Question about Dodge Ram 1500

Open Question

2006 dodge ram 1500 door lock actuator

Door lock actuator makes noise

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 5 Answers

SOURCE: 2006 Dodge Ram 1500 4.7 misfire

Dodge recommends new plugs at 60k. If that engine, I don't remember off hand, has a coil pack over overy plug, try switching the coil to a different plug and see if the missfire moves. If it does then you need a coil, if it doesnt then its the plug.

Posted on Apr 24, 2009

Ad
  • 66 Answers

SOURCE: 2004 Dodge Ram 1500 Quad Cab Drivers side power door lock broken

Sounds like the link rod to the latch are jammed in the locked position by something inside the door or it came off. Any way, you have to remove the door panel to get access to it.

Posted on Jun 03, 2009

  • 1 Answer

SOURCE: blower motor makes loud noise when on high

I have a 2004 dodge ram 1500 with the same problem, vibrating blow fan when on high, pulled the blower fan out and found a piece of the hinge from the recirculation door and felt the recirculation door sitting up on the vent of its hinge. Crappy engineering once again.

Posted on Jun 07, 2009

roniecon
  • 6918 Answers

SOURCE: 2006 dodge ram diesel a/c clutch makes loud grinding niose

replace the compressor

Posted on Jun 29, 2009

  • 850 Answers

SOURCE: 2002 Dodge Ram 1500 power door locks keep blowing fuse

by process of elimination!
one door at a time so disconnect 3 & keep changing the active one till you find which one isnt working
then test its circuits ok
Cheers rob.

Posted on Jul 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 dodge ram heater mode door repair


Check to see if actuator is moving,where the actuator plugs in the door the plastic may have broken on the door then the heater box would need to come out to repair but if the actuator isn't working then easily replaced then all doors recalibrated provided it's getting the command from HVAC module..

Jan 28, 2015 | 2006 Dodge Ram 1500

1 Answer

All my doors lock except for one. If you open the unlocked the truck alarm goes off


check for power at the door lock actuator..if it has power when activated replace it it is normal for the alarm to go off as the actuator and alarm switch are seperate circuits

Dec 08, 2014 | 2009 Dodge Ram Pickup 1500

1 Answer

2006 Ford Escape drivers side door locks but won't unlock


Andy, does the actuator make any noise when you press the lock switch? If it does not make any noise than you have a faulty control switch.

Dec 03, 2014 | 2006 Ford Escape XLT

1 Answer

Power door lock quit working on rear door


The most likely cause is a defective lock actuator.You'll have to pull the door panel to get at it.Unplug the connector,and rig a 12v test light across the two connector pins.Pressing the lock or unlock button should make the light come on(lock or unlock just reverses the polarity).If you get a light,then the actuator is the problem.If not,then trace back towards the lock relay to find the open in the circuit.

Mar 30, 2012 | 2005 Dodge Ram 1500

1 Answer

I think I have a blend door problem just not sure how to fix it. I get heat from my mid and lower vents on the drivers side but it blows cool on passenger side and defrost both sides. Magically the next...


this unit is eclectric, it uses actuator motors to control the blend doors and selector doors, you are correct its a blend door problem, if you look under the dash on the passengerside there will be a motor mid way, thats the blend door actuator and theres another on the driverside. you what pass/side. move your controls to pin point the right one,hope this helps.

Sep 21, 2010 | 2006 Dodge Ram 1500

1 Answer

Power door lock not working


replace the acuator but check the wiring first may have a broken wire in bend where the door closes

Jul 16, 2010 | 2007 Dodge Ram Truck

2 Answers

2003 DODGE RAM 1500 HEAT BLOWS DEFROST OR DASK


there is a directional door actuator motor,that has gone bad.

Nov 19, 2009 | 2001 Dodge Ram 1500 Truck 2WD

2 Answers

Blower motor makes loud noise when on high


I have a 2004 dodge ram 1500 with the same problem, vibrating blow fan when on high, pulled the blower fan out and found a piece of the hinge from the recirculation door and felt the recirculation door sitting up on the vent of its hinge. Crappy engineering once again.

Feb 14, 2009 | 2004 Dodge Ram 2500

1 Answer

2003 Ram 1500 door locks


Not a lot that can be done about this. Its the Actuator inside the Doors. It gets cold and operates Very slowly. Not particular to any one Make or Model.

Jan 03, 2009 | 2004 Dodge Ram 1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...