Question about 1998 Chevrolet C/K 3500

1 Answer

Fuse where is the fuse located for a brake light in a chevy1998 a g 3500

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 24 Answers

That should be located in the fuse box under the dash board. I have the same problem in my car.

Posted on Jan 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the #24 fuse located at for the third brake light


Year/make/model didn't post. The high mount brake light is not fused seperately. It should be on the same fuse as the brake lights. If it is not working check for a bad bulb. If the assembly is LED, check for power and ground at connector to light. If power and ground ok, suspect defective LED assembly

Feb 12, 2016 | Cars & Trucks

Tip

Brake Lights Not Working


Check System Fuse: A fuse is used to protect the brake light circuit from amperage overload. If the fuse has failed it will not allow the electrical current to continue to the brake lights. To check the fuse, first locate the brake light system fuse in the fuse panel which is either under the dash or under the hood in the power distribution center. Connect the test light to a ground like an engine or dash bracket and turn the ignition key to the "on" position. Using the test light probe both sides of the fuse. If the test light illuminates on both sides the fuse is ok continue onto the next step. If one side of the fuse illuminates the fuse has failed and needs to be replaced. If the fuse fails as soon as it is replaced or when you apply the brake pedal the brake light electrical circuit is shorted to ground. Rarely a system short can occur, a car repair manual is needed to find the wiring schematic for the brake light circuit. Once the brake light wiring has been located inspect and repair as needed.

on Dec 18, 2009 | Honda Civic Cars & Trucks

1 Answer

Where is the fuse for brake lights on 1999 camry


There's two fuse box locations..in the engine compartment and inside along the bottom or side of the dashboard..but I'm willing to bet it's your brake light switch..which is located behind your brake pedal..if the fuse isn't blown it's the brake switch..also referred as the neutral safety switch..

Mar 31, 2013 | Cars & Trucks

1 Answer

Whetes the brake light fuse on 92 lincoln


The brake light fuse for this 1992 Lincoln continental is located in the fuse box located on the driver side of the dash.You will need to look under the dash on driver side. i have enclosed a picture diagram of the fuse box and i have circled the brake light fuse.This fuse is in slot location # 1 and uses a 15 amp fuse. hope this is helpful. any other problems let me know, good day.4_29_2012_9_00_43_pm.gif

Apr 29, 2012 | 1992 Lincoln Continental

1 Answer

Brake light s not working but third light does. and flashers work


Does the 3rd brake light turn off & on with the stomp of the brake pedal?Do the normal running light work?Their is more then one location for fuses for this vehicle.. did you check them all?One is located in the engine compartment far as I know it does not have a separate fuse for rear brake lights.The second one is of course under the dash.The thrid is a rear power distribution box located near the spare tire... btw other fuses could cause this issue like towing light fuse possibly.. so make sure you check them all. Of course start with brake lights first.

Nov 22, 2011 | 2001 Lincoln LS

1 Answer

Brake light fuse location


the brake light fuse should be in the fuse box under the hood,but you might find a small fuse box under the dash as well.....hope this helps.....cheers

Jul 28, 2010 | 2002 Chevrolet Silverado 1500HD

1 Answer

I need brake light troubleshooting tips for 1993 940 Volvo turbo


the BOO switch, (Brake On Off) located on or near the brake pedal

Apr 29, 2010 | 1993 Volvo 940

2 Answers

Break lights dont work, I replace the lights how do you replace the break fuse what should I look for?


Bulbs are just like a fuse to for they blow out like a fuse. You have a brake light switch mounted near the brake pedal. Check that switch out with a OHM meter. Just unplug the switch and feed the Ohm meters contacts into the switch. Then push the brake pedal down to see if it completes the circuit. If a OL reading is showing at all times the switch is bad and needs to be replaced

Apr 29, 2010 | 2006 Chevrolet Colorado

2 Answers

Brake lights not working


Having the sa but haven't replaces the brake switch. The owner's manual for my 99 accord indicates the the fuse is located behind a panel that is viewable when you open the door on the driver's side. There is a panel that you remove (pull off) to expose the fuses. The brake light fuse is the third one from the top on the left. 7.5 A

May 22, 2009 | 1999 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

98 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

60960 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6812 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...