Question about Cars & Trucks

Open Question

Tickety/flapping noise Noise sounds like the flapping noise when you stick paper through spokes on a bike. Fairly Regular, every 10 seconds or so but not as much when revs are lower. lasts about 7 - 10 seconds each time but this can vary. Nothing cathing on wheels. Cant trace the noise.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 41 Answers

SOURCE: noise is like cards in the spokes of a bike tire

Depends on what year and engine you have. But if the noise is only occurring when the vehicle is in drive, or reverse, then I would consider asking a local transmission specialist take a look at it.

Posted on Nov 12, 2008

Ad
johnthejag
  • 286 Answers

SOURCE: front end noise

Hi Wild Bear

No 1....... Check your wheel nuts ! !!!!!!

If OK.....

Is the problem worse on full lock, one way ?

If so, it sounds like the drive shaft CV joint is shot.


If no....

Jack up the front, support car on axle stands.

Spin your front wheels, check the treads, and I should think, you will be able to tell the problem wheel.

Expect it might be in the brake caliper area, something loose and fouling the wheel or rim ?

Check for play too, in your front wheel bearings, by gripping the tyre, top and bottom and pulling, there should be no movement.

Give these things a try, and get back to me.

Good Luck !

A FixYa rating would be nice thank´s

John.

Posted on Feb 10, 2009

Molson02536
  • 3854 Answers

SOURCE: 02 silverado gas tank popping noise after startup & shutdown

It could just be the heat shield around your exhaust expanding and contracting again when your engine cools down. Sounds like a tin can type of popping noise?? If it is that's the heat sheild from the engine that protect's the spark plug wire and around under the truck cabin. Good luck and hope you find where the noise is coming from.

Posted on Apr 07, 2009

dcgun007
  • 63 Answers

SOURCE: When making a left hand turn a rubbing noise sounds

these are rwd no cv joints what kind of noise a pop. That will be a coil spring coming out of seat in a bind because of worn a frame bushings, Put a floor jack under lower control arm and clear the tire and shake and twist it around you should find the lose bushing or ball joint. Let me know ...gl..DC

Posted on Jun 22, 2009

  • 1374 Answers

SOURCE: VOLVO s90 1997 clicking noise from wheel area

If it happens only on turns then its the outer axle cv joint.. If it happens all the time probably something stuck in a tire. Either way have the suspension visually inspected by a technician as soon as possible.

Posted on May 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2010 Elantra, started with a high pitched sound turning left. Did that for a few days, then started when turning right. Now same noise is cooming for about 10 seconds. Not immediately on start up but


You may need to check the belts on your car's power steering section. Make sure the belts are tight and not worn out. Check for cracks on the belt and if loose, tighten it. There is also a product called Automotive belt dressing that you can spray on the belt to make it stick more easily to the pulley it is supposed to turn.

Mar 12, 2014 | 2010 Hyundai Elantra

1 Answer

Strange noise (sounds like when kids put cards in spokes of bikes to make sound). Sometimes loud; sometimes low. (Kind of THUDY sound. On left hand side (near the wheels). Usually every day I drive it;...


sounds like it may be bad wheel hub bearing. wen going down road with no traffic steer left then right left right and see if noise gets louder and softer wen weight shifts from side to side. if it does u may need to get new hub bearings

Feb 23, 2011 | 2000 Dodge Caravan

1 Answer

I just drove my kia rio to work, got out, went inside for 10 minutes, came back out, turned key to start car and all the bells and whistles come on like it normally does when I start my car but then it...


SOUND LIKE BAD STARTER SOLENOID.IF YOU HEAR LIKE CLICKING NOISE.CHECK BATTERY CABLE FOR TIGHTNESS AND CLEAN FREE FROM CORROSSION.CHECK BATTERY VOLTAGE SHOULD BE 12.5 VOLTS.IF NOT BATTERY HAS WEAK CELL IN IT.IF YOU HAVE TO REPLACE BATTERY.TURN OFF RADIO BEFORE DISCONNECTING NEGATIVE BATTERY CABLE SO YOU WONT LOCK OUT RADIO CODE.

Oct 14, 2010 | 2005 Kia Rio

1 Answer

High pitch winding noise on cold start up.


Sounds like a constricted IAC Idle air control valve passsage. Fairly simple to fix. Remove air filter trunking all the way to the throttle body to allow access. The IAC allows air passed the throttle when closed at idle. Just on the inside of the throttle body in front of the throttle flap there is an opening in the throttle wall. This is the air inlet to the IAC; there is an outlet similar on the other side of the throttle. Use carb cleaner and cloth to shift the grime from this tubing and get it like new. Hold the throttle flap open to get at both ends of the IAC tubing. The IAC can be detached and cleaned to a shine. Reinstall the IAC and replace all air pipe ducting. Leave for about 20 minutes to allow any cleaner residue to dry out. When you restart you might experience a bit of uneven running but this will disappear very quickly as the last of the cleaner dries out

May 04, 2010 | 2004 Chevrolet TrailBlazer

2 Answers

TC makes a ticking / flapping noise when driving.


Grab ahold of the "Chin" or lip spoiler under the radiator...chances are it broken..."Flapping" at speed...might also be an inner fenderwell thats loose.
Good Luck

Jun 14, 2009 | 2007 Scion tC Coupe

1 Answer

Clicking sond in right front end or engine/trans? on decleration


Sounds like your CV axle is worn out and making noise. Time to replace it.

Dec 01, 2008 | 1995 Toyota Camry

1 Answer

Noise is like cards in the spokes of a bike tire


Depends on what year and engine you have. But if the noise is only occurring when the vehicle is in drive, or reverse, then I would consider asking a local transmission specialist take a look at it.

Sep 18, 2008 | 2004 Dodge Grand Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...