Question about 2004 Chevrolet Impala

1 Answer

Abs traction control light comes on and the car wants to stall

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 645 Answers

ABS & traction control are controlled by the ECU(engine control unit).It's all integrated by the CAN(Controller Area Network) bus.-----------------------------------------------------------------------------
Trucks & Heavy Duty Scan Tools

Posted on Dec 04, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: Traction Contrl and ABS Light on

No, it is probably not related. Usually the ABS and traction control light is either a wheel sensor problem, located in one of the wheel bearings, or most likely in the wire harness from the wheel bearing sensor. Remove wires and spray clean with a good solvent electric spray, and check the condition of the receptacle. I have had these problems with my 02 AWD so many times it has become almost routine. GM really have a problem with this type of speed sensor in the wheel bearings. In the AWD model, it keeps the car in FWD if the ABS light is on for any reason. JUNK!

Posted on Nov 27, 2008

  • 56 Answers

SOURCE: traction system light and abs light come on at same time

You still have issues with the speed sensors. The wires that connect to the hubs are known for failure.

Posted on Feb 13, 2009

  • 33 Answers

SOURCE: 2005 Impala abs & traction control problem

it will be right tront hub assembly pplug bad or or hub itself

Posted on Mar 24, 2009

  • 1 Answer

SOURCE: Service Active Handling, ABS and Traction Control Lights on

I have had exactly the same problem on and off for 3 years now - and just solved it last week thanks to another computer site. Remove and disassemble both grounds from the top of both the left and right frame rails adjacent to the front corners of the engine block. Completely clean the green corrosion from the internal parts with fine sandpaper and add dielectric grease then re-assemble. Clean the mounting bolt and frame hole while you're at it. Sounds time consuming and difficult, but it ain't. No more than 45 minutes combined. I am a technical airhead so if I can do it so can you. What clued me in was the problem always occurred around wet or humid weather. Also, the clock would always lose time overnite. That has ceased also. Good luck. Anyone know why my left headlite, when deployed, vibrates and shimmys??? Sully ptsully@roadrunner.com

Posted on Jul 07, 2009

daves944
  • 1050 Answers

SOURCE: 2005 impala ls the abs light and the traction control light comes

You'll need to have the codes read from the computer. You will have a code that indicates one of the front wheel sensors is bad. This could be the case, but they are very expensive as they are built into the wheel bearing assemblies. It is more likely that the wiring harness between the frame and the part of the front spindle that holds the harness, has broken internally. It is a very common problem and can be repaired with a new wiring harness section or by tracking down the fault and repairing it.

Posted on May 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Traction control and abs warning light comes on,how do I fix??


the ABS system is defective, probably one or more of the sensors.

Traction control system works with the ABS sensors to monitor to monitor traction slippage.

Jul 20, 2014 | 2001 Chevrolet Impala

1 Answer

My abs and traction control light is on at the same time


You would need to get the body computer scanned for trouble codes to proceed with testing.
When there is a problem with the abs system, the computer will disable the traction control too since it uses the abs system to function.

Mar 08, 2013 | Cars & Trucks

1 Answer

2008 ford escape abs and traction control light is on, if the car sets over night the traction control light and abs lite doesn't come on until a few minutes and after the car sits around awhile the...


2008 Escape has a terrible reputation for ABS light and traction control light being. All due to broken ABS tone ring cracked and out of position flopping on frt bearing. Go to local AutoZone store and they will scan this to find which wheel has the broken tone ring. The replacement ring is cheap in the $7 range. It is labor that will sicken you as this ring must be pressed on after the front half shaft is removed. Not a driveway job if you are considering DYI.

Jun 21, 2011 | Ford Escape Cars & Trucks

3 Answers

Traction control and anti-locks(ABS) lights come on.


Traction control and anti-locks(ABS) lights come on there is sensors that are pluged in behind the rotors check and see if they are disconected or loose sometimes when you change your brake pads they might come loose and not making contact.

Jul 06, 2010 | 1998 Cadillac DeVille

1 Answer

Brake peddle is chattering 2003 ion and would like to pull the anti lock brake fuse (if safe ) until i can afford the repair. I would like to know witch fuse to pull?ABS is on and traction control


If brake pedal is chattering or pulsating it is most likely because you need either front or rear rotors, or both. They are rusted or out of round. If there is something wrong with either your abs or traction control,the abs or traction control light will come on & stay on. As soon as these lights come on, it automatically disables abs or traction control. If you would like to take out fuse that disables abs or traction control circuits, it will leave the lights on.You just wont have their functions. If by some strange condition your chattering goes away, then there is indeed something wrong with your abs or traction control.Fuses are labeled abs or traction either under hood or in your fuse panel in car.

Jun 13, 2010 | 2003 Saturn ION

1 Answer

Traction control indicator that traction is off


have the calipers and brake system checked, as for traction control is ran by abs system

Apr 13, 2010 | 2002 Chevrolet Impala

1 Answer

2001 jaguar s type. Traction controll fault light came on. 5 minutes later brake light comes on and at the same time abs light comes on. What could my problem be?


your traction control mechanism uses the abs breaks to slow the spinning and give you better traction. i'm thinking your traction control sensor has gone bad

Mar 15, 2010 | 2001 Jaguar S-Type

2 Answers

ABS/traction control 1998 lincoln towncar


sounds like the brake pads may be metal to metal, that could be the noise problem, but until u have the system tested for the trouble code that is setin the ABS modules memory when the light comes on you are guessing, the Dealer is the only one in most cases that has the scan tool to check ABS trouble codes.

May 13, 2009 | 1998 Lincoln Town Car

1 Answer

Lincoln ls year 2000 v8 3.9litres


ABS and traction control really are only for panic stops and if your tires slip on wet surface's and yes each tire has a sensor on it. However if the brake light comes on this has nothing to do with the ABS or traction control lights. It's not a parking brake light. This light tells you, you have a serious brake problem.

May 13, 2009 | 2002 Lincoln LS

1 Answer

2001 olds ABS and traction control sensor issue


An ABS sensor DOES affect the traction control system. Traction control uses these sensors to determine if a wheel is losing traction. A bad sensor will cause both the ABS and TRACTION lights to come on.
The CHECK ENGINE light however is going to be a seperate problem.

Jun 08, 2008 | 1999 Mazda Pickup

Not finding what you are looking for?
2004 Chevrolet Impala Logo

160 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...