Question about 1999 Ford Windstar

2 Answers

Coolant is pouring out between the engine and the transmission on my 1999 ford windstar but can't see were the leak originates. does any one know were the leak may be originating?

Have looked from every angle and can't see were the coolant comes from.

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Possible, there is a metal hose that runs ontop of the intake. This hose is located just above the water neck and goes across intake to hoses on passenger side. This hose is an obsolete item. Junkyard is best result. I just found this out cause that's were my leak was. After several headaches, and finally breaking down and asking advice, that's what it was.

Posted on Apr 09, 2013

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

COULD BE THE FREEZE PLUG

Posted on Dec 04, 2012

  • Michael Vere Dec 05, 2012

    I believe I can see all the freeze plugs and they are not leaking.

×

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1999 ford windstar sensor problems on 3.8 engine

iac valve is sticking remove valve and clean the shaft so it moves freely. This is a very easy fix.

Posted on Aug 29, 2008

  • 4 Answers

SOURCE: 1999 Ford Windstar 3.8 no heat

If you have a knock or clicking noise behind the radio, it is the blend motor. The blend door is spring loaded and the gears in the blend motor are "stripped". The door is spring loaded so that the door is closed to the heater core. About 2 hours to replace and a lot of bending and stretching. You don't have to remove the dash, but all of the trim, radio, and controls will need to come out.

Posted on Mar 01, 2009

  • 116 Answers

SOURCE: 1998 Ford Windstar Transmission to 2000 Ford Windstar

while it is possible to perform that swap, the newer 2000+ transmissions will have updated internals and such.

so will it work............. yes.

is it optimal.................no.

Posted on Apr 11, 2009

morse008
  • 1111 Answers

SOURCE: 1998 ford expedition 4.6 engine without tow package...overheating

improvise and buy a new hose and 2 clamps and wha-la

Posted on Sep 15, 2009

  • 14 Answers

SOURCE: My 2001 ford windstar's transmition is leaking.

This could be caused by multiple components failing. what i have seen most often on the windstar is the transmission pan gasket leaking, which is maybe a twenty dollar gasket between the pan and transmission, very simple to do, just requires removing between 10 and 20 bolts and replacing the gasket, then refilling the trans. i have also seen lines leaking going to the transmission cooler, which are more expensive and much more involved than the pan.

Posted on Oct 24, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Water leaking from top of engine


Is it water or engine coolant leaking? Check the coolant level and see if its low. If the coolant level is low...the coolant system will need to be pressure tested and leak pinpointed. If you sure its water...I would look at the black windshield cowl. This cowl channel's away water and could be leaking on the motor. There is windshield washer hoses in the cowl that could be leaking. Good Luck

Nov 27, 2012 | 1999 Ford Windstar

2 Answers

I have a 1998 ford windstar V6. and im having lots of white smoke pouring out tail pipe with lite water what can this be


It's possible that the white smoke you are seeing is from coolant entering the exhaust, however, I would think that the engine would also be running rough or be difficult to start should this be the case. I would start by checking the coolant level. If the level is very low then it's possible that you have a head gasket leaking which is allowing coolant to enter a cylinder and then be forced into the exhaust where it will turn into a thick white steamy/smoke that takes a while to dissipate after it exits the tailpipe. Whatever the source or cause of the smoke is, it's possible that it could cause some serious engine damage so you should have it checked out as soon as possible.

Feb 20, 2011 | 1998 Ford Windstar

2 Answers

New batrery, no spark, no fuel. pulled front bank of plugs not sign of fuel or hear from spark. Just replaced a top coolant hose that was leaking. Engine turns over strong.


try swapping your PCM power relay with another relay in the relay box (engine compartment by the battery).
The PCM relay powers the fuel and ignition systems, as well as the PCM. Let me know if this doesn't work or you have more questions.

jturcotte_325.gif

Nov 27, 2010 | 1999 Ford Windstar

1 Answer

Coolant leak from heater hose at engine when engine hot 1999 winstar 3.8


coolant pipe has 2 small holes , can jb weld repair it?

Nov 06, 2010 | 1999 Ford Windstar

1 Answer

My 1999 ford windstar is only blowing cold air and no heat


possable problems:

1. coolant leak (level too low to fill heater core)
2. headgasket leak forcing the coolant out of the overflow.
3. stuck thermostat.
4. bad water pump. if the impelers are broken, coolant wont flow.
5. HVAC malfunction. system may think you selected cold or is unable to move diverter. maybe a fuse,solenoid or vaccum leak? (hvac controler uses vaccume controled soleniods)
6. airlock. if you have resently changed your coolant, you may need to repeatedly squeeze the heater core hose to help force out the air.

May 19, 2010 | 1999 Ford Windstar

1 Answer

I have a 1999 ford windstar speedometer, odometer does not work, and I found a switch under the master cylinder that is leaking...want to know how to fix it?


do you have cruise control? if so, ford issued a recall on them. leaking master cylinder switch was causing fires even while parked and keys out. the missing speedo and odo is likely a fuse and/or the VSS at the back of the engine on top of the transmission. use a realtime DTC reader to confirm sensor output

Feb 13, 2010 | 1999 Ford Windstar

1 Answer

My Windstar was parked for a few weeks. When I


The backfire may have caused a coolant leak into the engine.
Check for a blown headgasket- look for combustion bubbles in the coolant resevoir (or ask for a coolant system combustion gas check at a radiator specialist).

Oct 11, 2009 | 1998 Ford Windstar

2 Answers

Coolant is black in 2000 ford winstar


Flush the coolant system and replace with new antifreeze.

Jun 02, 2009 | 2000 Ford Windstar

Not finding what you are looking for?
1999 Ford Windstar Logo

131 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...