Question about Cars & Trucks

Open Question

REPLACE THE TORQUE CONVERTER SOLENOID ON 2006 MITSUBISHI RAIDER 3.7

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 142 Answers

SOURCE: torque converter solenoid stuck off DTC

There is a solenoid switch that locks up your torque converter to get a 1:1 input for your transmission. This solenoid (or less likely its circuit) does not operate. You probably don't feel the difference in driveability but this definitely affects fuel mileage of the car... The solenoid for your particular application is available for about 60$ Canadian at NAPA auto parts here in Canada. Not too sure about USD$ and labour costs...

Posted on Aug 13, 2008

Ad
  • 1 Answer

SOURCE: jeep codes location of unit

Got me a complete manual for 199 jeep factory model and found location of each individual unit in question. Manual gives u possible solution to each code and repair and or replace. As a mechanic myself testing, trouble shooting and repair was not that difficult. Shift solenoid was very difficult to get to. Located under the head lamp passenger side.

Posted on Nov 19, 2008

  • 76 Answers

SOURCE: My 2001 Dodge Ram 1500

For a few years, at least in my area, there was a issue with the tcc solenoid. It involved not only replacing the solenoid( dropping the pan and unbolting from the valve body) but also flashing or updating the control module.once both repairs are complete you should have no problems. A good dealer will help you out.

Posted on Dec 06, 2008

  • 132 Answers

SOURCE: Locationof the Torque Converter Clutch Solenoid

Your transmission should still work if the solenoid goes bad. It will just shift funny

Posted on Jan 30, 2009

  • 22 Answers

SOURCE: 2001 Cadillac Deville TCC PWM Solenoid Circuit (p1860)

it should take approximately 4 - 5 hours plus the cost of sensor

Posted on Aug 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have been getting the code p0740 it says something about the torque converter clutch circuit. it doesn't seem to be going into over drive. dose anyone have any suggestions I can try.


On some cars, there is a TCC solenoid in the transmission which can be replaced by removing the bottom pan. In some cars this solenoid can't be accessed without major disassembly.

Jun 04, 2015 | Cars & Trucks

1 Answer

Codes po740, po743 ? po753 all at once. Where should i begin for repairs?


You must do the diagnostics for each code.
Here are the possibilitesP0740 DODGE - Torque Converter Clutch Circuitxicon.jpghttp://engine-codes.com/p0740_dodge.htmlForum CodePossible causes- Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
P0743 DODGE - Torque Converter Clutch Solenoid Circuitxicon.jpghttp://engine-codes.com/p0743_dodge.htmlForum CodePossible causes- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Low transmission fluid level
- Dirty transmission fluid

P0753 DODGEP0753 DODGE - 3-4 Shift Solenoid Relayxicon.jpghttp://engine-codes.com/p0753_dodge.htmlForum CodePossible causes- Faulty shift solenoid valve
- Shift solenoid valve harness or connectors
- Shift solenoid valve circuit is open or shorted
- Low transmission fluid level
- Dirty transmission fluid

Jul 03, 2012 | 1997 Dodge Ram 1500 Club Cab

2 Answers

P0741 code


P0741 MITSUBISHI - Torque Converter Clutch System Malfunctionxicon.jpghttp://engine-codes.com/p0741_mitsubishi.htmlForum CodePossible causes- Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness or connectors
- Torque converter clutch solenoid valve circuit is open or shorted
- Transmission internal mechanical problem

Jun 25, 2012 | 2002 Mitsubishi Montero Sport

1 Answer

I have a 2006 Mitsubishi Raider with a strange starter solenoid or fuse issue. However "intermittent", I try to start the truck and get nothing. All dash lights come on until final twist of the...


You have a strange problem, but I think it is not a serious one. In fact, from what you said it sounds like a contact corrosion problem or a starter relay problem or your vehicle is not sensing the key chip.

Where you say removing the starter fuse and reinserting it repairs the problem for a short time, I feel it is probably contact corrosion on the fuse box connections.

Aug 28, 2011 | 2006 Mitsubishi Raider

1 Answer

Mitsubishi with W4A32 transmission when put in


I suggest you to replace the Torque converter but before to do it check the your Idle air control valve operation.

Jan 27, 2010 | 1996 Mitsubishi Mirage

2 Answers

Car surges at times when driving. Placed obdII on it and recieved a code of PO741. ''torque converter clutch solenoid circuit performance or stuck out'' was told torque converter bad. Could it be a sensor...


U have a problem with the electric transmission torque converter clutch, to repair this requires the removal of the transmission, and in most cases a new torque converter.

Sep 18, 2009 | 2006 Hyundai Sonata

1 Answer

Got error


Transmission related (Shift Solenoid E Electrical)

Shift Solenoid E is the solenoid in the transmission (automatic) that controls torque converter lock-up.

Either this solenoid or its wiring is either shorted or open.

http://autorepair.about.com/library/faqs/bl079i.htm?p=1
explains diagnostics for this code for a Toyota Camry.

While your car does not have the same connectors and pin numbers, the principle is the same.

It is a pretty elaborate problem to diagnose and fix for a backyard mechanic, but in case you want to fix/learn about it:

Torque converters : http://en.wikipedia.org/wiki/Torque_converter
http://auto.howstuffworks.com/torque-converter.htm (very good article)

Sorry, I'm not sure about the exact lock-up solenoid configuration in your particular vehicle...

Aug 30, 2008 | 2006 Mazda 3

3 Answers

MPG


Compare Fuel Estimates for 2006 Mitsubishi Raider Trucks Here's a comparison of EPA fuel economy ratings among the trucks in the 2006 Mitsubishi Raider lineup. As always, your mileage will very likely differ. 2006 Mitsubishi Raider 2WD 6-cylinder Trucks * 3.7L, 6-speed manual, 16 city / 22 highway * 3.7L, 4-speed automatic, 16 city / 22 highway * 3.7L, 6-speed manual, 16 city / 20 highway

May 15, 2008 | 2006 Mitsubishi Raider

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...