Question about Cars & Trucks
On 95-97 and possibly 1998, Chevy Blazers both the turn signal and hazard flashers are located behind the lower dashboard trim just to the left of the cigarette lighter. You can not get to it without taking apart the trim. Thank you for asking ChaCha please be sure to ask ChaCha another question again soon!-------------------------------------------------------------------------------
Truck & Heavy Duty Diagnostic tool
Posted on Dec 04, 2012
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 1994 devilles flasher location
Turn signal flasher module is behind dash left of steering column near chime module. I have a 94 Seville and I had that same problem you need a Turn Signal Flasher Moduel, I forgot the proper term for it but I had to get mine replaced too. When I hit the signals to turn the side light would come on but the signal light wouldn't. Its a little box you get from Cadillac it only cost like $20 - $25 and you get it installed and trust. It'll work again. I just got mine done this week and my car now has turn signals again.
Posted on Dec 15, 2008
SOURCE: 1997 sonoma turn signal flasher
The flashers are located behind the instrument panel trim, roughly between the base of the steering wheel and the ashtray, just to the left of the car lighter. To access the flashers, you need to at least loosen the lower instrument panel trim. Just under the steering column there are two screws with star heads. One to the left of the column and one to the right. You need to remove both of these screws. You will need to remove your ashtray. On the upper left corner of the hole left by removing the ashtray is a 9/32 hex head screw. You need to remove it. Once these three screws are removed you should be able to pull down on this portion of trim under your instrument cluster. When you do this it may cause trim around your instrument cluster to loosen that you can just pop back into place with your hand. You won't need to pull down to far on this trim piece as there are still some screws holding the bottom. You should be able to pull it down far enough to see the flasher units behind and just to the left of the cigarette lighter. There are two flasher units and I found that the one on the right is for the turn signals.On the left the other is for the hazard flashers. It may be a hand scraping experience to replace the flasher but it beats paying someone to do it for you. They are easy to recognize because the are silver and round metallic plug ins. The flasher unit on the left is for the emergency flashers and the one on the right is for turn signals. You can place the emergency flasher unit into the slot the turn signal unit belongs until you get a replacement. These flasher units are pretty cheap.
Posted on Jun 02, 2009
there are two flasher for this car, one for the hazards and one for the turn signals, the turn signal flasher is located behind the center of the ashtray,the hazard light flasher is located on the fusebox center.this fuse center is located behind the right side of the dash to the right of the glove box, hope this helps.
Posted on Mar 01, 2010
Testimonial: "Thanks for the advise! The flasher was behind the ashtray to the right, just next to the glove compartment. It is just hanging there!"
On the 1993 Sedan de Ville, The hazard flasher is easy to locate, under the dash between the steering column and the radio. Looking up, you will see the smooth round side of the flasher and the wires will be attached to the top.
The turn signal flasher is more difficult to get to, but readily accessed with a T-15 torx driver and a little patience. It is located to the left of the steering column, but is most easily accessed through the dash panel instead of from underneath.
1. remove the T-15 screw from above the headlight switch, above the fuel data center, and above the small panel similar to the one around headlight switch. All of these are somewhat hidden, and you'll need to feel for them or get low and look up at them.
2. Using a bent piece of wire or an allen wrench, or anything else handy, pull off the small trim piece that is directly below the steering column. On my car, this is wood-grained plastic. This will expose two more screws that need to be removed.
3. Now, you should be able to remove the large dash trim panel that goes around the fuel data center.
4. Unscrew the two T-15 screws that hold the fuel data center into the dash, and it should pull straight forward. There should be plenty of wire to move it out of the way.
5. The turn signal flasher is the silver can that you see to the right in the opening you just created by removing the fuel data center module. It has a single plug with two conductors on the back. I had to use a small screwdriver to pry it off.
It is a different part number, so I don't know if you can just swap it for the hazard flasher to test it like you can on many cars. I just replaced mine with a Wagner 323, which is what came out of mine.
Posted on Apr 30, 2010
Tips for a great answer:
Feb 08, 2016 | Cars & Trucks
Feb 18, 2013 | 1998 Cadillac Eldorado
Nov 29, 2012 | Cars & Trucks
Jun 21, 2011 | 1997 Chevrolet Blazer
Jan 03, 2011 | 1997 Cadillac Eldorado
Sep 24, 2010 | 1995 Lincoln Town Car
Mar 13, 2010 | 1996 Lincoln Town Car
Mar 01, 2010 | 1996 Oldsmobile Cutlass Ciera
May 31, 2009 | 1996 Pontiac Grand Am
80 people viewed this question
Usually answered in minutes!