Question about 2006 Ford Escape

Open Question

How to replace cruise control switch ford escape 2006

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: cruise control won't work

Does the on light in the dash come on? If not, you may have a broken switch in the steering wheel which is a fairly cheap repair. Otherwise, the controls work through the Printed Circuit Board in your dash (your instrument cluster) and the problem could be as simple as a solder defect or faulty component. The problem is that no Ford Service Technician that I know will touch this and tell you that you need to replace it.

The instrument cluster is very easy to replace but may cost you a few more dollars than you want to spend. I would have someone with an electrical background check the cruise control switches in your steering wheel with a multimeter before going any further with this. Also check the wiring for resistance leading from the switch to the cluster.

Posted on Aug 06, 2008

  • 1 Answer

SOURCE: cruise control

I had the same problem on mine - just check the end of the cruise control cable under the big plastic cover of the engine. good luck!

Posted on Mar 26, 2009

  • 27 Answers

SOURCE: My 2002 Ford Escape's cruise control won't work.

check for the presents of a switch on the tip of the master cylinder. these switches are problematic. if no switch on master cylinder, switch will be on brake pedal above brake switch, this switch is plastic and breaks very easy

Posted on Aug 15, 2009

dnewcombe1
  • 1564 Answers

SOURCE: How to replace cruise control switches on 98 ...

More likley you want to have the transducer or the electronic equivalent checked first. The actual lever and controls rarely malfunction. However if someone has indeed pulled the lever out, it should snap back into place with a slight inward push towards the steering column. Best of luck, Dana

Posted on Aug 28, 2009

  • 1 Answer

SOURCE: cruise control will not engage

pull the plastic cover off the top of the engine and check where the cable from the cruise control connects by the throttle body. There is a plastic connector that might be broken. i had the same problem and a piece of tape fixed it for me but you can replace the part if your picky.

Posted on Sep 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuse for cruise control in 2012 ford escape


There isn't one. The cruise control is a module/computer which is controlled by the ECM. This one has to go on a scanner to see what's wrong. Code readers don't read the cruise.

Jan 14, 2015 | 2012 Ford Escape

1 Answer

Faulty Deactivation Switch for Cruise Control


No coincidence Pal. That cutout switch is part of the brake light switch and is easy to replace. It just screws into a bracket at the brake pedal lever and has a jamb nut on it to lock in position. Just get one from a parts store and replace it yourself.

Jul 02, 2017 | 2002 Ford Escape

1 Answer

I have a 2005 Ford escape replaced the booster now the cruise control does not work but the fuse is fine??


check to see if you knocked off the vacuum line to the cruise control servo while doing the booster

May 07, 2011 | 2005 Ford Escape

1 Answer

When I try to set the cruise control, the speed does not "hold."


if the cruise control is on a lever off the side of the steering column it is most probably the lever assembly that is the problem, I had the same problem on my car only a month ago and I replaced the whole switch lever and my cruise control works fine now

Jun 19, 2010 | 2004 Ford Escape

1 Answer

Replace on/off cruise control switch on a 2005 Escape


If it's located in the shifter handle it just pops out. carefully pry off the cover then you can access the switch

Jun 17, 2010 | 2003 Ford Escape

2 Answers

Cruise control ford escape 2002. ford escape


If the cruise lamp comes on and the cruise does not set i would advise inspecting the cruise cable and make certain it is not broken, if ok the the servo has likely failed.

May 29, 2010 | 2001 Ford Escape

1 Answer

Cruise control will not engage


pull the plastic cover off the top of the engine and check where the cable from the cruise control connects by the throttle body. There is a plastic connector that might be broken. i had the same problem and a piece of tape fixed it for me but you can replace the part if your picky.

Sep 25, 2009 | 2001 Ford Escape

2 Answers

Ford freestar having cruise control and transmission problems


found the brake petel switch sticky and tapping the pettel a couple of times allowed the cruis light to stay lighted and it worked on mu 2006 freestar.

Feb 16, 2009 | 2006 Ford Freestar

1 Answer

I need to replace the crusie control buttons


disconnect batt.wait 5 minutes,push brake several times,locate airbag fuse and remove.this is improtant as you will have to remove drivers airbag.there are 2 round plastic caps covering the 2 airbag bolts located at back of steering wheel by the cruise switches.remove caps remove the 2 8mm bolts.remove airbag,set airbag away from you with plastic cover of airbag up.replace switches.reinstall airbag,reinstall fuse.reconnect batt.

Oct 06, 2008 | 2006 Ford Escape

2 Answers

Cruise control won't work


Does the on light in the dash come on? If not, you may have a broken switch in the steering wheel which is a fairly cheap repair. Otherwise, the controls work through the Printed Circuit Board in your dash (your instrument cluster) and the problem could be as simple as a solder defect or faulty component. The problem is that no Ford Service Technician that I know will touch this and tell you that you need to replace it.

The instrument cluster is very easy to replace but may cost you a few more dollars than you want to spend. I would have someone with an electrical background check the cruise control switches in your steering wheel with a multimeter before going any further with this. Also check the wiring for resistance leading from the switch to the cluster.

Aug 06, 2008 | 2002 Ford Escape

Not finding what you are looking for?
2006 Ford Escape Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5481 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...