Question about Chevrolet Cobalt

Open Question

Replace turn signal switch 2006 chevy cobalt - Cobalt Chevrolet Cars & Trucks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 76 Answers

SOURCE: how to adjust headlights on 2006 chevy cobalt

There will be adjustment screws located on at least two different spots surrounding each headlamp. By turning these screws you move the angle of the headlamp. Most shops will do this at a very resonable rate, I say this because improper headlamp angle may lead to a ticket, or at least a warning. To say the least, they have to be at specific angles and heights. Good luck.

Posted on Feb 20, 2009

  • 1 Answer

SOURCE: Chevy Cobalt: key stuck in ignition

For me, this problem was covered by my chevy dealership since it involves a recalled part. Apparently we aren't alone :) thank god

Posted on Jun 29, 2009

  • 521 Answers

SOURCE: my 2006 chevy cobalt 2.2 liter sputters

Fault with the IAC valve.there maybe a trouble code associated with it also./ Go to your nearby autozone or auto parts retailer and ask them to put a scanner to the car....make note of the codes if any are found. the IAC valve i usually locate don the throttle body and can be removed for inspection and sometimes cleaning using a good throttle body cleaner spray and a pipe cleaner brush.

Posted on Aug 04, 2009

  • 124 Answers

SOURCE: Fan switch does not work in the 1, 2, 3, position 2006 Cobalt

You have a problem with the blower motor resistor. This is a very commen problem on all gm cars and light trucks. The part is not to pricey. You can find the resistor under the glove box buy the blower motor. Two bolts and out it comes.

Posted on Sep 14, 2009

  • 324 Answers

SOURCE: how replace turn signal switch 2000 chevy blazer?

Since the 2000 chevy blazer is equipped with SRS (Saftey Restraint System), ie: Airbags, which is located in the steering wheel. In order to replace the turn signal switch you must remove the steering wheel. Therefore I would only highly advise you to take it to a dealer to have this done.

Posted on Oct 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No crank signal


Change the ECM too if they can exchange. Your car controlled by ECM so see this work.

Dec 19, 2013 | 2006 Saturn Vue

1 Answer

My 2006 cobalt wont start


There can be a couple things, nutral saftey switch, AC DELCO, NEUTRAL SAFETY SWITCH Direct Replacement Part For OE Number 24219476 `$68.67 , ignition switch not adjusted correctly, try jumping the starter at the starter to see if the starter is working, of course I have just fixed a car that the guy didn't have the shifter in park, try these things and get back to me

Oct 18, 2011 | 2006 Chevrolet Cobalt

2 Answers

My 2008 Chevy Cobalt coupe has a passenger side turn signal that flashes fast on the instrument panel. However, no turn bulb is burnt out in either the front or rear. The rear passenger turn blub just...


It is as simple as your hazzard switch needs to be replaced yes your hazzard switch as now turn signals are built threw the hazzard switch my PT Cruiser had same problem as my s10 replaced hazzard switch fixed the problem

Aug 18, 2011 | 2008 Chevrolet Cobalt

1 Answer

How do I replace my rear turn signal? I have a 4 door 2006 chevy cobalt. Owner's manual isn't very clear. I have the carpet pulled back an the knut off the screw, but I can't get the light off the car to...


To my knowledge there is one screw you need to remove after you pull the carpet back (the one you took off), there are two more screws you undo from the outside of the car with the trunk open. Hope this helps.

Feb 15, 2011 | 2006 Chevrolet Cobalt

1 Answer

2006 chevy cobalt LT. the key is stuck


Have you tried shifting the gears completely through and then putting the car in park. It sounds like the car isn't able to be put completely in park to release the key. Try putting the car in N and removing the key. Even thought the car may not completely be in park to release the key, The gear most likely is in park but not enough to make the switch/sensor to release.

Jul 16, 2010 | 2006 Chevrolet Cobalt

1 Answer

Turn signal on 2006 Cobalt does not make a clicking sound but the signals work fine.


The clicking sound comes from the old-fashioned thermal blinker switch. There is an electronic flasher unit whick is a direct replacement (and usually more reliable) which does not make a noise. This is probably what you have. There is no problem.

Mar 14, 2010 | 2006 Chevrolet Cobalt

1 Answer

Chevy Cobalt turn signal issues


There is a plastic piece inside the steering column that will automatically turn the turn signals off when the steering wheel is turned back to 'straight ahead'. This plastic piece can break, and if it does, they can only be turned off manually, as you are doing. I have not worked on anything as new as your cobalt to repair this, but on older cars it involves removing the steering wheel and turn signal assembly. You must also deal with the air bag. Don't attempt this repair unless you have a manual to follow to disarm the air bag and properly remove the steering wheel and other components.

Jan 01, 2010 | 2006 Chevrolet Cobalt

1 Answer

Fan switch does not work in the 1, 2, 3, position 2006 Cobalt


You have a problem with the blower motor resistor. This is a very commen problem on all gm cars and light trucks. The part is not to pricey. You can find the resistor under the glove box buy the blower motor. Two bolts and out it comes.

Sep 14, 2009 | 2006 Chevrolet Cobalt

2 Answers

Powersteering goes out randomly. Its electronic


your chevy cobalt has a eletrionic power steering steer gear there is no power steering pump. there is a relay switch that if wet will short out. try to disconnect your battery for 10 min to reset to factory specs

Mar 03, 2009 | 2006 Chevrolet Cobalt

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

227 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...