Question about 2000 Ford F350 Super Duty Super Cab

1 Answer

Cranks but dont start

Check fuses.check gas pump.ok crank but dont start.what alse could it be?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Ford Master
  • 5,370 Answers

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.



From start to end troubleshooting these problems I suggest you to check the help link below and follow its procedure: -----


http://alltypesofpartsreplacing.blogspot.com/2012/11/car-no-start-engine-not-turning-over.html

------------

These will help.

Thanks.

Posted on Dec 04, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 393 Answers

SOURCE: 1999 F 250 crank but wont start

look on injector pump make sure there are no loose wires

Posted on Dec 09, 2008

SOURCE: 1991 ford explorer fuel pump assembly, fuel pump

Change fuel pump

Posted on Oct 25, 2008

  • 1 Answer

SOURCE: 92 ford explorer (crank but no start and no noise from fuel pump)

How do you check the electrical wiring to the pump and if it is that is it something I can do? I have checked the fuel relay fuse and the safety cut-off switch and replaced the fuel pump and filter

Posted on Dec 07, 2008

MNfisherman
  • 11896 Answers

SOURCE: my 2000 ford focus cranks, but does not start. I

You will want to find out if you are not getting spark or not getting fuel.
If no fuel, then bad fuel pump, plugged fuel filter, or bad fuel pressure regulator, or bad fuel pump relay.

If no spark, then bad crank sensor, or ignition module, or coil packs.

Posted on Oct 14, 2009

  • 1 Answer

SOURCE: e 450 motorhome cranks but no start

E 450 bus, shutdown, failes to restart. cranks over, can the fuel shutoff be the problem? if so where is it located?

Posted on Apr 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have no power to my fuel pump in my 2006 jeep liberty, I've put a new pump in, checked all the fuses and relays, and put a new crank sensor In. I still don't have power to the pump


ouch, you dont have a $10 volt meter, ? if you dont have 12vdc to the pump cranking why replace a pump, it has no power. so.....?
which engine, we need that because its and EFI question and varies by engine. Gas or Diesel?
first off here is the dead pump checks on all EFI cars,
1: fuses are first (as is a charged battery to 12.6vdc rested)_
2: next is to scan it, scan it cranking, dont skip scans. ever. and 100x that in newer cars. it reports many failures, now. details......
3: the crank engine (yes, crank it ) and see if 12vdc makes it to the pump. does it? id bet not. (as you said no power but did you crank it?)

4: if the pump feed wire is dead now what. well check the pump drive. on old cars its a relay on newer its ELECTRONIC driven.
that means powerful transistor drive from the TIPM.
5: first is if the SKIM is glowing cranking is it? immoblizer active cuts fuel. (not sure if it cuts pump but is important this)
6: dead ASD relay, it dont close. cranking.
7: or the ASD relay drops out cranking, scan tool tells why.

me ?, I scan first, ohm the scan tells me x fuse is blown,.
wow.
or that the ASD dropped for x reasons 8 total.

does the PCD Fuel pump relay close cranking?
does the coil on said relay (meter across coil of it) go to 12vdc cranking 11v is typ.?
if not the ECU is blocking the pump relay,
that takes a scan tool to find why.
use an Innova 3160 scan tool , buy one and save a fortune guessing.
barrow, rent or buy,
cant go to shop engine is dead, right? so leaving 2 choices.
tow it or buy scan tool for less. cash.

fuse 24 looks ok but is cracked (hair line) and reads infinity on the ohm meter RX1 scale.? BINGO, we test fuse that look ok.
or check voltage on both sides of fuse cranking, 12vdc is good.
0v is bad.

The PCM has many reasons to cut the relay,
not one can be guessed at (well dead spark, sure)
it needs to be scanned.

Apr 08, 2015 | Jeep Cars & Trucks

2 Answers

Will crank but will not start


great post. and symptoms,
no engine option stated so generic answered. and guess gas engine.
so if it dont start, you check spark next.
at each cylinder if #1 is dead. #1 is most easy.
if spark is good, it runs on test fuel (not blown engine)
does it? run for 3 seconds, on test fuel (you spray it?)

the list , easy
  1. check fuses.
  2. crank engine with scan tool attached (any) get DTC errors ?cranking for 5 seconds, sure you do? P03xx errors. bingo!
  3. the ASD fails to close , cranked, ? (fuses mostly)
  4. The ASD relay drops off , while mid cranking? if yes Scan tool told you why in every case. use a scan tool. or guess forever.
  5. ok test fuel works, and no DTCs and ASD hold, seams you lost the fuel pump pressure, check pressure.
http://www.fixkick.com/Jeeps/ASD.html

Mar 15, 2015 | 2005 Jeep Liberty

3 Answers

On my 1999 plymouth breeze 2.0 sohc. it cranks but wont start. Relays , fuses are good. But i dont hear the fuel pump


First key on you should hear pump run a couple seconds if you think it's the pump have someone crank it over and another pound on the fuel tank this sometimes makes the pump motor start to run, if it does that may be enough for you to drive to a shop for a new fuel pump.

Apr 22, 2014 | 1999 Plymouth Breeze

1 Answer

Equinox cranks but will not start


start by checking all fuses, then if all ok make sure fuel pump is kicking on have a friend listen by the gas tank while you turn the key on they should hear a buzzing or a whining noise come from the tank if not then check fuel pump fuse first if ok then get the pump tested by a shop to make sure it failed. Also you can try giving a light tap to the tank to see if it kicks on but be safe about it.. Good luck. One last thing if you find blown fuses find out what they are for I had a pcm fuse blow and my car cranks but would not start..

Nov 10, 2013 | Chevrolet Equinox Cars & Trucks

1 Answer

Started truck yesterday and then the engine stopped. It will crank but does not seem to be getting fuel. Numerous attempts to start but just cranks and cranks.


remove gas cap and listen inside tank while another person turns key on if you here a buzzing sound coming from tank the pump will most likely be OK. You can also check for blown fuses or fuel relay fuse

Jun 06, 2011 | Chevrolet Silverado 2500HD Cars & Trucks

1 Answer

Starter wont crank with ignition key


Well, if you have a problem with the security system not allowing you to crank, then you have a problem that can be fixed only by the dealer.

Check your key and verify that it doesn't have a dirty or wet resistor on the security ignition key. This is a common problem with this type of security system.

Good luck on fixing this problem.

Jul 08, 2010 | 1994 Cadillac Eldorado

1 Answer

My 1985 S-10 crank no start will run with gas in throtlle body


Three steps to remember a car need air fuel and spark to run ... check your ignition coil and distributor for spark ..... if everything ok check the fuel pump and make sure it works ..... a slight hit to the tank or pump itself could help it start ....dont beat it though.... Hope this helped

Oct 30, 2009 | 1985 Chevrolet S-10

2 Answers

Jeep wont start.


while someone is cranking over the engine listen under the rear of the truck at the gas tank for the fuel pump. is it buzzing ? if not try again while cranking with a Rubber Hammer tapping on the center of the gas tank, if it starts you will need a fuel pump.
good luck chris

Mar 15, 2009 | 1999 Jeep Grand Cherokee

Not finding what you are looking for?
2000 Ford F350 Super Duty Super Cab Logo

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...