Question about Ford E-350

2 Answers

No tail lights

My problem is my turn signals, brake lights and backup lights all work but my tail lights don't. all fuses are good and so are the bulbs. Is there a relay and if so where is it located.

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 3,533 Answers

Check to make sure they are grounded especially if you just recently hooked up a trailer or hitch but if you think it maybe a relay those are normally in a small box under the hood also take a 12volt tester and take the lens off and see if you have power going to the sockets

Posted on Jan 11, 2009

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Where is the relay on dodge ram 1986? My break lights, alternator and dash board is not working

Posted on Mar 15, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace multi-function switch 2005 mariner


The tail light is usually a bulb with lower wattage, so it won't glow as brightly as the brake and turn lights.. There should be one or two other bulbs in either of the two tail assy's. The turn signal can use the same bulb as the brake light. If so, it's up to the flasher assy to direct the lights to both come on, and/or for one to flash if the brake and turn signal is on, e.g.. There could also be a backup light.

So if the brake and turn lights don't operate, look to the fuses, and flasher assy. for possible replacement.

Jun 01, 2015 | 2005 Mercury Mariner Premier

1 Answer

2005 chevrolet aveo brake lights work but tail lights don't


check them all since most fuseblocks are numbered now.. then move to the fuseable link wires near the battery.. then go to light relays..

Dec 26, 2013 | Cars & Trucks

1 Answer

Brake and tailgate sometimes works


Since tail lights are not part of the brake switch, I wouldn't think so. This sounds more like a bad fuse or some other fault. Do either of the turn signals work? Are the turn signals a part of the brake lights or are they independent?

Jul 07, 2013 | 1993 Jeep Grand Cherokee

1 Answer

My tail lights don't work but brake lights do, what's the problem?


Check your fuses to make sure they are OK. Your turn signal is on a different circuit than the tail lights. I think.

Apr 13, 2013 | 2003 Nissan 350Z

2 Answers

I have 89 bronco 2 my brake lights turn signals both work my tail lights don't work have check fuse n blubs what might be the problem


The turn signals and brake lights use the same circuit and filament in the bulbs. The tail lights are on the other circuit which comes from the headlight switch.
Do you have power on the tail light fuse ?

Feb 25, 2013 | 1987 Ford Bronco II

1 Answer

No turn signals,brake lights. have tails lights. all fuses in fuse box under check out ok


The turn signals and the brake lights go through the hazard switch. Try cycling it a few times and see if that solves the problem. If the fuses are good and the 4way's don't work, I would suspect that switch.

Sep 21, 2011 | 1994 GMC Suburban

2 Answers

I have a 2000 chevy 2500 and the tail lights, tag lights and brake lights have stopped working, I checked the bulbs and they are good, fuses are good. Have not replaced the brake relay under the hood. Do I...


check for power at the wires going intop the tail lights, real common that the circuit board is bad, but unlikely both at the same time. The tag, tail lights and brakes are 2 different systems. Do the turn signals work normally? if so the wiring from the turn signal switch to the brake lights is GOOD. the stop light switch had\s a ORANGE wire that should have 12V if not ck STOP LPS fuse, when brake pedal is depressed, the WHITE wire is 12V (at the stop light switch) if that is OK, the turn signal switch COULD be bad. The wiring harness plug is near the back left under the tailgate, see if that is disconnected?

Aug 04, 2011 | 1999 Chevrolet K2500

3 Answers

Tail lights and brake lights are combined. I have tail lights but no brake lights. fuses look good.


No they are different systems going to the same place, the tail lights use one fillament in the bulb and the brake and turn signal use the other, a couple things to check, brake light fuse, brake switch (located on the brake peddle) check for power, I have also run into the 4 way flasher that were the problem, more than likely the brake switch

Apr 14, 2011 | 1997 Chrysler Sebring

1 Answer

Hell i just bought a chevy cavlier and my back break light is out...the light its self is on...its just the break light when pressed...


you don`t say if its both or just one brake light out.you say the light itself is on but not if you mean tail light or what.the tail lights use a different filament in the bulb than the signal light which is the same filament that the brake light uses.if the signal light work on the rear then the bulbs are good,if just one side works then the bulb is no good on the side that doesn`t work.if the signal lights work but neither brake light works then you need to check the fuses in the fuse panel under the dash on the drivers side.if the fuses are good then it will be either a bad wire at the brake switch or a bad brake light switch,this is located on the brake pedal lever under the dash.

Mar 18, 2011 | 1999 Chevrolet Cavalier

1 Answer

Left side brake and hazard lights don"t work


sounds like a bad turn signal switch, wiggle it , just a little bit,... see if some of the lights start to work. do your turn lights work correctly??

Dec 02, 2008 | 2000 Chevrolet Lumina

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

312 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

70387 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22041 Answers

Ron Lankford

Level 3 Expert

5386 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...