Question about 2006 Ford Explorer

Open Question

2006 ford explorer dome light stays on - 2006 Ford Explorer

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
emissionwiz
  • 76164 Answers

SOURCE: 2006 Ford Explorer "Oil Change Required" light is still on after changing the oil

IF YOU FIND THIS INFO USEFUL PLEASE RATE ME AS A FIXYA! THANKS

Oil Change Reset
A press of the OIL CHANGE RESET switch will allow you to
reset the oil life feature to 100% (or your Personalized Oil Reset
Percentage). After you have the oil changed, you must execute
the following procedure. Press the OIL CHANGE RESET switch
and hold for five seconds as the M/C counts down for five
seconds. After a successful reset the Message Center will display
“OIL LIFE RESET TO 100%.” If you have established a
Personalized Oil Reset Percentage, the display will show that
percentage instead of 100%. To ensure accurate oil life
indicators, perform this reset procedure only after an oil change.
Your Personalized Oil Reset Percentage allows you to establish a
smaller oil change interval than the manufacturer’s
recommended interval. To establish your Personalized Oil Reset
Percentage perform the following procedure:
1. Press and hold the OIL CHANGE RESET switch and press
the RESET switch while the display is still counting down
the 5 seconds to reset. The display will change to “START
OIL LIFE AT XXX%.”
2. Press the OIL CHANGE RESET switch until the displayed
percentage is the Personalized Oil Reset Percentage that you
desire. Your choices are 100%, 90%, 80%, 70%, 60%, 50%,
40% and 30%.

Posted on Oct 15, 2008

Ad
dgjtex
  • 405 Answers

SOURCE: Ford taurus door ajar light stays on

have you had the door panel apart before for anything, the switch is on your latch inside your door. I hope this helps you. I am just trying to be helpful, and will help you all the way through your repair if you like, My compensation is my rating. please be generous..lol

Posted on Dec 19, 2008

  • 1 Answer

SOURCE: GEAR SHIFT INDICATOR LIGHT 2006 FORD EXPLORER

I had the same problem. They need to change the whole shift indicator assembly. Had mine fixed inn 30 minutes

Posted on Feb 08, 2009

chuck943
  • 783 Answers

SOURCE: 2009 ford focus dome light stays on

Are you sure that the thumb wheel switch beside the headlamp switch is not turned all the way up until it clicks?
If it is staying on for 10 minutes this means that the smart junction box is seeing a demand for the interior lights from something like a door ajar switch or the thumb wheel. If it sees that the igntion is in the off position it will turn the lights off after 10 minutes to conserve battery power.
Normal operation is:
The interior lighting delay feature provides temporary illumination of the courtesy lamps after the doors are opened and then closed. The interior lighting delay feature keeps the courtesy lamps on for a period of 25 seconds after all the doors are closed. If during the 25-second delay time the SJB detects that the ignition has been switched out of off, or if the vehicle is locked using the RKE, the courtesy lamp illumination is discontinued

Posted on Mar 24, 2009

  • 85 Answers

SOURCE: door ajar light stays on and interior dome light

spray the door latches with a good penatrateing oil slam the doors sevral times thier is a switch in the latch that sticks

Posted on Dec 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

My dome light will not go out.


Check the light switch if it's off position for dome light. Or check your door switch if is making contact with door panel. If all of this are good. You have an bad door switch.

Jan 02, 2015 | 2006 Ford Escape XLS

1 Answer

Light won't turn off when door is closed on 2003 ford explorer


2 things to look for. the switch on the dome light itself and the door switches. These switches make a ground connection so the bulb will light. The dome light switch may be faulty allowing current to flow all the time. The door switches do the same with one exception. The wire going to each door switch can become pinched or come in contact with a sharp body part causing the dome light to stay on. Check the obvious first before you start tearing the interior panels apart.

Jul 14, 2014 | 2003 Ford Explorer

1 Answer

My dome light on my 2006 Ford fusion stays on for 11 mins straight how can I fix it


Hi.. On your Fusion the dome light will stay on
If the Body cumputer detect any door open,
This happen when the Door Ajar Switch when bad.
The Body computer Don't receive the signal of the switch.
After 11 Minutes The Body will turn off the Light .
With a system Called Battery Saver.
The Alarm system will not work right.
I recomend Try to do Computer Diagnostic.
To find wich Ajar switch is bad and have replace it
I hope this help on your question.

Thank you for use Fixya. Feel fre to ask anything..

May 17, 2012 | 2006 Ford Fusion

1 Answer

2003 ford explorer driver side door opens and closes by itself and interior lights stay on while driving


The opening and closing by itself is either the door being out of alignment or the Door pin being worn and in need of replacement. As far as the interior lights staying on, look for the brightness control for the dashboard lights. If that is turned all the way to the brightest setting there is a position just past that which turns the interior lights on continuous. Make sure it is not in that position. If it is not in that position and the lights are staying on with all doors closed, to include the rears, and you have checked the switch on the dome light itself to make sure it isn't set to ON, then the problem is a switch in one of the door jams being grounded or a wire was tapped into the power circuit for the dome light that has grounded. This happens when the LoJack installer or Alarm installer makes the mistake of tapping the light circuit for power.

Sep 30, 2011 | 2003 Ford Explorer

1 Answer

DASH LIGHTS DO NOT WORK AND THE DOME LIGHT STAYS ON


Do you have an owners manual? I had a similar problem with a Ford, turned out that the dome stayed on until the bad fuse was replaced. Sort of a "safety" feature you know that you have fuse blown in some other area. Owners manual should show location of fuse.

Hope this helps

Mar 07, 2011 | 1999 Ford Explorer

1 Answer

04 EXPLORER DOME LIGHT STAYS ON, DOOR ADJAR LIGHT ON, DOOR JAMB SWITCHES WORKING PROPERLY.


At least one of your door ajar switches are sticking. Try spraying rust penetrant into the latches and open and close the doors several times. If they still stay on you will have to locate which latch it is by removing the door panels and disconnecting the switches.

Feb 24, 2010 | 2004 Ford Explorer

1 Answer

The dome light on my ford expedition stays on


Check owners manual on dome light operation - if that doesn't work, check for a bad door switch...take the switch out and Ohm across the contacts (if the switch reads zero Ohms with the switch depressed...then the switch is bad - should read infinite with the switch depressed).

Nov 30, 2009 | 2006 Ford Expedition

1 Answer

Dome lights won't shut off


Have you checked the dimmer knob for the dashboard lights? If the 2006 Fords are like my (a bit older) Fords, then turning the dashboard lights to the brightest setting will turn on the dome light. Just turn the knob a bit to the left and the dome lights should turn off.

Nov 28, 2009 | 2006 Ford Excursion

1 Answer

Interior dome light stays on while driving


Your dome light switch in in front of the driver's seat where the headlights are. It is possible that switch is bad as it should be both a turn knob switch, and by pulling on it, it becomes a head light switch. You may have to replace it.

Dec 21, 2008 | 2006 Ford Mustang

Not finding what you are looking for?
2006 Ford Explorer Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76132 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5520 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...