Question about Nissan Cars & Trucks
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Hi El Faraon,
I believe that you're dealing with 12 mm bolts and nuts....THESE ARE NOT THE SPECS FOR YOUR ENGINE, but I believe that if you use them you'll be close....Tighten in three stages up to 22nm....choose the bolts from the centre of the manifold and circle outwards until you reach the last one.....It may be a good idea to draw an overhead or plan view of the unit, marking out the bolt positions.....Start at the centre and mark the sequence and follow that....What is important is starting at the centre, so that nothing becomes warped....
Hope this helps,
Posted on Sep 06, 2008
The knock sensor is not a huge deal to replace and will not turn on the light. It should be dont though.
The crankshaft sensor is located directly between the engine and transmission. It is dead center at the bottom.
Posted on May 21, 2009
Locate the temp switch in the engine bay, if its a single wire just earth it and see if your gauge moves. If it does then get a new switch.
Posted on Jan 27, 2010
The power fuse for the accessory power outlets (front and rear) is in the engine compartment on the passenger side. If the fuse is good, check the positive (center) connection in the outlet for power. These outlets are subject to ground (negative) failure local to the outlet socket
Posted on Mar 02, 2010
Tips for a great answer:
Oct 06, 2014 | 2000 Nissan Xterra
Jul 05, 2011 | 2000 Nissan Xterra
Dec 21, 2010 | 2000 Nissan Xterra
Dec 01, 2010 | 2000 Nissan Xterra
Aug 09, 2010 | 2000 Nissan Xterra
Mar 04, 2010 | 2000 Nissan Xterra
Aug 11, 2009 | 2005 Nissan Xterra
Jul 07, 2009 | 2005 Nissan Xterra
39 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: