Question about GMC Yukon XL

Open Question

How to replace the brake pedal position sensor 2004 yukon xl

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: location of fuse box/panel for 2004 yukon denali xl

There are 2 fuse panels in the Denali.
One is a panel on the drivers side, its on the dash but facing the door.

The ohter is under the dash and above the pedals, this one is much tougher to access.

Your Owner's Manual should tell you where the fuses are that you need to access.

Posted on Oct 20, 2008

SOURCE: replace rear brake pads on 2001 yukon xl

First remove the cap off the master cylinder. Push in the piston on one caliper with a c clamp, or pry it back between the pad and rotor with a prybar. Then remove the 2 bolts on the caliper itself. Replace pads.Go to other side, repeat sequence

Posted on Dec 11, 2008

  • 1 Answer

SOURCE: I need to replace Accelerator Pedal position Sensor

there is two little nuts on the bottom of the pedal itself just loosen the nuts and it comes right off.

Posted on Apr 29, 2009

  • 1986 Answers

SOURCE: where are the oxygen sensors located?

There will be one located before, and one located after the catalytic converter for each exhaust that you have

Posted on Sep 10, 2009

  • 438 Answers

SOURCE: where is locate the knock sensor in 2004 yukon xl

There are 2 or them and they are under the intake manifold. The manifold has to be removed to replace them.

Posted on Oct 10, 2009

Testimonial: "TANK YOU +++++++++++++++++++++"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What tools do i need to change brake pads on 2005 yukon xl


Jack, wheel wrench, socket set, large screw driver, pair of pliers or grips. Lithium grease for the pins. Watch all of these videos. .spell{font-size:18px}.spell_orig{font-size:15px}#mss p{margin:0;padding-top:5px}




g-img{display:block}._WCg{display:block;border:0;position:relative} Search Results

    How To Install Replace Front Brake Pads 2000-06 Chevy ...

    9k=? 4:46 https://www.youtube.com/watch?v=nPohZtD8zlA May 27, 2014 - Uploaded by 1A Auto Parts http://www.1aauto.com/brake-pads/i/1abps00080 1A Auto shows you how to ... Front Brake Pads 2000-06 ...

    HOW TO INSTALL REPLACE GMC YUKON DENALI ...

    z? 14:10 https://www.youtube.com/watch?v=um7dt_yvZ1s Sep 20, 2012 - Uploaded by TheRykerDane Video on how to change the brake pads and rotors on a 2004 GMC Yukon Denali. Changing these parts ...

    How to REPLACE INSTALL BRAKES and ROTORS GMC ...

    2q==? 11:32 https://www.youtube.com/watch?v=UWqows3P4DE Feb 11, 2012 - Uploaded by TheRykerDane Video on how to change the brake pads and rotors on a 2004 GMC Yukon. Changing these parts ... Would ...

    GMC Denali Brake Pads Removal and Installation - YouTube

    z? 3:45 https://www.youtube.com/watch?v=uEKs8nphVxU Oct 24, 2012 - Uploaded by AnotherLookFilms Remove and Install rear brake pads on your 2006 GMC Denali XL. ... 9-21-13 2007 GMC Yukon rear brakes ...

    GMC Yukon Denali Front Disc Brake Pad Replacement ...

    2q==? 8:21 https://www.youtube.com/watch?v=w_gn_l5lYkw Jun 20, 2013 - Uploaded by AMS Automotive Watch the proper procedure for replacing front disc brake pads. Featured vehicle: 2007 GMC Yukon Denali ...





Jan 22, 2016 | Cars & Trucks

1 Answer

2007 Yukon XL - P01121 Throttle/Pedal Position Sensor A Circuit Range/Performance.


P1121 GMC - Throttle Position Sensor Circuit Intermittent High Voltage
This codes has nothing to do with APP - accelerator pedal position sensor . This has to do with the throttle body - TPS throttle position sensor . These have know problems ,the sensor an broken wire at throttle body , an when this happens the cruise control wont work . The throttle works by a DC motor controlled by the PCM - engine computer .

Dec 30, 2015 | Cars & Trucks

2 Answers

2004 Yukon XL in drive and will not shift


Is the selector stuck in drive? If so you might want to check the neutral switch which is on the steering column inside the truck. It sounds like you might have broken something in the switch. Hope this helps.

Jun 04, 2015 | 2004 GMC Yukon XL

1 Answer

REDUCED ENGINE POWER ON 2004 YUKON DENALI


throttle position sensor is prob. bad. unfortunately this mean replacing the throttle body

Dec 14, 2013 | 2006 GMC Yukon Xl Denali

1 Answer

2004 Yukon XL parking brake alarm and light still on even though brake is off. How do I fix this?


Well, at the brake arm, there is usually a switch around there, somewhere...disconnecting wires would tell if it is the culprit. Often other things use the same warining circuit, like fluid level....
It sometimes is as simple as the brake pedal is not being pulled far enough to hit it's stops... Brake inspection and adjustment is indicated if loosness is the case.

Sep 20, 2010 | 2003 GMC Yukon XL

1 Answer

Where is the throttle position sensor located on a 2001 gmc yukon


if you follow the air filter tube to where it meets the motor that is the throttle body it is mounted on the side of that opposite of the gas pedal cable.

Dec 27, 2009 | 2001 GMC Yukon XL

1 Answer

GMC Yukon - ABS light and parking brake light come on while driving but they will go out if the car is restarted. Could it be a sensor or ECBM?


try to pull up on your parking brake pedal with your hand when light comes on. if this makes it go out u will need to adjust the parking brake switch under the pedal. or replace pedal spring that holds it up.

Oct 02, 2009 | 2002 GMC Yukon XL

1 Answer

Where is the fuse box on a 2004 yukon xl denali


It is either under the driver side dash area between the brake pedal the door. Or under the hood near the left or right fender

Aug 03, 2009 | 2005 GMC Yukon Xl Denali

3 Answers

2005 Yukon XL, third brake light intermittent


Remove bulb, make sure it sits tight in the socket. make sure socket is not burnt up (brown or black in color) Check bulb, if the filament inside is loose or discolored, replace as nesessary. Check brake light switch under driver side dash above brake pedal. make sure it is adjusted correctly.

Jul 23, 2009 | 2005 GMC Yukon Xl Denali

2 Answers

I have a 04 yukon both front heated seats come on for 10-30 sec than go off both started at the same time so i dont think its in the seats its self (HEATING WIRES) any help would be great


See GM TSB 05-08-143-001, If you have Adjustable pedals, especially if they don't work with the memeory buttons, but function with thier own buttons. Its the Brake Pedal Position Sensor is shorted and messing up the seat module which controls the heaters too. My 05 Suburban had the same issue. Can check by unplugging sensor and see if heated seats work .

Mar 30, 2009 | 2001 GMC Yukon XL

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...