Question about 2003 Hyundai Tiburon

Open Question

How do i remove the automatic transmission in 2003 tiburon

I need instructions on removal of the transmission and haynes dont have manual for tiburon

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 102 Answers

SOURCE: 2003 tiburon transmission

if you have a 4 cylinder you wiggle the clutch shaft up and down remove the lever and this will get the fingers off the releasbearing / 2 starter bolts 2 large bolts up top 3 under exhaust and 4 0n the other side lower one is above right inner cv axle, remove left axle from car right axle can moved over un do ball joint 3 mounts remover upper side and reaar , strap engine to a cradle or 4,4 post chained to support engine you can slide tranmission over14 inches with room to stick your hands in and remove pressure plate ,fly wheel can be removed but takes good hands tricky,now thats a hyundai flat rate tech procedure for 4 cyl, IF YOUR NOT SURE ABOUT or if the engine is V6 cylinder THE SUB FRAME COMES OUT you can remove rack hose on sub frame and 4 bolts and wire or strap the steering rack to body at that can stay in car or you will have to take rack out with sub frame

Posted on Sep 25, 2008

Ad
TurboTuscani
  • 15 Answers

SOURCE: 2003 tiburon half-shaft removal

Unfortunately I dont have a solution for you. I highly doubt that the car will be similar to a GM vehicle but its always possible I guess. I would go to your local Hyundai dealer and ask one of the technicians or contact Hyundai directly if they have any way to assist you I'm sure they will. They also have all the schematics available for the vehicle when you sign up with them. Also, alldata.com is usually a reliable source as well. You'll find many service departments utilize it.

Posted on Nov 21, 2008

  • 491 Answers

SOURCE: I need to find out

the ignition switch is the thing you put the key in to start the car

Posted on Jan 07, 2009

michigan man
  • 3533 Answers

SOURCE: need to replace my right front fender fo my 2003 hyundai tiburon

try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Posted on Mar 21, 2009

ghost4548
  • 776 Answers

SOURCE: Need Instructions on 2003 Hyundai Tiburon Clutch Replacement

Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Posted on Jun 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need instructions on how to replace transmission


Hi David.

Getting the actual instructions for a transmission replacement is way over what messages here can convey.

That said, i've replaced a few in times past, and if you're going the DIY route, I've been very happy with the repair manuals done by Haynes (it's what I used on my old Saab for three different tranny swaps - the process worked, I just was a poor student buying wrecking yard transmissions).
Haynes is the information resource for the DIY enthusiast The specific manual is here
Do It Yourself DIY Repair Manual from Haynes and at $20 for a print manual, it'll make back it's cost in no time. They're based on complete tear downs and rebuilds of cars, so the manuals tend to have a lot of practical advice about where you need a helper, when you need some weird collection of u-joints to get your socket on something, and the kind of tools you'll need for the job.

Good Luck to you
D

Dec 02, 2015 | 2010 Chevrolet Malibu

1 Answer

I just got a 2004 tiburon 6 speed 4 cyl why is it when i shift when pressing on the gas the rmps go up but dont pick up speed ??? help


This is bad news either way, whether you have a manual or automatic transmission. The transmission is slipping if it an automatic or your clutch is worn out if it is a manual transmission.
Assuming you have an automatic, is may be the transmission is slipping because the transmission is not quickly shifting gears.

If you transmission shifts using hydraulic valves, there may be hope. You can add a can of SeaFoam transmission oil or similar product that helps stuck valves move. If you have solenoids used to shift the transmission based on motor RPM and pressure sensors, you need to go to a transmission shop to run more complicated tests. In that case, go to someone who is familiar with your vehicle model.

Feb 12, 2015 | 2004 Hyundai Tiburon

2 Answers

Shifting solenoid replace


You will need to remove the transmission drain pan to remove and replace the Solenoid.

Jul 12, 2010 | 1999 Dodge Durango

1 Answer

I need a firing diagram for a 2004 hyundai tiburon gt v6.


if you do not want to spend the money to buy a haynes/ chilton manual, then you can call the parts store and ask them for the firing order, they should tell you over the phone.. they have done that for me many times.... hope this helps.....

Apr 03, 2010 | 2004 Hyundai Tiburon

1 Answer

Cant seperate trans from motor 2003 tiburon 2.0 manual all bolts removed


At the top of the transmission where the hydraulic clutch cylinder rod is attached, you have to remove the lever from the shaft (14mm nut), because the clutch is the 'PULL' type pressure plate bearing system. After you remove the trans, you will need to remove the bearing from the pressure plate and put it back on the input shaft collar in the trans before reinstalling the trans.

Oct 14, 2009 | 2003 Hyundai Tiburon

1 Answer

How i make the idle higher on my 2003 Hyundai Tiburon? Also, does any one know where i can get the service manual for free?


idle is nonadjustable~computer controlled, free manual no, best bet get chiltons or haynes manual at parts store

Jul 06, 2009 | 2003 Hyundai Tiburon

1 Answer

Looking for step by step procedure to replace a clutch assembly in a 2004 hyundai tiburon with a 2.0 liter 4 cylinder engine ...


To do this job you will need a lot of time and above average skill level. You will need a good flat place to work, a good floor jack and a fixture to keep the engine from falling, and a pilot bar to align the clutch disc.. The actual instructions can be found in any decent manual...(chiltons, haynes etc) but art too long to re-write here. if you have any specific questions along the way post back and I'm sure someone will help out!!!
good luck!

Mar 25, 2009 | 2004 Hyundai Tiburon

1 Answer

How to remove gearbox from manual 91 sentra


need a haynes repair manual .it shows you how to do it . it has photos easy steps instruction how to remove transmission.

Feb 19, 2009 | 1991 Nissan Sentra 2 Door

Not finding what you are looking for?
2003 Hyundai Tiburon Logo

Related Topics:

208 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...