Question about 2005 Jeep Wrangler

1 Answer

Rubber grommet for shifter cable on a 2005 jeep wrangler (in cab)

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

No it is on the left side on trans a cable coming from the shifte will be next the you trans above you trans pan . the grommet runs 8.00 at a dealer. takes 5 minuets to install your self. just replaced on 5 days ago.

Posted on Mar 16, 2013

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Mikey108
  • 475 Answers

SOURCE: 2005 Jeep Wrangler Emergency Brake Cable seems to be loose when

You have to look under the car and see if the cable is broken. If it is'nt then it has to be ajusted.

Posted on Nov 17, 2008

  • 1 Answer

SOURCE: 2005 Jeep Wrangler Unlimited cruise control will not engage.

check the vacuum line on the right side of the engine. There should be an elbow connector connecting the line to the engine. Does interior fan only come out of the defroster vents by chance?

Posted on Nov 10, 2009

  • 454 Answers

SOURCE: horn not working. Fuse is good. 2005 Jeep

May be bad horn. Get a 12 volt test light or multi-meter and attach to the horn wire at the horn. Have a helper press the horn. If you have 12 volts when it is pressed, horn itself is bad. Otherwise, may be bad horn relay. Horn cover should pull off.

Posted on Dec 31, 2009

witmoz
  • 389 Answers

SOURCE: can not find the correct

you can try the dealer they will have it in stock or will order it.i found 1 for my 89 6 cyl at advance auto parts in a small section where the vacume line connectors and window crank knobe are by the oil section.if u have the old 1 its easier to mach up, or u can use a piece of paper and trace the diameter of the whole and compare it to the new grommets center diameter.

Posted on Sep 02, 2010

rabbit7954
  • 417 Answers

SOURCE: jeep wrangler 2005 automatic floor gear shifter is loose won't engage stuck in park

try pushing the knob down onto the shifter a little bit then try and shift. Sometimes if that knob is raised even a little bit it will be locked in park. Can't be 100% sure without seein it but worth a shot. Hope that helps you.

Posted on Oct 02, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Shift my jeep in 4wd now the shifter is loose and it is staying in 4wd


Sounds like the rod from the 4WD shifter has come loose form the transfer case or from the shifter lever. Some use a cable. Look under the vehicle. A rod or cable will go from the shifter to the transfer case. If it is a cable and the ends appear attached the cable is broken inside the housing. Reattach ends of rod or replace cable .

Feb 26, 2015 | 2010 Jeep Wrangler

1 Answer

My jeep wrangler 2008 - I shifted to reverse then to parking, when i release the breaks it kept going in reverse. So i turn off the engine. now it wont start the engine, neither the shifter will move


The shifter cable has broken more than likely ,Find the shift shaft on the transmission,,block the wheels and remove the shift cable from the shift shaft,put the gear shift in park,then shift the shift shaft in park,then it will start,Then of course you will have to replace the shift cable.

Oct 05, 2013 | 2008 Jeep Wrangler

1 Answer

How do you replace the shifter cable on a Titan


cables through firewalls are normally surrounded by a stiff rubber grommet that is either just pressed in place or retained by a metal surround push out/in and pull cable through. make sure you replace it to around the same position before refitting the cable

Jan 19, 2013 | 2005 Nissan Titan Crew

1 Answer

Jeep wrangler 2005 automatic floor gear shifter is loose won't engage stuck in park


try pushing the knob down onto the shifter a little bit then try and shift. Sometimes if that knob is raised even a little bit it will be locked in park. Can't be 100% sure without seein it but worth a shot. Hope that helps you.

Oct 02, 2012 | Jeep Wrangler Cars & Trucks

1 Answer

How do i get the shifter knob off of 2005 wrangler x?


if you drive by the local dealer and buy the mechanic a caoofey he will likelly take the knob off for you for free

Nov 14, 2011 | 2005 Jeep Wrangler

1 Answer

Hi my 2005 Jeep wrangler 1st gear pops out what is the reason ?


the lock ring for the shifter fork inside the transmission gearbox may be worn out. jeep transmission dont last long especially if a lift kit or bigger tires are installed.

Apr 01, 2011 | 2005 Jeep Wrangler

2 Answers

Jeep is stuck in park, will not drive


ckek shifter cable brokin or disconected

Nov 04, 2009 | 2003 Jeep Wrangler

1 Answer

Manual trans stuck in gear


I had the same problem. Started for me as not going into reverse. Here is what you do. Have someone work the shifter while you open the hood and look straight down into the engine bay. You will see a cable that attaches to the top of the transmission. Where it attaches to the transmission the cable is supposed to have a plastic grommet. In time this grommet cracks and falls apart. Therefore the cable no longer engages/disengages the gearbox. You must fashion a new grommet out of a piece of rubber or similar material, make a hole in the middle of it to fit over the shaft of the transmission lever, jam it into the opening at the end of the shifter cable, then use a small cotter key to secure the whole thing into place. Test the shifter, make sure the cotter key will hold, change the size if it will not stay on. Should work, I made this fix about 20,000 miles ago and its not come off since.

Apr 17, 2009 | 2001 Chrysler PT Cruiser

2 Answers

2005 Jeep Wrangler Emergency Brake Cable seems to be loose when pulled up, but seems to grab & hold when released?


You have to look under the car and see if the cable is broken. If it is'nt then it has to be ajusted.

Nov 17, 2008 | 1989 Jeep Wrangler

Not finding what you are looking for?
2005 Jeep Wrangler Logo

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...