Question about Cars & Trucks

1 Answer

We replaced fuel pump. Now car is gettin gas to the injectors but no farther. Wthe car still won't start. What could be the problem now?

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 54 Answers

Could be an airlock in the fuel system? Is the timing on the IP right?

Posted on Dec 04, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 225 Answers

SOURCE: won,t start

sounds like it may be and ignition relay falling out. i think there is 3 of them under the hood. have to ask is there fuel pressure, spark. i know you changed them but why.

Posted on Aug 13, 2009

tayjoejoe
  • 2182 Answers

SOURCE: silverado 02 won't start.

Is there a light on the dash that says SECURITY? These anti theft systems have been known to disable fuel.

http://vatspasslockpasskeysecurityhelp.yolasite.com/

Posted on May 15, 2011

  • 2 Answers

SOURCE: I have a 1990 vw cabriolet that won't start.

When u turn the ignition on the fuel pump should make a hum sound until the fuel system is primed then it will stop until the engine is turning over to run.If u ran it out of gas the pump mybe burn't up The liquid (gas) in the tank keeps the pump cool.

Posted on May 27, 2011

  • 2926 Answers

SOURCE: Car won't start. No fuel to injectors. No

It is most likey a defective crankshaft position sensor. Was the PCM checked for trouble codes?

Posted on Jun 08, 2011

  • 5370 Answers

SOURCE: Car will turn over but won't start. Through the

No noise from fuel pump when you turn over the car .First thing get voltage at fuel pump relay checked, is there 12 volt to the relay.If no, then problem is again the relay.--------- To reconfirm the problem, try other test, that is remove the relay and by pass the relay terminals with a jumper wire .Then with 12 volt external battery give power to fuel pump connector and see, if the fuel pump starts, then its clear that fuel pump relay is faulty.----------- Also other problem can be fuel pump inertia switch.If the inertia switch is faulty then also fuel pump will not start.-------- The fuel pump relay on a 1995 Ford Explorer is in the power distribution
box, in the engine compartment, driver's side near the firewall.----------
The fuel pump inertia switch is in the right front passenger area
it is below the dash but above the carpet in the right hand corner.--------
Its a push button type inertia switch.
--------
Fuel Pump Activation
When ignition switch is turned to START position, PCM operates fuel pump relay to provide fuel for starting engine. PCM senses engine speed and shuts off fuel pump by opening ground circuit to fuel pump relay when engine stops or engine speed drops to less than 120 RPM. When ignition switch is in ON position, EEC power relay is energized (contacts closed). Power is provided to fuel pump relay and timer in PCM. Fuel pump receives power through fuel pump relay contacts.
Inertia Fuel Shutoff (IFS) Switch
All models use an electrical interrupt switch in fuel system. During a collision or vehicle rollover, electrical contacts within inertia switch open, shutting off fuel supply to electric fuel pump. Fuel supply is interrupted even when engine is running.
A reset button is located on switch assembly. If electrical circuit trips, vehicle will not restart until switch is reset. Fuel system should be inspected before resetting switch.
IFS switch is located under instrument panel, near right side of transmission hump.
----------- If the fuel pump relay, the inertia switch and fuel pump all checked ok, and fuel pump is working with direct 12 volt source to fuel pump.Then problem relates to computer.The computer (power control module, PCM) is faulty and has to be replaced.--------- This will help.Thanks.Helpmech.

Posted on Jul 17, 2011

Testimonial: "Thanks. That was the best answer yet.I didn't want to hear that the PCM might need to be replaced but the car has served it's purpose through the year"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1992 4.3 v6 tbi s10 starting problem. Won't squirt


Are the injectors getting power and a ground signal from the computer ?

Sep 06, 2013 | Cars & Trucks

1 Answer

I changed the fuel pump but the van still won't


And you know the fuel filter is good? Could be injector problem: just as a check, spray some starting fluid into the intake and see if engine runs a few seconds. If it does, it is a fuel problem. Check injector fuse, as a start. Check fuel pressure. Check injector circuit. If engine won't start with starting fluid, check if you are getting spark. Problem may be in the ignition system.

