Question about 1996 Geo Prizm

Open Question

How do you change bulb in third brake light on 96 geo prizm

3rd brake light is in rear window

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
bryant329
  • 125 Answers

SOURCE: 1996 geo prizm

you'll have to pull off the interior panel. window in the up position. on the lock cylinder there is a clip that you have to pull off and an arm that actuates the lock. pop the lock out. reverse to install.

Posted on Sep 22, 2008

Ad
  • 1 Answer

SOURCE: Geo Prizm brake lights

I had the same problem, what I did to fix it was as follows:

  • Removed the plastic light holders from the tail lamp.
  • On each of the three bulbs there is a ground wire that is attached to the plastic light holder via a screw. Remove these connections and clean, I used some very light sand paper.
  • Reassemble, Worked like a Charm for me, and I save a $90 charge from Firestone by doing it myself...

Posted on Apr 13, 2009

wiringlunati
  • 576 Answers

SOURCE: '96 geo prizm manual transmission-does the trans.

It isn't usually necessary on a manual transmission to change the fluid, however, if you do, you might notice a bit smoother shifting. It will probably have little if any impact on the life expectancy of the transmission. It won't hurt to do it, so if it makes you feel better go for it. It is important, however to make sure it stays full.

Posted on Nov 26, 2009

Molson02536
  • 3854 Answers

SOURCE: geo prizm stereo radio wiring diagram

1994 Geo Car Stereo Wiring Schematic
Car Radio Battery Constant 12v+ Wire: White
Car Radio Accessory Switched 12v+ Wire: White/Black
Car Radio Ground Wire: Black
Car Radio Illumination Wire: Red/Yellow
Car Stereo Dimmer Wire: Red/Green
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: N/A
Car Audio Front Speakers Location: N/A
Left Front Speaker Positive Wire (+): White
Left Front Speaker Negative Wire (-): Black/Blue
Right Front Speaker Positive Wire (+): Blue
Right Front Speaker Negative Wire (-): White/Red
Car Audio Rear Speakers Size: N/A
Car Audio Rear Speakers Location: N/A
Left Rear Speaker Positive Wire (+): Light Green
Left Rear Speaker Negative Wire (-): Light Green/Black
Right Rear Speaker Positive Wire (+): Gray
Right Rear Speaker Negative Wire (-): Gray/Black

Posted on Dec 23, 2009

matt2414
  • 247 Answers

SOURCE: 93 geo prizm....the airbag light

Don't touch this vehicle,the airbag has been deployed and a new whell attached without resetting the code.

Posted on Mar 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My additional brake light is not working i have tested the brake unit and that works is there a seperate fuse for this or is it all on one fuse for all the brake lights


The third or High Mounted Brake Light runs straight off the brake light switch on the brake pedal arm. You say you tested the "brake unit"? I assume you mean the third brake light assembly, and if you get power there when someone steps on the brake pedal, then the bulbs are bad.

The power flow for the brake lights goes like this: Fuse ->Brake switch -> Turn signal switch -> Rear lights. The only difference is, if you have a 3rd brake light in your rear window, that gets its power directly from the brake switch. It does not go thru the signal switch first. So, if you are having a brake light problem, and your fuses are good, check the 3rd light in the rear window, if it lights up (assuming the bulbs are good, no one ever changes them), then the problem is most likely in the turn signal switch, hope this helps!

Aug 28, 2011 | 2002 Ford SVT Focus

1 Answer

Breaks lights don't work


Here are some things to check:-

1 The brake light switch
2 The fuse for the brake lights
3 The bulbs for the brake lights
4 The bulb contacts in the brake lights
5 The earth connections in the rear light clusters
6 Generally check for loose or broken wires in the vucinity of the brake light switch and the rear light clusters.



Jan 26, 2011 | 1995 Geo Prizm

1 Answer

My brake lights won,t go on in my 1993 geo prism


I would check the brake light fuse and the brake light switch under the dash on the brake pedal lever. And, of course, check the bulbs themselves.

Oct 19, 2010 | 1993 Geo Prizm

1 Answer

What type of brake light bulb do I need for a 95 geo prizm?


Take the old bulb out, there will be a number on the bulb, you can take that number or whole bulb to any parts store to have it replaced. '
If there is no bulb, again a parts store can look up the vehicle and get the correct bulb replacement

May 25, 2010 | 1995 Geo Prizm

1 Answer

I'm having an unusual problem with a 1990 Geo Prizm. When I step on the brake the brake light comes on in the rear. When I turn on the lights the brake light goes out if I'm holding the brake pedal down....


Make sure you have the right bulbs in the right place...Sometimes they will fit, even though they are not right...Your brake light bulb should be a two filiment bulb...If it is one , then there goes your problem...Now if your bulbs are interchangable, go ahead an swap them around, and see what happens...Goodluck....

Dec 11, 2009 | 1990 Geo Prizm

1 Answer

How do you change the rear window brake light bulb on a 93 Honda


unscrew the case from around the light pull the case off and then youll have access to the bulb take the bulb out usually turns counter clockwise replace with new one reverse the process.

Nov 14, 2009 | 1993 Honda Accord

1 Answer

How do I replace the break light in the rear


You'll have to go into your trunk and there should be two screws holding the light fixture in place.. remove the screws and you'll be able to replace the bulbs

Aug 21, 2009 | 1993 Geo Prizm

1 Answer

1990 Geo Prizm 4 door sedan


Tail light or light bulb?

Jun 13, 2008 | 1990 Geo Prizm

Not finding what you are looking for?
1996 Geo Prizm Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Mike Gilbreath

Level 1 Expert

50 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...