Question about 2003 Chevrolet Monte Carlo

Open Question

How do I check injector pulse on 2003 monte carlo

3400 eng

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: loss of power...2003 chevy monte carlo

catalitic converter if car is under 80,000 miles or 8 yrs dealer must replace free i had same problem

Posted on Jan 10, 2009

Ad
  • 840 Answers

SOURCE: need serpintine belt diagram for

Call chevy parts department with vin # and they can give the schematics of the belt but their should be a label inside of the hood or radiator support showing you where it needs to go. Please rate my response than you very much

Posted on Jan 28, 2009

  • 1 Answer

SOURCE: need diagram for serpentine belt on a 2003 monte carlo

http://gsi.xw.gm.com/image_en_us/gif/000/000/043/43400.gif

Posted on Feb 03, 2009

mcgyver468
  • 710 Answers

SOURCE: location of low pressure ac valve and type of

SHOULD BE IN THE FRONT OF THE ENGINE SORT OF LOW, IN FRONT OF THE FAN. IT HAS A BLUE CAP ON THE FITTING AND THERE IS AN "L" ON IT. I HOPE MY MEMORY SERVES ME WELL. IF ALL ELSE FAILS, THEN LOOK FOR THE LARGER OF THE TWO LINES MADE OF ALUMINUM, COMING FROM THE CONDENSER. WELL I HOPE THIS HELPS YOU. PLEASE KEEP ME POSTED. THANKS FOR AN HONEST RATING AND FOR USING FIX-YA. GOOD LUCK

Posted on May 19, 2009

  • 14 Answers

SOURCE: 2003 Monte Carlo SS Hesitates and Dies after running for awhile

The ck engine light should not be ignored, what sensor was shown to be bad ? Have it scanned again and replace the sensor that is bad if it still runs rough you might want to consider a tune up. Plugs, wires, fuel and air filter's and clean the throttle body with some gumout. It could also be the IAC motor Idle Air Control. Good Luck

Posted on Jun 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 monte carlo engine cranks but will not start


If it cranks good but won't start, have a helper crank it while you visually check for spark at the spark plugs, if spark everywhere, use a gage and check fuel proper fuel pressure. Check fuel injector pulse.

Check your security system.

Feb 22, 2015 | 2006 Chevrolet Monte Carlo

1 Answer

02 monte carlo has spark fuel no start


Not to sound cute, but if it has spark at the right time, fuel to the injectors, injector pulse, and normal compression, it should start.
So something has to be missing.
What have you checked so far, and which engine do you have ?

Jan 30, 2013 | 2002 Chevrolet Monte Carlo

1 Answer

Cylinder one on monte carlo 2003


If the code is 301 it means there is no power from that cylinder. It could be a problem with the ignition, fuel injector, or something mechanical.

Dec 06, 2012 | 2003 Chevrolet Monte Carlo

1 Answer

2003 monte carlo 3.4 130,000 skips on start up


I'd suspect a sticking injector--car should have set the check engine light. Read the code(s) to progress further. If the coil pack were a problem, it would not be likely to fix itself. If the codes indicate an injector problem, try an injector cleaner in the fuel--worst case, replace the bad injector. The codes should indicate which cylinder to change the injector.

Sep 09, 2012 | 2003 Chevrolet Monte Carlo

1 Answer

2003 Chevy monte carlo 3.4L, need the torque


Check Autozone.com. There repair section should have the torque specs and order of tightening.

Mar 06, 2010 | 2003 Chevrolet Monte Carlo

1 Answer

Where do you fill power steering fluid in 2003 chevrolet monte carlo


The 3100 and 3400 Engine Models have the power steering reservoir located on top of the engine on the passenger side of the vehicle, located directly on top of the power steering pump. The 3800 engine has the power steering pump located on the rear of the engine. you will want to wait until the engine is cold, some of them are a tight squeeze and can cause burns when it's hot. You have to, with the engine OFF, reach back and around and take the cap off to pull out the Cap/Dipstick and check it. Filling it is the tricky part, I have some tubing attached to the end of a funnel I use to Fill them, I currently work at a GM Dealership. Sometimes the wiring runs right on top of the reservoir, and it can be a hassle to get the cap off.

Aug 13, 2009 | 2003 Chevrolet Monte Carlo

2 Answers

Cold engine startup rattle


The problem might be fuel injectors...

Jun 22, 2008 | 2004 Chevrolet Monte Carlo

Not finding what you are looking for?
2003 Chevrolet Monte Carlo Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...