Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The same thing happened to my 95 Celica, the first mechanic or suspension shop replaced the front wheel bearings and about a month later the noise was back. I took it to another shop and they said that the bearing were bad because the base of the spindle assemble,where the bearing sits, was wallowed out. They replaced it and the bearings and all is good. I would have them check the spindle assembly.
Posted on Jun 20, 2008
Raise and support vehicle. Remove wheel. Remove caliper assembly. DO NOT allow caliper to hang from brake hose. Always support caliper by wiring it to frame. Remove rotor.
Loosen and remove ABS speed sensor mounting screw. Carefully remove sensor head from steering knuckle. If sensor head is seized due to corrosion, use hammer and brass punch to tap sensor. Tap edge of sensor ear, rocking sensor from side to side until it is free. DO NOT use pliers on sensor head.
Remove axle shaft nut. Remove 3 bolts securing hub assembly to steering knuckle. Pull hub straight back from knuckle. If hub is corroded, pry between hub flange and knuckle
Fully remove knuckle pinch bolt. Insert pry bar between lower control arm and steering knuckle. Push down on pry bar to separate ball joint stud from steering knuckle. Ensure ball joint dust boot is not damaged during removal. Loosen and remove strut-to-knuckle nuts. Bolts are serrated where installed into knuckle. DO NOT turn bolts in steering knuckle. Use soft-face hammer to drive bolts out of knuckle. Remove knuckle from vehicle.
Installation: To install, reverse removal procedure. Tighten all nuts and bolts to specification. DO NOT fully tighten axle nut until vehicle is on ground. Ensure hub mounting surfaces are clean and free of foreign material. Coat speed sensor with high temperature grease before installing onto knuckle.
Posted on Oct 20, 2009
Testimonial: "thank you very helpfull"
Tips for a great answer:
Mar 27, 2016 | Dodge Cars & Trucks
Mar 05, 2014 | 2005 Dodge Neon
May 05, 2011 | 1998 Dodge Neon
Nov 17, 2010 | 2004 Dodge Neon
Jun 11, 2010 | 2001 Dodge Dakota
Dec 13, 2009 | 2004 Dodge Neon
Feb 28, 2009 | 2000 Dodge Neon
Dec 21, 2008 | 2002 Dodge Neon
43 people viewed this question
Usually answered in minutes!