Question about Cars & Trucks

1 Answer

2000 Dodge caravan, the body-colored, plastic gas cap cover broke off. Now what? looks like hell

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Cars & Trucks Master
  • 2,030 Answers

You will have to get a new gas door and have it installed by a mechanic or body shop

Posted on Dec 03, 2012

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
INSIGHTAEM
  • 1 Answer

SOURCE: starter for dodge caravan 2000

DISCONNECT THE BATTERY, JACK UP AND SUPPORT YOUR CARAVAN. LYING ON YOUR BACK LOCATE THE STARTER WHICH IS ATTACHED TO THE ENGINE THROUGH THE BELL HOUSING .THERE ARE TWO 15 MILIMETER BOLTS THAT HOLDS THE STARTER ON . AFTER BREAKING THE BOLTS A 15MM WRENCH WOULD BE USEFUL.

Posted on May 30, 2008

SOURCE: Wet floorboard

DO NOT REMOVE TUBE CLEAN IT OUT

Posted on Nov 03, 2008

  • 548 Answers

SOURCE: replace broken fuel door 2000 dodge caravan

If you're on the smallish side and pretty limber, you might avoid removing the rear wheel. If not, you will likely need to remove the rear wheel and put the van on jack stands securely. I would remove the underside splash shield and gain access from underneath. It looks like you will need to unscrew the plastic insert that surrounds the filler neck inside the area that is exposed when you open the fuel door. Make sure you get the vent hooked up correctly when you are done.

Posted on Jan 31, 2009

  • 3 Answers

SOURCE: HOW TO REMOVE 2000 DODGE CARAVAN REAR SEAT

There are 2 handles on the back of the seat where it attaches to the floor. If you hold the button on the handle and push it down it should release the seat from the floor. After this it just rolls out the back. Same for the middle seat if you need to remove it.

Posted on Mar 08, 2009

  • 373 Answers

SOURCE: timing marks for the Dodge 2.4L caravan, 2000

To align both sets of timing marks, turn engine crankshaft to the right with belt on cam and crank. Once you have done this the crankshaft alignment mark (on front of crankshaft gear) will line up with mark to the rear of gear on engine block.The two cam gear timing marks should be alines across from one another. The right cam gear is the intake side and the left side is the exhaust side. After removing the belt turn the exhaust cam down 1/2 notch. Timing mark on exhaust 1/2 notch down from the intake side. Install new belt and recheck everything to make sure it's all correct. Hope this will help you.

Posted on May 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Broke gas cap cover


ok and what is your ?

Dec 03, 2012 | 2000 Dodge Caravan

2 Answers

Where is the oil cap on a 1999 Dodge Caravan?


The oil cap depending on what motor you have is on top of the valve cover or on top of an extension tube along side the valve cover and it will look like the picture below, might be black in color. these simply unscrew to remove.
Here is a short video and there are more on this page to help you. If this was helpful a vote on the thumbs up would be greatly appreciated for the free advice. Thanks for using Fix Ya

http://www.ehow.com/video_4949202_oil-change-remove-oil-cap.html
dcramer531_134.jpg

Aug 17, 2011 | 1999 Dodge Caravan

1 Answer

How do I change the drivers side front turn signal bulb on my 2000 Grand Caravan?


There are bolts under the hood on top of the plastic housing. If you look at the light cover you can see where it connects to the body. Either the bulb twists into the housing and all you have to do is twist it out (to the left or right) or you have to unscrew the housing pull it off and change the bulb then put the housing back on. Hope this helps, James Booth. PLEASE RATE THIS!!! :))



May 20, 2011 | 2000 Dodge Grand Caravan

2 Answers

Rear windshield wiper does not cover the intended area how to remove rear windshield wiper arm


IF YOU HAVE A PLASTIC CAP ON ARM REMOVE IT AND THE NUT UNDER IT, AND LIFT WIPER ARM OFF.

Jan 02, 2011 | 2000 Dodge Caravan

1 Answer

Gas cap warning light is on. Gas cap is tight.


If the cap is tight then you need to replace the fuel cap. the light will go off when cap is replaced

Jul 13, 2010 | 2000 Dodge Caravan

1 Answer

Need to know which relay fuse (under hood) belongs to air conditioner on 2000 dodge caravan & where is the relay box


the relay box is on the driver side, next to the battery. remove cover to find fuses and relay. it's on the bottom right if you look at it from the driver side fender. in the cap, you should find the diagram of the location of every fuse/relay located in there.

Jul 02, 2010 | 2000 Dodge Caravan

1 Answer

Computer Diagnostics code of P0456


i only have a listing for codes p0455 and p0460. i am thinking it is a p0455 witch is common and is a evap leak (large). this system is a ventilation of the gas tank and when a leak is detected it wiil set this code. most of the time it is due to the car being filled up with gas while running. also causes are a faulty gas cap seal (new gas cap). or a vacume line that is broke , off or cracked. good luck.

Mar 23, 2010 | 2000 Dodge Grand Caravan

1 Answer

My 2000 ford taurs engine check light is on with an emmission code p1405 what should i be checking?


Check vacuum lines running to the valve covers the rubber end sometimes get holes and have to be replaced. One on the front and one on the back valve cover. Also check the pvc valve tube running under the throttle body same thing the rubber connector gets a hole in it. One more thing check the gas filler neck when you take off the gas cap look for hair line cracks in the plastic coating thats on the inside at the top its gray in color.

Mar 14, 2010 | 2000 Ford Taurus

3 Answers

I have a 2000 dodge caravan 3.8l engine,the air bag light stays on and the horn won't work.


o'clock spring in steering calume and sloud be cover under warrenty

Nov 05, 2009 | 2000 Dodge Caravan

1 Answer

The latch broke on my 2000 dodge caravan hatch,


I assume you are talking about the rear door. When mine broke and wouldn't open, I unscrewed the plastic panel on the inside with a phillips screwdriver and opened the latch by hand. Then I changed it. There should be little round plastic covers that go over the screws. Rick

Apr 07, 2009 | 2000 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...