Question about 1994 Chevrolet S-10 Blazer

1 Answer

Truck shakes at idle on a 1999 yukon - 1994 Chevrolet S-10 Blazer

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 70 Answers

Check to see if you need new plug wires. One way is to open the hood at night and look for any arcing
I had this happen to my Bonneville. Changed the plugs and wires and it stopped.
Good luck

Posted on Dec 04, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Truck runs rouff at idle on a 1999 yukon sle


I found that a lot of times it is a bad plug wire, or one that is arcing off the block or body. Do you get check engine light?

Dec 04, 2012 | 1999 GMC Yukon

1 Answer

Where is they idle air controle on a 1999 yukon


located on your throttle body, right where your throttle cable attaches

Nov 19, 2012 | 1999 GMC Yukon

1 Answer

My 2005 Yukon Denali shakes and jumps a little when idled. I just purchased this Yukon from a GMC dealership 3 weeks ago and it passed both VA and MD inspection. It has 107,000 miles on it. Do you think I...


Yes i would think so.These new vehicles are suppose to go 100,000 miles before it gets a tune-up and yours is there.I would like the sparkplugs are culprit.

Aug 09, 2011 | GMC Denali Cars & Trucks

2 Answers

While driving dwn the road i hve a bad shake in my steering wheel i have a 1999 gmc yukon


it sounds like the front tires need balancing.if you drive the truck slowly(creeping down the road at about 5mph)and lightly holding the steering wheel do you feel the steering wheel moving back and forth.this could indicate a bad belt in a tire where as a wheel imbalance won`t show up at this low of a speed,but a bad belt will.also have the front end checked for worn front end components and wheel bearings,this can cause a bad shake too.

Apr 20, 2011 | 1999 GMC Yukon

1 Answer

Spark plug wires are arcing on 1999 Yukon Denali, runs rough, wants to stall while idling


If the wires are arcing that means that they need to be changed they have worn out and they can no longer keep the high voltage inside the wire just replace them about $100 and all your problems will be solved

Dec 15, 2010 | 1999 GMC Yukon Denali

1 Answer

We've replaced the MAP sensor and coil pack in my daughters 1999 pontiac sunfire. It's a 2.4L, DOHC but the engine is shaking when it idles. We think it may have a broken motor mount, but when the engine...


do a compression test of the cylinders, could be a burnt valve, from what you describe engine is missfiring on idle and running on all cylinders at higher revs

Apr 24, 2010 | 1999 Pontiac Sunfire

1 Answer

1999 nissan frontier is idling rough the truck shakes but shaking stops when the air is turned on. changed oil, spark plugs, spark plug wires and distributor cap.


This can be your Idle control valve, when you turn the air on it puts the engine under load and your computer will increase the idle automatically to prevent the engine from cutting out.
When you are standing still and the car is shaking, by touching the accelerator very softly does the shaking stop? If so check the idle control valve.
I hope this will help.
Regards
Sam

May 13, 2009 | 1999 Nissan Frontier

1 Answer

1999 escort 5 sp manual trans. had vibration


IF GEAR SHIFT SHAKES THEN THE TRANSMISSION MOUNTS COULD BE BAD. HOPE THIS HELPS. GOOD LUCK

May 01, 2009 | 1993 Dodge Shadow

2 Answers

Shakes


If you havent done so already try replacing your oxygen sensors. There are 4 of them, the two in the front are the first that i would replace.

Dec 02, 2008 | 1999 GMC Sierra

Not finding what you are looking for?
1994 Chevrolet S-10 Blazer Logo

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...