96 SHO. Hope this helps

Nov 25, 2008 | 1996 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...