Question about Cars & Trucks

1 Answer

Low tire pressure

My back tire is low and i can't back up - feels like it's grabbing - not free moving

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Expert
  • 55 Answers

Air tank put air in it,than fix the leak

Posted on Dec 04, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: Low Tire Pressure Indicator

I took my car to the dealer and they solved it for me, I am not sure what exactly they did, but I know it involved me changing some tires.

Posted on Dec 16, 2008

Molson02536
  • 3854 Answers

SOURCE: what does low trac mean?

Sound's like you have a bad tire. There are steel belt's in the tire that help keep there shap, but when one belt's break you have flat spot that make's it seam like your driving over pot holes. Before you go off changing the tire have it balanced first to see if that is the real problem. Good luck.

Posted on Apr 06, 2009

dsacco86
  • 1077 Answers

SOURCE: low tire pressure light won't stay off after proper reset.

Some newer Toyota vehicles have a sensor in the spare tire. Tires loose air over time naturally. I would check out the spare.
When did this TPS light start coming on?
Have you had new tires put on, or had a flat repair done before the light?

Posted on Apr 28, 2009

  • 1 Answer

SOURCE: How do you reset a low tire pressure warning on a 2008 Jetta?

Reset the tire pressure warning, same as you would any service issue. Insert key in ignition, hold wrench button and min button, then start engine.

Posted on Jun 08, 2009

  • 49 Answers

SOURCE: low tire pressure indicator is on. I have put the

if u have the right tire pressure in the tires the light will go out . but sometimes you have to put 5 to 10 miles on the car to reset

Posted on Nov 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

4 Answers

2000 Chevy venture wobbles and makes noise on passenger side with increased speed it starts shimmering real bad,just replaced the CV axle


Lift that tire off the ground. Grab it on the top and bottom. If it moves, have some on watch the lower ball joint. If the ball joint moves, replace it. If it doesn't replace the wheel bearing. If the tire doesn't move top and bottom. Grab the sides and move back and forth. If you feel slop in it, replace the outer tierod. Do this soon, because a lot of vibration could be close to failing/wreck.

Feb 06, 2015 | 2000 Chevrolet Venture

1 Answer

Feels loose while driveing


Air pressure good in tires? Idler and pitman arms would get loose. Jack up front wheels and grab them on each side and wiggle them from side to side. Watch for movement in the steering linkage. Then grab wheel on top and bottom. Wiggle it again. If it moves then, you need a wheel bearing Hub assembly or ball joint.

Apr 09, 2013 | 1999 Chevrolet Suburban

1 Answer

Ive got this bad grinding problem comming from my front driver side, it kinda sounds like my breaks are metal 2 metal but they ain't I wanna know what the grinding is we can't seem 2 find them...


If not the brakes, it could be a ruined wheel bearing. To check, raise the wheel just off the ground with your jack, parking brake on. Grab the tire, try to move it back and forth, just feel for play right at the wheel. The tire should have no play in it, except for a very small amount, only a fraction of an inch. If you feel significant movement shaking it, or moving it, its probably a bearing. You'd better replace it before it gets worse. It is bad on the tire, too-it will wear uneven. After the work is done, you will need an alignment for your car.

Dec 23, 2012 | Cars & Trucks

1 Answer

Clutch pedal staying down but there's plenty of fluid in resiviour


Probably bad clutch master cylinder and/or slave cylinder. I always replace both.

Oct 04, 2012 | Cars & Trucks

2 Answers

Steering wheel movement


Could be your tie rods coming out of the rack and pinion and attached to the wheels. Grasp the tie rod near where it attaches to the wheel and see if you can shake, twist or move it. If you feel any play or looseness at all in the tie rod joint, then it is worn badly. Both outer tie rods at each wheel should be replaced. If the outer tie rods are tight, you can't move them with your hands, then have a shop check your inner tie rods for wear. Have them check the ball joints for wear, also. Or you can raise the wheel off the ground. Be safety conscious. Grab the tire at top and bottom. Can the tire move in and out, feel play in the lower ball joints? Any side to side play in the wheel? Maybe you can spot the looseness at the tie rod or balljoint. Maybe you'd better let a shop look at it.
A CV joint wouldn't have those symptoms. A wheel bearing possibly, but usually accompanied by a grinding noise. Have it checked out.

Jun 20, 2012 | 1999 Ford Windstar

1 Answer

Stering goes it oposit of my turn


You need to raise the front tires of the ground and check for loose front end parts. Grab the tires at the 3 and 6 o'clock position and push/pull. If you feel any play you have worn outer tie rods, inner tie rodes, ball joints or wheel bearings ( if there really bad). If you don't feel anything loose check your tire pressure. The tires should be inflated to around 30-35 psi.

Jan 15, 2012 | 2007 Chevrolet Equinox LS New Cars

1 Answer

At what tire pressure is the tire pressure warning indicator activated


The LOW TIRE PRESSURE warning light will come on when the pressure is 25% below the manufacturer's recommended pressure. If I recall correctly, the 2007 Sonata has a manufacturer's recommended tire pressure of 30 psi. There is a tire label (sticker) on the inside driver's door jamb ('B' Pillar which tells you what the manufacturer's recommend tire inflation pressure should be. Once you have that value, you can calculate 25% of that & find the pressure at which the warning light should come on. NOTE: The TPMS (Tire Pressure Monitoring System) does not continually nor constantly scan the sensors in the wheels for this information - once every 3 to 10 minutes.

Aug 27, 2011 | 2007 Hyundai Sonata Limited Sedan

2 Answers

My windstar has a light that has come on in the dash panel that has an exclamtion point enclosed in what looks like a bowl. and when I stop at traffic lights the car feels as if it is still moving a little...


If the picture below is the light you are talking about. The reason it is on is right there for you. Why your vehicle would feel like it's still moving doesn't seem to have anything to do with a low tire unless it's so low that it is like jelly and then the vehicle would feel like it's moving. You may have 2 seperate things going on. There is one light right in the middle of the speedo which has an exclamation mark as well but that has a circle all the way around it and the word brake should be right above it. This all should be in your owners manual if you have one. If you don't have an owners manual and would like a copy, you can email me at csautomotivecars@att.net with your make, model and year and I will be happy to email you a copy. I hope this helps and good luck.


clifford224_448.gif

May 11, 2011 | 2001 Ford Windstar

1 Answer

I have a 1997 Jeep Wrangler with uneven front tire wear. I have had them about 2-years. Moving front to back along the interior lugs of Goodyear Wrangler MTS tires there are lugs that are more worn than...


You didn't mention if you ever rotated the tires. I suggest you get them re-balanced and put the fronts on the rear. I recommend putting them front to back without crossing them. There's been an argument about that for many years and I still believe that crossing will cause belts to shift inside the tire and that can cause it to fail if you reverse the rolling rotation, especially if no rotation has been done for a long time. (rotate about once a year) It may also be a good idea to replace your front shock absorbers. Unless you live somewhere it gets very hot, I'd also run your tire pressure at 35psi. If you normally run it lower, it may feel a bit hard at first but it's easy to get used to and the tires will last longer.

Mar 05, 2011 | 1997 Jeep Wrangler

3 Answers

SYMPTOMS OF BALL JOINT WEAR


If you make a hard right or left hand turn (with steering wheel turned until it stops) you'll hear and feel a pop sensation.When you drive over potholes you'll feel a slight pull to one side.If it is one of the upper balljoints,you can grab the tire with both hands near the top(11 and 1 o'clock) and pull the wheel back and forth.You will feel looseness if the upper balljoint is bad.

Nov 01, 2009 | 2002 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...