Question about Mitsubishi Eclipse
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I assume this is an automatic transmission, you didn't say.
There is no dip stick on the transmission any longer.
You will have to go under the car to check. You may want to go to your local instant oil change and have them check the level.
If you feel you want to check it, here is a description of the location and process.
Make certain the vehicle remains level while checking the fluid.
Located just above the top sealing flange of the transmission oil pan you will find a threaded plug. Remove the plug and see if transmission fluid drips out of the hole. If so, the fluid level is correct. If not, remove the red fill cap on top of the transmission, driver side. Add fluid to the transmission until fluid dribbles out of hole.
Replace and tighten the plug.
Posted on Mar 24, 2009
If trans is still shifting its most likely a blown cluster fuse or bad cluster.If you have a check engine light & trans don't shift most likely blown trans fuse or trans vss (speedo) harness at right drive axle broken puple with white stripe wire or light green wire with black stripe
Posted on Sep 03, 2009
There has been issues with the solder joints on the PIN connection to the gauge cluster. The issue being that over time thru vibration and such one of these solder joints will fail (happened on or 1999) you can repair this though. You will have to remove all of the trim from around the driver's side dash board, this will include the trim towards the center of the dash. Once these pieces are remove you'll need to remove the gauge panel (I believe (4) allen head screws) carefully bring the panel and release the wire clip from it. Looking at the back of the panel, where the plug was, carefully with plenty of light look for one of the pins to have a failed solder joint. It will be very faint however the failed joint will be a fine dark line around the pin. To correct use a small soldering iron and reheat this solder until it wants to flow, let it cool and reassemble.
I hope this may have helped,
PS: I have helped several persons with this issue, please review my profile; good luck with it (also often times with this issue the ABS light stays on)
Posted on Oct 20, 2009
Testimonial: "thank you you are the only person who had an answer I will try and let you know"
SOURCE: 2005 pontiac sunfire
I have the same problem.. i installed a toggle switch for the fuse so at least I can reset it while driving.. its still a pain so Im thinking my next step will be to drill a hole through the plastic and put in a small metal post to stop the tach from going past 7
has anyone taken theirs into a shop?
Posted on Mar 14, 2010
Tips for a great answer:
Apr 09, 2013 | 1999 Pontiac Sunfire
Oct 19, 2010 | Pontiac Sunfire Cars & Trucks
May 11, 2009 | 1997 Pontiac Sunfire
Mar 22, 2009 | 2005 Pontiac Sunfire
May 24, 2017 | 2004 Pontiac Sunfire
Nov 28, 2008 | 2005 Pontiac Sunfire
Nov 17, 2008 | 2004 Pontiac Sunfire
Jul 09, 2017 | 2005 Pontiac Sunfire
37 people viewed this question
Usually answered in minutes!