Question about 2007 GMC Yukon Denali

Open Question

2007 GMC yukon engine vibration while coming to a stop

When I come to a stop my engine will vibrate

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 375 Answers

SOURCE: '04 GMC Yukon Denali Check Engine Light

Did u put in fuel shortly before the light came on? I own 2 service centers & the most common situation with "Check Engine" lights are because the fuel cap wasn't re-installed or not tightened. When you refuel make sure it "clicks" when putting back on. We don't charge for a "Code Reading" but a dealer will, don't go there. Go, like the others suggested. If it is the fuel cap & you re-install it correctly, the light will go off after a short drive. Good Luck. PS-Don't panic when the "Check Engine" light comes on unless it blinks, if that happens don't drive. PSS-RE: Murray's, Auto-Zone.......If it's a "Code" (the reader will give a #) the code book will tell you the problem. PSSS-Some1 please have Troy W's Mommy & Daddy take away his keyboard. Just because you can put together a "Lego" car doesn't make you a master mechanic. You only repeated what we said except you have a "Napoleon" complex against any1 plugging something in to a vehicle. It's the same as plugging in a light @ home. In conjunction with "kinder" nine out of ten time in my experience it usually is the oxygen sensor(s) which would be about right with the year model

Posted on May 18, 2008

  • 58 Answers

SOURCE: air conditioner compressor vibration

bearing in ac pulley is faulty

Posted on Nov 03, 2009

  • 7353 Answers

SOURCE: Replace headlamps 2007 GMC Yukon

It should be pretty easy, thats why there no "directions" Lift up the hood, now at the headlights there should be 2 rods, lift these rods and the lights should lift out, to access the bulbs.

Posted on Nov 06, 2009

  • 85 Answers

SOURCE: 2001 gmc yukon xl was jerking, cut off. will not start.

it sounds like the fuel pump might have died, or blew fuse or relay see if it gets fuel at the motor

Posted on Feb 24, 2010

  • 10865 Answers

SOURCE: 2005 gmc seirra vibration around 50 mph

It is most likely the tires. Change the tires and the vibration will disappear. J.

Posted on Mar 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Vibration when diving


Your vibration can be from several different things:
Brake rotors warped, Tire out of balance, lugnuts loose, etc.
The most common reason would be a tire has thrown a weight creating the shimmy. Go to your local tire dealer (i would suggest Les Schwab) they can check it out for free, and usually balance for free too.....

Mar 07, 2016 | 2007 GMC Yukon XL

1 Answer

Vibration intermittent


May be wheel bearings, could be a warped brake disk, unbalanced wheel, dry transfer case may need fluid, drive shaft linkage.

Apr 01, 2014 | 2007 GMC Yukon XL

1 Answer

Car vibrates while accelerating, when coasting no vibration


I had a similar issue,turns out it was the drive shaft being a little loose,get it put on a lift and see if you have any play either from transmission or coupling areas.

Mar 01, 2013 | 2002 GMC Yukon Denali

1 Answer

I have a 2005 yukon xl. wife says steering wheel is vibrating, air psi warning light coming on.


so....did you check the air pressure in the tires? it may be to late, vibrations are never good.

Dec 22, 2010 | 2000 GMC Yukon XL

1 Answer

I purchased a 2007 GMC seirra with the 5.3L active fuel management engine.recenlty it has developed a hum/vibration when the engine is in V4 mode and seems to fade away when the engine goes to V8 mode..My...


the older chevys use to have what was the chevy tick-now its the gm hum seems that theirs no remedy to the hum the 08 yukons are a little quieter than the earlier trucks- they all do it u feel it more at higher speeds 65 gm has no answer and states doesnt cause any problem with engine or performance

Nov 24, 2009 | 2007 GMC Sierra 1500

1 Answer

Air conditioner compressor vibration


bearing in ac pulley is faulty

Nov 03, 2009 | 2002 GMC Yukon XL

1 Answer

2003 gmc yukon vibration only at 50 to 60 MPH feels rough like transmition. other speeds are fine.


50-60 mph vibration may be as simple as tires being out of balance or an unevenly worn tire(s)

Oct 18, 2009 | 2003 GMC Yukon XL

1 Answer

1994 GMC Yukon,vibration under deaccelaration


Unbalanced tires wont give a vibration all the time at low speeds.Have them balanced and check wheel bearings and ball joints.If it still persists then have the prop shaft balanced

Sep 01, 2009 | 1994 GMC Yukon

1 Answer

Service Engine light on, car feels likes it's going to stall when stopped, and feels like it's vibrating. 2002 GMC Envoy


Service Engine light on, car feels likes it's going to stall when stopped, and feels like it's vibrating. 2002 GMC yucon denali

Aug 14, 2008 | 2002 GMC Envoy

Not finding what you are looking for?
2007 GMC Yukon Denali Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...