Question about Mercedes-Benz CLS500

Open Question

Check engine light turned on in a cls 350

The car has been stationary for 3 weeks . i turn it on every 4 days.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2427 Answers

SOURCE: power steering difficult to turn wheels in tight stationary spots

no its not.. something is wrong with the power stearing assemply. is there oil leaking ? if so there may be a hole i the line. of nothave the power stearing motor checked.

Posted on Apr 04, 2009

  • 218 Answers

SOURCE: Check engine light came on

THERE IS A VALVE ON THE RIGHT SIDE OF THE INTAKE MANIFOLD THAT OPEN THE RUNNER.IT HAS A VACUUM LINE TO IT.FOR IT TO BE STUCK OPEN EITHER THE SOLENOID IS BAD,THE VACUUM LINE IS BAD OR THE RUNNER IS GUMMED UP WITH CARBON AND STUCK OPEN

Posted on May 15, 2009

  • 2 Answers

SOURCE: 1998 Lincoln Town Car: No turn signals, 4 way flash, brake lights

If only your brake light in middle of rear window works then your other bulbs are bad. If brake lights all work in the back than bulbs are good. If you put turn signal on right or left and the bulbs light in front and back then you need to change multifunction light control box under dash. My understanding is it cost $600 new. So I would try used.

Posted on Jun 14, 2009

  • 634 Answers

SOURCE: code 171 check engine light on 2000 corolla

sounds like you have a bad fuel injector a good service station can read the individual injector pulses and see, check spark plugs is one extra dirty or clean? clean leaking injector dirty no fuel

Posted on Jul 06, 2009

fingaz22
  • 1068 Answers

SOURCE: 1994 Acura Legend check engine light is on. When

turn the ignition key to the acc or lock position with the odometer reading showing.

while holding the trip/reset button turn the ignition to the on position. light should flash and go out!

reset done. if you have any more issues plese ask. good luck

Posted on Sep 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Automatic transmission won't go into gear, at red light( 3 miles from home) had to pull over, won't go in 1st or 2nd gear, would go into reverse but it was hesitating. turned car off, started again and it...


Check the tranny oil level ,with engine stationary and cold pull dipstick for transmission and it should be about a 1/4 to 1/2 inch above the full mark

Jan 10, 2014 | 1997 Mercury Grand Marquis

1 Answer

2001 Bonneville! Several weeks ago, had trouble turning the key in the ignition - sometimes would turn, sometimes wouldn't. Then the Service Engine Soon light came on and the car stalled out a few times...


Service Engine Soon came back on and the car is again stalling ????? Did you have it checked for DTC'S - diagnostic trouble code's ? Service engine soon light on , codes will be present !

Apr 20, 2017 | 2001 Pontiac Bonneville

2 Answers

I turn the turn signals on front works back don't 2005 ford f 350 super duty its not the fuse what should i check


If the steering column has the warning 4-way flashers mounted on the column, then push the 4-way flasher button about a dozen times and see if everything works again.

The turn signal shaft, multifunction switch has all the contacts for the lights, wipers, and turn signals. Sometimes the contact points get out of alignment and the alignment is sometimes corrected by using the 4 way button.

May 31, 2012 | 2005 Ford F 350 Super Duty

1 Answer

About 2 weeks ago my check engine light came turned on so i drove home and told my dad about it but when we turned the car on it did not flash. But the the next 2 days it stayed on and the next morning...


Any time you get any check light, you should
be at a repair in a couple of days, or at least
check for codes. Still need it diagnosed and
repaired in a week

Otherwise you waste gas,polute the air or could
cause some damage,as you don't know what the issue
is that set the light

The fact the check light went out, doesn't mean
the problem went away.

Don't clear any codes you find,their needed to diagnose
the system faults

Apr 05, 2011 | 2006 Mitsubishi Eclipse

2 Answers

Please show me the position of the #1 spark plug wire on the 95 350's distributor


If you are talking about a 350 Chevrolet (GM) engine, the #1 plug is at the drivers side front. To find the position on the cap, turn the engine 'till the timing mark on the lower pulley points to 0 on the scale, then check rotor position in the distributor. If it's pointing towards the firewall, make one more turn. The firing order goes in the direction the rotor turns when cranking the engine over. 18436572.

Jun 28, 2010 | Cars & Trucks

1 Answer

Transmission problem


Turning the steering 15 times is not going to damage the computer or the engine--- the only thing that you are damaging or hurting is the tire threads and the steering ball joints because by turning the stering with the car parked creates more stress on this components. If you wanted to bleed the steering system it needs 2-4 full turns to bleed the system out, and normally you do that with the front wheels jacked up so there is no stress on the steering components.
Now you say that it has poor acceleration ? Checked for tune up ?-- fuel filter? You are saying it's a new car-- but you have listed it as a 1996 car? That's not new -- that's 14 years old.
If that car is in need of a tune up, then ----the transmission shift points will change.
Good Luck.

Mar 01, 2010 | 1996 Honda Accord

2 Answers

2001 Jeep grand cherokee limited v8 engine, did diagnostic test and code P0320 came up. Wondering what needs to be done, and if possible, if diagram


Hello...

P0320 means "No Crank Reference Signal To PCM"

The Crank Position Sensor needs to be checked.

Good Luck

Dec 12, 2009 | 2001 Jeep Grand Cherokee

1 Answer

Power steering difficult to turn wheels in tight stationary spots


no its not.. something is wrong with the power stearing assemply. is there oil leaking ? if so there may be a hole i the line. of nothave the power stearing motor checked.

Apr 04, 2009 | 2000 Chevrolet Silverado 1500

1 Answer

Trouble with car


Phantom coolant level warning which turned out to be erroneous. No problem found and no catastrophic meltdown. Just the inconvenience of having to take it into the dealer to be checked.

May 14, 2008 | 2008 Mercedes-Benz Mercedes Benz Cls Class

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

91 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75051 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...