Question about 2000 Dodge Caravan

1 Answer

Broke gas cap cover

Body colored plastic gas cap cover broke off

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Dodge Master
  • 2,030 Answers

Ok and what is your ?

Posted on Dec 03, 2012


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Signal light question: if unit damaged, will it work with a bulb change? '94 Honda Del Sol.

Most likely the impact of the collision has broken the globe filament. I had many years ago the whole back of one of my vehicles smashed in with missing smashed broken covers on the brake and signal lights. I replaced the globes and used cellophane and gaffa tape as it had to show the correct color until I could get the back of the car fixed.
You could use clear or correctly colored cellophane if the signal cover is missing and use gaff tape or packing tape - taped at the edges on to the car body to seal it until you can get it fixed to protect it from water ..

Apr 25, 2017 | Honda Cars & Trucks

2 Answers

2008 Toyota Camry gas-cap door release is stuck; how do you release it?

Hi fellow,
Your problem has two options ;first, you have to inspect the interior wire that pulls the lock of the gas cap.If found cut you should replace it at the mechanic's. Secondly, once the wire remains uncut or undamaged by any reason, the lock itself might be jammed due to the rust or misuse. Therefore, you are advised to use some anti rust liquid it wil work. Good Luck.

Jun 09, 2014 | 2008 Toyota Camry

1 Answer

2000 Dodge caravan, the body-colored, plastic gas cap cover broke off. Now what? looks like hell

you will have to get a new gas door and have it installed by a mechanic or body shop

Dec 03, 2012 | Cars & Trucks

1 Answer

"05 Nissan Pathfinder PO455 EVAP

If those are fuel lines then fuel would be coming out. There are lines that carry fuel vapor for the EVAP system. If these lines you are looking at are the EVAP lines (sounds like they are) then this would be the cause of the large EVAP leak.

Aug 31, 2011 | 2005 Nissan Pathfinder

1 Answer

My gas pedal is sticking on my 2002 buick lesabre

Remove the plastic shroud which covers the engine. This can easily be done by unscrewing the oil fill spout (the 3-inch extension onto which the oil filler cap fits) by unscrewing it a half turn and lifting it out. This exposes the fuel injector body and mechanism.

Remove the rubber boot between the air box and the fuel injector body, then locate the "screen" which covers the intake. The screen should be held on by a "C" shaped ring, remove this then work the screen out. It's a little tricky to get out but it's not impossible. Spray some WD-40 (or other lubricant) on the butterfly shaft bushings and this should fix your problem.

May 19, 2011 | Buick LeSabre Cars & Trucks

1 Answer

Where is the port to install a.c.gas

Well, on the left side of the engine compartment. It will be covered by a plastic cap usually light blue or black in color. The coupling on your refill kit will only fit the Low Pressure side, the high and low are different sizes.

Jul 05, 2010 | 2001 Ford Focus

1 Answer

My 2000 ford taurs engine check light is on with an emmission code p1405 what should i be checking?

Check vacuum lines running to the valve covers the rubber end sometimes get holes and have to be replaced. One on the front and one on the back valve cover. Also check the pvc valve tube running under the throttle body same thing the rubber connector gets a hole in it. One more thing check the gas filler neck when you take off the gas cap look for hair line cracks in the plastic coating thats on the inside at the top its gray in color.

Mar 14, 2010 | 2000 Ford Taurus

2 Answers

Would like to install locking gas cap cover on 08 Wrangler. How does original come off? Don't want to force anything until I'm sure. Thanks.

Does your Wrangler have a cap that is attached with a tether (chain, or plastic cord to prevent loss of cap?) If so, just cut it to remove the cap. Stant makes a locking cap for an 08 Wrangler, available online or in stores.

Jul 11, 2009 | 2008 Jeep Wrangler

1 Answer

Driver power seat

Yes, that piece is called the "recline cover". You will need the trim color code from the vehicle identification plate on the inside driver's door frame to match the trim plastic color. This is going to be a dealer part or perhaps an ebay part but make sure the trim color is a match.

Apr 30, 2009 | 2004 Honda Odyssey

1 Answer

How to remove broken gas cap cover lid

yes the boot and liner must be removed to gain access to a hidded bolt

Apr 16, 2009 | 2002 Jaguar X-Type

Not finding what you are looking for?
2000 Dodge Caravan Logo

Related Topics:

46 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides