Saturn ION 2003 Trouble Code P0455 - 2003 Saturn ION

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

SOURCE: saturn ion blower motor

lower settings as far as speeds for your blower motor go through a resister block to reduce the voltage your blower motor receives to make it turn slower. If it turns slow on high you would have to check the voltage at the blower motor, should be the same voltage that would be at the battery. There could also be material in the blower motor fan like things a mouse could have put there. Causes the fan to spin slower and also blocks the fins from pushing air. Any strange noises would be heard unless you have had the prob since you owned it and could not detect any changes. It could be even full of stuff and still
be in balance. but it could be a few other things.

Posted on Dec 23, 2008

SOURCE: where is 2003 saturn ion thermostat?

FACEING the ENGINE It is At TOP RIGHT SIDE Close to Master Cylinder takes About 1 hour to Replace Have Fun its a EASY One
Please Dont forget to RATE ME Thank You

1. Drain the cooling system.
2. Remove the bolts that secure the thermostat housing to the water pump feed pipe.

Remove the feed pipe

1. Remove the thermostat and retaining sleeve, noting the orientation for installation.

Installation Procedure
Install the thermostat and retaining sleeve with the dimple placed into the housing slotImportant: Lubricate the O-ring with soapy water or coolant before installing the O-ring in the water pump.

1. Install the feed pipe that connects the thermostat housing to the water pump.Notice: Refer to Fastener Notice in Service Precautions.
   
   
   1. Install the bolt that secures the water pump feed pipe.
   • Tighten the bolt to 10 Nm (18 inch lbs.) .
   1. Fill the cooling system.

Posted on Feb 09, 2009

SOURCE: Oxygen sensor location on a 2003 Saturn Ion-1

One is front of the cat, and one after the cat of the exhaust.
The OBD Scanner should tell you which bank is producing the error.
Bank one is the front one.

Thanks for using FixYa - a FixYa rating is appreciated!!

Posted on Feb 21, 2009

SOURCE: 2003 saturn vue trouble code p1599

P1599 IS A STALLING ISSUE COULD BE BAD GAS / BAD FUELPUMP DIRTY FUEL FILTER
DISCONNECT BATTERY AND SEE IF THE LIGHT COMES ON AGAIN
U2107 HAS SOMETHING TO DO WITH THE COMPUTER LOOSING POWER AT THE BODY MOUNTS CHECK CABLES AND GROUND STRAP

Posted on Mar 02, 2010

SOURCE: I need a fuse diagram for 2003 Saturn Ion

Go to carhelpsite.com it is free as long as you click on 2 of the ads at the website then your questions will be answered by an ASE certified mechanic,you don't have to buy or fill out anything on the ads,so help keep the site free.

Posted on Apr 13, 2010