- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
I think you should see screws inside the trunk and on the back of your tail light then unscrew them and you'll be able to get the whole tail light out and then you can take the bulb out by turning the bulb cover. Good luck
pop the trunk and right behind where the lights are pull the carpet
down and their will be of the following depending on the trim.
You will either see the light sockets themselves that you can twist and pull to change the bulb, or you will see the plastic nuts/screws that you can remove to remove the entire assembly in order to access the bulbs.
If it's your 3rd brake light, the screws to access the housing are located in the upper part of the trunk
If you open the trunk and remove the rear trunk trim, at the tail light area, you will see the fasteners that hold the tail light in position. Remove the fasteners and the tail light will come out, you can replace the bulb that is defective.
if it is a taurus wagon then you need to take a screwdriver and you can aactually pull the light down and the just pull of the cover and take out the bulb. if it is sitting on the back dash try opening your trunk and looking at it from inside your trunk and you should be able to access it that way.
First of all, number your wires before you pull them off. Pull the wires off, unplug the module. (You need a deep well swivel socket to get to the bolts). Also, make sure your battery cable is disconnected - being close to the starter wires. It's easier to get to from under the car. Make sure you use jack stands and be extra careful. Hope this helps. Phil
on my buick lesabre you have two star screws right on top of the tail light plate then you take them out you can pull out the whole case and you have all 4 bulbs exposed just turn the case and the socket come out and change bulbs
I hope it helps