Question about 1999 Lexus RX 300
Posted by Anonymous on
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
If it is running perfectly I wouldn't think that you would need to replace the timing belt. You shouldn't need to replace that until 100,000-120,000 miles. I would definitely hold off until now unless you have start having some timing problems. Let me know if you have any other questions. Thanks for rating my response and for using FixYa!
Posted on Jul 08, 2009
Remove 3 - 4 screws on fender cover close to side marker light. Pull fender cover out a bit for you to use your other hand to reach side marker light. By twisting on one direction and here you go the light out. Replace new bulb and replace everything on reverse order.
Posted on Aug 18, 2009
VSC means Vehicle Stability Control.
It comes on when the sensor send a signal that the vehicle is not stable on the ground.....check the wheel balancing and alignment and the air pressure of your tires too.
Rate this solution.
Posted on Aug 23, 2009
SOURCE: I have 3 codes 1) P0500
The PO125 is an indication of an engine running too cold-as if the thermostat were stuck open.For some reason it often sets with the PO1135 even when the engine runs at normal temp.A scan tool will indicate exactly how hot the engine is,don't trust the dash gauge. The PO1135 is a heater circuit fault in the bank1 sensor1 air fuel ratio sensor or oxygen sensor. Bank 1 is the REAR bank on this car...that O2 sensor is not much fun.PO500 is a vehicle speed sensor fault-does the speedo work correctly?it is located in the transmission near the back of the case. once again the scan tool will read vehicle speed and can aid in further diagnosis.
Posted on Mar 30, 2010
SOURCE: 1999 lexus rx300 check engine
Your 306 code means you have a misfire on cylender 6. That may be the cause of the po 125. Inspecdt the coil, spark plug wire, and spark plug on cylender 6. With the age of the car I would replace all 3 items. If you want know how to test all 3 I can tell you process of elimination is the way to do it. Do you know how to find cylender 6
Posted on Oct 15, 2010
Tips for a great answer:
Feb 19, 2014 | Lexus RX 300 Cars & Trucks
Oct 14, 2017 | 1999 Lexus RX 300
Apr 13, 2010 | 1999 Lexus RX 300
Jan 25, 2010 | 2002 Lexus RX 300
Jan 07, 2010 | 1999 Lexus RX 300
Jan 05, 2010 | 1999 Lexus RX 300
Dec 31, 2009 | 1999 Lexus RX 300
Aug 20, 2009 | 1999 Chevrolet C/K 2500
103 people viewed this question
Usually answered in minutes!