Question about 2003 Honda Pilot

1 Answer

Low beam headlights not working. High beams working. Fuses are OK

Any thoughts?

Posted by on

  • 1 more comment 
  • mbgbradley Feb 08, 2009

    This has happened to me 3 times now. I think the Honda Pilot 2003 may have electrical problems since I also have issues with a buzzing rear speaker and headphone jacks every once and a while. And help would be appreciated.
    Thanks

  • 2006168 Feb 19, 2009

    I have lost voltage to both low beam headlights. The high beams are both working. I have checked the fuses.

  • Anonymous Mar 30, 2009

    my headlights are not working, but my brights and other running lights are working

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Have the same problem with my 05. Do you have fog lights as those will not turn on either. I thought it was the switch on the stalk but that worked the same when I changed it out. I did notice a bit of a melted spot. Relays and fuses good. I'm guessing a bad ground but WHERE

Posted on Mar 29, 2010

5 Suggested Answers

  • 7353 Answers

SOURCE: low beams don't work - both out at the same time.

DID YOU CHECK THE BULBS?

Posted on Nov 04, 2009

Testimonial: "spot on."

maklean
  • 1665 Answers

SOURCE: Headlights not working

Lihgting switch must also be checked
8673aab.gif

Posted on Jun 08, 2008

djicenova
  • 319 Answers

SOURCE: low beam headlights not working

check voltage at switch

Posted on Mar 18, 2009

  • 1 Answer

SOURCE: Jeep Headlights not working. High beam works

had the same problem on my 92....check under the hood on the drivers side,towards the front,there is a "junction box" with all of the lighting wires connecting from the switches to the lights.My wires were all corroded inside,so I cleaned the ends and bought a new box from the local electronic supply store.The problem has not come back.

Cheers

Posted on Jul 15, 2009

caroldon
  • 17129 Answers

SOURCE: Changed the headlights and checked fuses the

If you have already checked the bulbs to be alright then check if the bulb holders is having bad grounding. If this seems fine then trace back the light voltage to the relay unit, it could be the contacts have worn out or the relay is not switching according to the command from the driver's console multiple switch. Check the voltage flow to the relay before you can confirm on the relay. If no the multiple switch is not giving out the contact. You can use a test lamp to check on the power to all these circuits. Use a 12 volt lamp and ground one end, the other end you can touch upon to the testing line for the bulb to light up confirming the voltage . This way you wiill be able to identify the continuity of the circuit under test. I hope this helps. Good day

Posted on Jul 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Passenger low beam won't light. New bulb did not help, fuses are good. What else can I check ?


low beam won't light Richard, faulty bulb socket module or wires, check and repair.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

How to Fix Low Beam Headlight

Low beam headlights out High beam working

High beams ok but not low beam one side only TDIClub Forums

Mar 06, 2016 | 2011 Mazda CX-9

1 Answer

My low beams don't not work, only high beam. All other lights works fine. Problem started without any known issue. They were working just fine two nights ago. Where should I start? Is there a fuse or relay...


on a lot of vehicles theres a fuse for low and high beam headlights. could be a relay also. check the fuses in the fuse box. if both headlights have been changed and the fuses or relay are ok, then the problem is either in wiring or a bad dimmer switch. have a good day !!

Jan 27, 2011 | Dodge Dakota Cars & Trucks

2 Answers

No headlights come on but high beams work as well as the other lights the fuses seem to be ok. Please help.


If your highbeams are working fine, you must be referring to your low beams not working I would simply check the 2 bulbs and make sure the low beam filament is good, theres a strong possibility that your BOTH low beam filaments are bad and require replacement of both headlight bulbs to get them working again its a very simple repair.....

Dec 07, 2010 | 1990 Mazda Protege

1 Answer

I have aproblem with my Buick Allure both low beam stoped working.The high beam works OK. Checked the fuses and there OK can you help


suspect low beam head light fuse, check fuse if ok suspect that both low beam head lights are burned out ( it happens) ,if ok suspect headlight dimmer switch.

Nov 16, 2010 | Chevrolet Avalanche Cars & Trucks

1 Answer

Headlighbeamt cannot work on high beam


It could be in the switch for the low and high beam's

Feb 04, 2010 | 2001 Toyota Camry

2 Answers

1994 Mercedes c280 high beams not working...


At first 1994 C280 high beams began to not connect regularly when stick pushed forward, then not at all. Drove high beams by pulling and holding stick back towards steering wheel until that stopped working, too. Shop said the turn signal switch was at fault-- had seen it many times before with W202; about $160 to replace. Haven't done it yet, but should be an easy fix?

May 27, 2009 | 1994 Mercedes-Benz C-Class

1 Answer

1994 Mercedes c280 high beams not working...


headlight relay is under the screwed down portion of the fusebox.

Oct 13, 2008 | 1994 Mercedes-Benz C-Class

1 Answer

High beams not working...


More likely to be the high beam relay if it is affecting both headlights.

Oct 13, 2008 | 1994 Mercedes-Benz C-Class

3 Answers

Low beam headlights do not work, but high beam headlights do


Clyde,

I've been troubleshooting this same problem on a different vehicle this week, and I can give you the steps I'd take.

1. If both sides went out at the same time, the problem is *NOT* likely to be the bulbs.

2. Check the fuses to see if both low beam lights are on the same fuse. Many cars have one fuse for low beam and another for high beam, so both lights out at the same time typically means fuse blown.

3. If the headlights are OK and the fuses are OK, then the problem is *LIKELY* the headlight switch. In my case, AutoZone has one and it can be installed easily; but in your case, that may not be as simple.

Please post your findings or comments.

Jul 16, 2008 | 1991 Nissan Pickup

Not finding what you are looking for?
2003 Honda Pilot Logo

1,280 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

60867 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

21949 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

6811 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...