Aug 13, 2013 | Cars & Trucks

1 Answer

Changed fuel pump and still won't start


Have you checked the fuel pressure at the injector ? It has to be at least 60psi for the engine to start.

Dec 08, 2012 | 1999 GMC Jimmy

2 Answers

Car won;t start after fillig up the gas task


It might be your fuel pump, if you turn your key to the setting right before your car turns on and you hear nothing, it maybe your fuel pump, if you do hear a buzz then try replacing your fuel filter before it strains your fuel pump

Jun 21, 2012 | Hyundai Santa Fe Cars & Trucks

2 Answers

My s10 truck is gettin fire, gas and air.. will turn over but will not crank.. what could be the problem?


Just because it get fuel,but does the fuel injector pulse? Add fuel in the throttle body if it wants to start your problem and solution will resie in bringing the fuel injector to working level

Apr 13, 2012 | Chevrolet S10 Cars & Trucks

1 Answer

Blazer 1999 won't start got spark new fuel pump


Pull off one injector connector and use a test light or voltmeter to see if one wire has power with key on.
Power to the injectors is fed through the ignition switch, so with key on, you should have power there. The injector ground is inside the ECM. If you have power, you'll have to diagnose the circuit for why computer doesn't ground the circuit when it should.

Nov 06, 2011 | 1999 Chevrolet Blazer

1 Answer

Motor turns over won't start. Cleaned terminals, put in new battery, still won't start. Removed gas cap to vent air on hot day, still won't start. Lights all come on, all electrics appear to...


Your problem may be one of the following:
First check or just replace the fuel filter. Usually located under the car in front of the rear axle, drivers side.
Next, the fuel pump may be worn out. Usually they get loud or stop working (running).
Next, check the fuel pressure regulator. Usually located on the front fuel rail, drivers side.
Is the vacuum line attached? Not leaking or rotted?
Also, do you smell a strong fuel odor when it won't start? May be one or more stuck-open injectors, or the coil pack is bad.
Checking these in the order listed will more than likely fix your problem.
The clicking noise indicates the battery can no longer run the starter, which also means the fuel pump won't run either.

It could be a fuel issue. How old is the fuel filter? Can you hear the pump run for a few seconds when you turn the key on? Try turning the key to ON without trying to start engine three times waiting for the pump to stop running each time. Then try to start the engine. If it starts, Its a form of Vapor lock caused by the extreme heat we have had lately, and a weak fuel pump.

If none of this works, try a new fuel filter first. From there have someone check the fuel pressure regulator and then the pump. If you are in need of a new pump, take my word for it and spend the money to get one from a Dealer, and not from your favorite parts store. Most parts store parts are made in China and they are JUNK.

Aug 28, 2011 | 1997 Chevrolet Blazer

1 Answer

Ran out of gas-truck won't start-replaced fuel


you probably have air in the lines, if you have a carb, spray some quick start into the carb and turn it over, if it starts and then dies when the starting fluid has run out, you probably need a fuel pump, since the running of the car should have blown out any air that was in the line, If your car is fuel injected, loosen the bolt cap at the end of the injector line that supplies the fuel,, and tap the key once,, ( don't start it,, ) just turn the key on and off 3 or 4 times, this should blow fuel out of that loose bolt head, if it does your getting fuel, if not, back to the fuel pump, also you can check this link, http://www.aa1car.com/library/us1296.htm

Jul 24, 2011 | Chevrolet Suburban 1500 Cars & Trucks

1 Answer

My 95 ford ranger wont start i think its a fuel problem the fuel pump comes on and know the carborator is not bad i changed the fuel filter and put gas in the truck i dont know about the fuel injectors...


probly the injectors. i would run some fuel systems cleaner through it and see if that doesn't fix it man. give me a good rating please :) i only need one more

May 23, 2011 | Ford Ranger Cars & Trucks

1 Answer

Will not Start but turns over not getting gas replaced spark plugs and wires Injectors but still does not start. Put gas in by pouring it in starts but not run.


Have you checked the fuel pump and fuel filter? The filter might clogged not allowing gas into the engine. The pump might be bad so you're engine won't be getting any gas there either. Both of those are cheap and easy home fixes as well.

May 04, 2011 | Chevrolet Silverado 1500HD Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...