Question about Cars & Trucks

Open Question

My new Jeep Wrangler with Automatic transmission has problems when downshifting, it can go to D1, and I can bump it up to D3, but not D4. It can't return to Drive unless I stop the car put it into

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

wdmb08
  • 34 Answers

SOURCE: Car stops moving in reverse gear

Sounds like the car is just slipping out of gear. Keep your hand on the shifter when you back up next time. See if you can feel the shifter move when the car comes out of gear. If the shifter moves up when it happens keep pressure on the shifter holding it back like you dont want it to move forward. And of course if the shifter moves back when it comes out of gear, put forward pressure on the shifter so it doesnt slip out. This might work for now but but i know i wouldnt want to spen 700 for that ****. Let me know how it goes.

Posted on Nov 20, 2008

  • 6982 Answers

SOURCE: How do you know if your torque converter is bad on Jeep wrangler

First check fluid. Make sure it's full and clean and does not smell burned (compare to another good car)
Converter failure is usually most obvious when trans shifts to OD. if shift is late or makes bang noise going in, you likely have a problem. to check lockup, after od engages, lightly touch brake, trans should momentarily shift out of od. Whining is usually due to low fluid. Also check transfer case and both differentials for proper level and leaks.

Posted on Jan 24, 2009

csmock132
  • 4669 Answers

SOURCE: 2004 Jeep Wrangler - Clunking Noise when shifting out of Park

It could be lash in the differential which is normal, but it could also be a loose u-joint in the driveshaft. Check the rear driveshaft u-joints.

Posted on Mar 12, 2009

  • 149 Answers

SOURCE: car will not shift into gear

Sounds like a linkage/cable to me. Disconnect the linkage at the transmission and move the shift actuator by hand to see if there is the same things happening. Don't try to do this with the engine running unless someone is holding the brake inside the car.

Posted on Jul 03, 2009

Murphybanton
  • 2004 Answers

SOURCE: 1991 735i automatic transmission,no forward drive, has reverse

The transmission has gone bad and all I can say is that you need to replace it.

Good luck.

Posted on Aug 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 95 silverado c1500 with 4l60e trans and it wont go into overdrive


overdrive is the fourth gear.D1,D2,D3,D4 now drive truck at 80 kmh
cruise at steady speed no fuel pedal movement, downshift from D4 to D3 you should feel RPM raise .. after push brake pedal a little you should see RPM raise 300 to 400 rpm.
shift pattern is 1st gear ,second gear,3rd gear and lock up(torque converter clutch). 4th gear with lock up
hope it helps

Mar 29, 2014 | 1995 Chevrolet C1500

1 Answer

When do I use the d 5 gear in acura 2003 tl 3.2 liter


Pretty much all the time!

D3, D4, and D5 are all just *DRIVE* like on any automatic transmission, EXCEPT
that the number next to the D is the "highest gear the automatic transmission will go into".
The Acura just gives you a choice, in case you don't want to go into a higher gear (like if it's slippery traction or a steep hill, etc.)

1 means: Manual gear. FIRST GEAR ONLY.
2 means: Manual gear. SECOND GEAR ONLY.
D3 means: Use automatic transmission, but engine will never shift above 3rd gear.
D4 means: Use automatic transmission, but engine will never shift above 4th gear.
D5 means: Use automatic transmission, but engine will never shift above 5th gear.

Aug 04, 2011 | 2003 Acura 3.2TL

1 Answer

2002 Jeep Wrangler, had a slight tranmission leak, drained and filled-up with new fluid. Now transmission whines at least twice as loud as before. But at least the leak appears to have stopped. Any ideas?


There is air in the lines...start the jeep, pull the tranny dipstick and shift the jeep from D1, D2, D, N, R, P and back....assuming this is an automatic...and repeat until noise is gone. Don't forget to check the fluid level and replace the dipstick.

Feb 09, 2010 | 2008 Jeep Wrangler

1 Answer

Gear Position light D4 is always flashing irrespective of gear.


This issue is caused by a transmission fault or malfunction, most likely a shift solenoid in the trans has failed or the trans control module has a problem, the trans can be tested for codes that will show what circuit or component of the trans controls is causing the light to stay blinking, have it tested.

Dec 12, 2008 | 1995 Honda Accord

1 Answer

Automatic trans downshifting


You need to have the TPS checked, this will cause the kind of erratic shifting issue you have.

Oct 18, 2008 | 1995 Honda Accord

1 Answer

I just picked up a 87 honda accord and just want to know what gear i drive it in it has l2 d3 and d4 can you help got me confused


D4 - this gear means that all four automatic gears will be able to work (1,2,3,4)
D3 - Three gears will be able to work (1,2,3)
D2 - Two gears (1,2) - L2 means the same thing
D1 - One (low) gear (1)

For your car, drive it in d4. this means that all forward gears will work, including overdrive (4th gear). It will be fine to leave your car in this gear.

Jul 20, 2008 | 1992 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...