Question about 1999 Lincoln Town Car
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
there are several kinds on these cars. first, unhook negitive battery cable. if it has screws, simply unscrew them and pull out panel. unplug switch and replace. another kind is snapped in place. take small flat head screwdriver and carefully pry it up and out. if you are to afraid to do this, fearing it might break, have a pro do it. good luck.
Posted on Dec 07, 2008
SOURCE: brake lighs stop working
Does the 3rd brake lamp illuminate? If so then your problem is multifunction switch.If it doesn't do the following checks.
Check for power to and thru the brake lamp switch itself.If you do not have power to the switch check fuse no. 10(20 amp) in the interior fuse panel.If you have power to the switch then depress brake pedal and make sure you have power thru the switch.If this is ok the check Fuse 22(20amp) with brake applied..
Posted on Mar 01, 2009
Open the hood and make sure the car and the lights are off.
Remove the plastic protective cover.There are 3 knobs,turn halfway and pull.Put aside and out of the way.
Remove the three pins that are holding the light assembly in place.These are flat rods with a little bend at the end.
Twist and un-plug the lights,now you can remove the whole lens.
The light bulbs can also be removed and replaced from this point.
Make sure all the bulbs are working before you put it back together.
Posted on Mar 13, 2009
you need to pull the cover off the rear diff. remove the rear brake drums or rotors, remove the bolt that holds the pin in the rear end, remove the pin, remoce the c clips, pull the axles out. remove the seal. you can do this by using one ofthe axles to pry the seal out. install the new seal and reassemble. use rtv sealant to reseal rear diff and fill with about 3 - 3 1/2 qts gear lube-may take synthetic
Posted on May 25, 2009
Tips for a great answer:
Oct 20, 2016 | Lincoln Town Car Cars & Trucks
Feb 26, 2013 | 1998 Lincoln Town Car
May 02, 2010 | 1998 Lincoln Town Car
Dec 25, 2009 | 1999 Lincoln Town Car
Dec 10, 2009 | 1999 Lincoln Town Car
Oct 06, 2009 | 1997 Lincoln Town Car
Jun 07, 2009 | 1989 Lincoln Town Car
Mar 20, 2009 | 1998 Lincoln Town Car
81 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: