Question about 2007 Mercedes-Benz ML320 CDI

Open Question

1999 320 ml LOW BEAM LIGHTS OUT

BOTH LOW BEAB HEAD LIGHT OUT , THE LAMP IS OK BUT IT WONT COME ON HIGH BEAM WORKS

Posted by on

6 Suggested Answers

  • 193 Answers

SOURCE: high beams wont turn on.

First place to start is with headlight switch. I did have a case many years ago when both high beams were blown out at once, but this is rare. When you have the headlight switch out, jump power from te low beams to the high beam contacts. If high beams come on, replace switch.
Bill

Posted on Nov 19, 2008

dgjtex
  • 405 Answers

SOURCE: left low beam light doesn't light

Go to autozone and ask them to put it in for you..lol or o'reillys. Youd be surprised at how much they will help you if you ask, It would be hard for me to tell you how, but under your hood on each side of your radiator, you can probably see back of headlight. If not it may have to be removed, just look how it is held in place, If I didn't help you I will if you will provide me more info, I do this for free to help people, please give a me a good rating, I don't have anything to gain by trying to help but for a better rating

Posted on Dec 19, 2008

  • 1 Answer

SOURCE: low beam headlights not working on 2004 Pontiac Montana extended

You headlight lamp have a diffuser mechanism which allows it to flip between the hight beam and low beam feature of the bulb. In fact, you high beam will function even if the low beam is not working.

I would recommend the purchase of the new headlight lamp. It would cost you you any where from $15.00 per unit to get a replacement lamp

Posted on Jan 06, 2009

  • 2 Answers

SOURCE: 1994 Mercedes c280 high beams not working...

At first 1994 C280 high beams began to not connect regularly when stick pushed forward, then not at all. Drove high beams by pulling and holding stick back towards steering wheel until that stopped working, too. Shop said the turn signal switch was at fault-- had seen it many times before with W202; about $160 to replace. Haven't done it yet, but should be an easy fix?

Posted on Jun 24, 2009

ourhowse
  • 2007 Answers

SOURCE: my low beam head lighjts do not work but the high

If you are absolutely certain the bulbs are okay, then change the switch. I would check for power at the socket first, to make sure it isn't bulbs.

Posted on Jul 25, 2009

  • 290 Answers

SOURCE: no low beams bulbs are ok fuses look good

There may be a relay that operates the low beam lights, check the owners manual to see if there is a relay, you should be able to hear it go "click" if there is one.

Posted on Dec 26, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2001 ford ranger , no high or low beam lights


Check the On/Off switch on the dash, steering column, and the steering arm/lever is connected properly and that the lighting cable's are cable connectors are connected and not corroded.
1, To check the Earth: Connect a cable from the earth of the bulb to the chassis/body/ metal part of the car.
2, Using a Test lamp: Disconnect the cable that connects the power to the head light bulb, Connect one end of the test lamp to any one of the connectors at the end of the cable that plug's into the bulb. With the low beam on, only one of these wire's will the light switch turned on will light up the test lamp bulb. If none of the cable's light the test lamp bulb. the problem is in the High beam relay, and possibly the Low beam relay as well.
One Head lamp relay: If one cable show a light in the test lamp, check the earth cable on that lamp.
Two Head lamp relay: If two cable's show a light in the test lamp, check the earth cable on that lamp.
Some of the car's electrical systems use the Steering column as an earth point. Check the switch.
In many cases are what is called Earth return (this means that the positive power (+) is supplied by one wire, and the negative earth (-) is connected via another wire) this is to reduce the problems of the rust effecting the power flow.
Get the wiring loom layout in the Cars book
Sorry I can't be of more help

Jan 13, 2014 | 1998 Ford Ranger SuperCab

1 Answer

Headlights wont go on all other lights work. Just high beam and low beam and the blue high beam indicator light on dash. changed headlight switch checked battery ground cable and ground wire to body.


check the fuse block under the hood, drivers side . head lights have fuses there may look ok but check with continuity tester to make sure. test wires at the head lights as well. best bet is the fuses

Oct 06, 2013 | 1996 Dodge Neon

2 Answers

2001 suburban


Well the high and low beam lamps use the same fuses, and the dimmer switch handles the ground circuit. So I would check the dimmer switch if both high beam bulbs are ok.

Jul 23, 2013 | Cars & Trucks

1 Answer

GMC Envoy 2003 SLT only the parking lights and fog lights work. The low beam and high beam don't work. Please help


Well, the problem is that I dont know the reason, you should investigate. There could be issues with lamps (must get new) or electricity problems (must head to auto-service)

Jun 29, 2012 | 2003 GMC Envoy

1 Answer

I have aproblem with my Buick Allure both low beam stoped working.The high beam works OK. Checked the fuses and there OK can you help


suspect low beam head light fuse, check fuse if ok suspect that both low beam head lights are burned out ( it happens) ,if ok suspect headlight dimmer switch.

Nov 16, 2010 | Chevrolet Avalanche Cars & Trucks

1 Answer

Head lamp wont work


Try replacing bulbs they could have both gone at the same time,I think it takes a 9006 bulb. You could check by pluging low beam plug into high beam bulb if it works the low beam bulbs are gone

Feb 06, 2010 | 2001 Pontiac Montana

1 Answer

Headlights not working at night but my day time running lights work just fine


possibly head lamp switch. daytime running lights on separate circuit and use the high beams at reduced voltage. does flash to pass work? that's high beams too. do high beams work?

Is it just low beams?
do taillights work?

Mar 01, 2009 | 1997 Cadillac DeVille

1 Answer

Low beam headlights not working on 2004 Pontiac Montana extended


You headlight lamp have a diffuser mechanism which allows it to flip between the hight beam and low beam feature of the bulb. In fact, you high beam will function even if the low beam is not working.

I would recommend the purchase of the new headlight lamp. It would cost you you any where from $15.00 per unit to get a replacement lamp

Dec 26, 2008 | 2004 Pontiac Montana

1 Answer

1999 Chevrolet Astro Van problem


the head lights have tree wires goig to it one groun one gets power when high beams on the 3rd gets power only with low beam on test the wires or try by plugin a good known head light to conector if it works with low beam then replace both head ligts because head light come with two bulbs in one high and low

Jun 02, 2008 | 1999 Chevrolet Astro

Not finding what you are looking for?
2007 Mercedes-Benz ML320 CDI Logo

Related Topics:

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

yadayada
yadayada

Level 3 Expert

60960 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

164 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...