Question about 2009 Chevrolet Cruze

Open Question

Replace side mirror on 2012 chevy cruze - 2009 Chevrolet Cruze

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

johnjohn2
  • 5763 Answers

SOURCE: I broke the glass in my side mirror on the

remove the broken glass with putty knife. go to a auto glass shop they can sell you a replacement heated mirror glass. the new glass is just glued to plastic housing in mirror and just plug in 2 little wires to back of glass were heat element is.hope this helps good luck.

Posted on Oct 20, 2009

  • 1 Answer

SOURCE: passenger side mirror

If you need to replace the entire mirror - it's a little involved. First you need to take the upper extension panel off from behind the mirror (black triangle) - just pull it of starting at the top. It will snap back on later. Next - remove the different screws holding the door panel in place (not the ones behind the mirror yet!) One is under the handle (pull it out and pull out the filler panel - small plastic thing that has a hole to pry it out). Then take off the rear red light - also pops off - and remove that screw. Finally - pick up the rubber filler where your fingers pull the door shut and remove these torx bolts.

Now is the tricky part. Snapp off the entire interior panel. It will pop off - but very difficult. It will sound like it is breaking! Start at the outer bottom corner - and use a door panel remover tool - check Amazon or E-bay - to keep from breaking things. Pull it out from all around the bottom and sides and then lift it up over the door lock. It good to have a friend help here. The panel will still be held on by a cable - that is your door release - leave it alone and let the panel hang by it (or better, put a box under it to rest on).

Now...remove the three bolts holding the mirror on - have a friend help hold the mirror while you do this or it will scratch your new car! Since the inner panel is off - you can also disonnect the mirror plus and remove it. It sounds silly - but the only reason to remove the door panel is to unplug it!

Get you new mirror and reverse the steps.

If you are just replacing the glass (non-heated) - get a replacement from the dealer. Adjust the mirror all the way to the inside and reach behind and pop it off. CAREFUL - put tape over the entire glass as it will likely break even more! Remove your connectors if heated - and replace (and reconnect) with your new glass. It just pops back on!

Replacing glass is easy - just be careful of cheap imitations on e-abay). And never use cheap flat glass on the passenger side! The DOT has special requirements for mirror glass - buy it from gmpartsdirect.com or your local dealer.

kb

Posted on Jan 08, 2009

  • 202 Answers

SOURCE: Replacing driver's side mirror on a 1994 Chevy Lumina sedan

There are screws that hold the door panel on. They are typically located behind the small round plastic covers. If you look at the bottom of the door handle, you will see them. Also on the door lever, there might be a screw. After removing all of the screws, take a flat head screw driver, and gently pry up the panel. There are plastic clips that hold the panel securely to the door. Doing this will pop them out one at a time. Once the door panel is loose, lift it up, and it should come right out. Be sure to disconnect any wiring harness connectors before fully removing.

Posted on Mar 24, 2009

c17hydro
  • 2984 Answers

SOURCE: How do I replace a side mirror chevy corsica?

Please don't forget to rate....thanks:


Removal & Installation The door outside mirrors are stud mounted to the door filler. The mirror glass face may be replaced by placing a piece of tape over the glass then breaking the mirror face. Adhesive back mirror faces are available. Left side flat and right side convex mirror faces must be replaced with the same type mirror face when surfaced.

  1. Remove the door trim panel.
  2. Remove the upper trim panel.
  3. Remove the sound absorber.
  4. Remove the (3) nuts.
  5. Remove the control cable from the upper trim panel.
  6. Remove the filler and mirror.
To install:
  1. Place the filler over the studs on the mirror.
  2. Install the control cable through the filler and connect to the upper trim panel.
  3. Install the (3) retaining nuts and tighten to 42-72 inch lbs. (4.7-8.1 Nm).
  4. Install the sound absorber, upper trim panel and trim panel.

Posted on Mar 06, 2010

  • 14 Answers

SOURCE: removing the driver side mirror from a 2008 3/4

ok on the inside of the door at the corner where the mirror is you will see a black plastic cover. take a flat head screwdriver and slide beetween the cover and the door and pry on it. you will hear it snap but it is just the retaining clips coming out dont worry you can reuse them. once off you will see three nuts remove those nuts i think they are 10mm and the mirror will come right off. if its power there will be a wiring plug that you will have to un-couple but its pretty self explanitory after that

Posted on Mar 25, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The Drivers side woidow will not work up or down the auto parts store said the motor is working what do I need to do to fix it?


I would say your cable broke on your assembly for your power window.. it would be easier to buy the window regulator assembly complete , Meaning motor and window track assembly. This same thing happened on my sons 2012 Chevy Cruze. . I replaced the window regulator assembly complete and it works fine.

Dec 04, 2016 | Cars & Trucks

1 Answer

Whats the headlight bulb size for holden cruze 2012 model?


Do you mean bulb type? Is this the same as a Chevy Cruze. We don't have GM Holdens here.

Jun 30, 2016 | Holden Cars & Trucks

1 Answer

Sunroof will not close in vent mode


Top 144 Complaints and Reviews about Chevy Cruze

www.consumeraffairs.com > Automotive > Auto Manufacturers
Rating: 1.4 - ‎84 votes I bought my 2012 Chevy Cruze LTZ from Purifoy Chevrolet in Ft. Lupton. ... Negative battery cable may not have sufficient clamp - don't bring it in unless you ..... is one, coolant is leaking, engine is idling, car is shutting off, the car is shaking.

Sep 24, 2015 | 2012 Chevrolet Chevrolet Cruze LT

1 Answer

What does the trouble code b2aaa for a 2012 chevy cruze mean it just says undefined on my code reader


this could relate to the OBD code P0672 , which is for #2 glow plug , is your vehicle a diesel ?if not i can only suggest giving a Chevvy dealer a ring and ask them ,as must be a chevvy based code for the own diagnostic equipment

Jun 26, 2015 | 2012 Chevrolet Chevrolet Cruze ECO

1 Answer

Replace the right exterior mirror on a 2012 Chevy Cruze


any old local body shop will do it for a small amount .

Feb 19, 2015 | 2012 Chevrolet Chevrolet Cruze LT

1 Answer

How do I remove a broken key in the ignition of a chevy cruze 2012 when the switch is not all the way in the off position


Try lil dab of job weld on something that fits and let dry...might work..might not...sounds good tho...lol

Sep 09, 2014 | 2012 Chevrolet Chevrolet Cruze LT

1 Answer

2012 chevy cruze 27000 miles on it check engine light came on had it checked at o'rileys auto store an code po597 came up.


Sounds like your car will need a new thermostat heater unit. Its all one piece and will need to be replaced as an assembly. It should be under warranty seeing as the car will not pass state inspection with this failure. It is computer controlled.

Jun 16, 2014 | 2012 Chevrolet Cruze LS Sedan 1.8L 4-cyl....

1 Answer

What does the diagnostic code p0480 mean on a 2012 chevy cruze ls


I have the same vehicle in an automatic transmission. My car had the same problem, and it turned out that the thermostat was stuck open and had to be replaced. A simple 90 minute trip to the dealer fixed this. Bonus for me, as it was covered under warranty. I hope this helps!

May 29, 2014 | 2012 Chevrolet Cruze LS Sedan 1.8L 4-cyl....

Not finding what you are looking for?
2009 Chevrolet Cruze Logo

Related Topics:

1,103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...