Question about Honda Odyssey

Open Question

Stop chirping when locking and unlocking Honda

Stop the chirp that sounds when locking the car

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 24 Answers

SOURCE: AWD acting like all wheels are locked up

  The clutch in the transfer case is burnt up and fused together therefor binding the powertrain. If you continue to operate it like this it will destroy the front differential and possibly the rear differential. It was most likely cause by the tires not having equal circumference either due to a mismatch of tires (different brands although the same size is indicated on the side wall will have different measurements,I have seen BF Goodrich tires have a different size because speed rating was different although the model was the same) or lack of tire rotation during the life of the tires.. If the measurements are not with in 1/4 inch around the center of the tread this will cause your concern. Tires should always be replaced at all 4 corners on all wheel drive vehicles.

Posted on Oct 19, 2008

Ad
MarkTSI92TLN
  • 37 Answers

SOURCE: keyless remote

Disconnect the battery from your car (negative cable only) overnight. Make sure you have your radio reset code before doing so.

Then reconnect after 10 hours, and make sure you have remote handy as alarm may go off. Then if that doesnt fix it, go to driver door, then insert master key, pull up on handle first all the way and hold it. Then turn the key slowly all the way so the doors unlock and continue turning the key. This will reset the central locking system as yours may have gotton stuck. then remove key let go of handle, open door and try to lock and unlock doors from switch inside car.

Then try remote. It should work, this is what the dealer will do and charge you about $350...if it doesnt work order a new remote b/c yours may have become damaged by liquid or dropping?

Have a great day,

Thanks,

Mark

Posted on Dec 30, 2008

  • 74 Answers

SOURCE: audi a4 turbo chirps when car is started

Could be the belt(s).

If not that, could be a loose hose coming from the turbo. If it build boost and the hose is loose, it'll chirp. At least, it would on my turbo bike. Sounded like a balloon releasing air when the neck is pinched.

Posted on Feb 10, 2009

  • 753 Answers

SOURCE: There's a chirping birdlime noise when the car is

Sounds like your serpentine belt is dried out.Replace your belt make sure belt tensioner is ok,or you can make sure that it is your belt by using a old candle or belt dressing that you can purchase from your local parts store.While engine is running VERY carefully touch the candle to the ribbed side of the belt and let the wax rub off onto the belt the squeak or chirp should change or go away.Or just spray the belt dressing on per the directions on the can.

Posted on Nov 19, 2009

  • 119 Answers

SOURCE: chirping sound coming from fan motor under dash.

remove blower motor and look for obstructions hitting cage(leaves etc.)possibly motor is worn internally

Posted on Feb 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to stop beep when locking and unlocking camry le 2010


When Horn chirp is enabled, the vehicle horn will chirp on locking and unlocking the vehicle, to enable or disable the horn chirp:

1. Turn headlight switch "OFF"

2. Cycle the ignition switch from "LOCK" to "ON" three times (within 5 seconds) leaving it "ON"

3. The vehicle security indicator will illuminate continuously for 5 seconds

4. During the time the indicator is illuminated, operate the horn(for 1 second). The turn signals will flash once to confirm successful programming.

5. Turn ignition switch to "LOCK" and test system with the remote controls.

To disable horn chirp, repeat the procedure for enabling.

The user manual actually declares customizations of the smartkey must be done by the dealers using special equipment. However, the above procedure works on a variety of years and models. And I see no where in the user manual that refers to the horn and door lock even being a customizable setting.

Aug 10, 2017 | Cars & Trucks

1 Answer

Making a "chirping" sound; also, having trouble holding charge. Will security reset address this and how is it done?


Chirping is probably coming from a stuck door lock lever which is part of the reset mechanism for the security reset function !
Either lever is stuck on lock or unlock.

Oct 30, 2015 | 2002 Chevrolet Impala

1 Answer

I have a 04 chevy tahoe and a certified instaled,untill cuple days ago i try to unlock the doors and it wont unlock or lock but the chirp does sound. Also if i do it manually does work, reprogram?


If it chirps or flashes the lights when you try to lock or unlock, it's recognizing the signal correctly. Unless there's a disable mode I don't know about (check the owner's guide), there is probably a fault in the power lock section of the circuit. Since the power locks work from inside the vehicle (manually), check the lock wiring harness at the receiver, or the lock relay inside it.

Aug 04, 2015 | Cars & Trucks

1 Answer

My 2001 ford focus keeps locking. The power locks automatically lock as soon as I unlock them, barely enough time to open door.


Your Focus may be equipped with the autolock feature. Try this:

To deactivate/reactivate the autolock feature using the power door unlock control

You must complete steps 1-7 within 30 seconds or the procedure will have to be repeated. If the procedure needs to be repeated, you must wait 30 seconds.

1. Turn the ignition key to ON.
2. Press the power door unlock control three times.
3. Turn the ignition key from ON to OFF.
4. Press the power door unlock control three times.
5. Turn the ignition back to ON. The horn will chirp.
6. Press the unlock control, then press the lock control.
The horn will chirp once if autolock was deactivated or twice (one short and one long chirp) if autolock was activated.
7. Turn the ignition to OFF. The horn will chirp once to confirm the procedure is complete.

Feb 18, 2015 | 2001 Ford Focus

1 Answer

Car Alarm not chirping when turning on/off


Check the battery

They only last 3 to 4 years in some cases
(cars battery)

That will make the chirp if the module voltage is low

Next would be to have the modules checked for codes
& or diagnosed to find a problem

Nov 25, 2014 | Cars & Trucks

1 Answer

2006 Kia Amanti lock/unlock chirp does not make sound


my guess is the BCM has a problem. There is a separate horn for the "lock chirp" under the hood on the passenger side. you can check for voltage at the horn but remember to hold in the hood ajar button or the test won't be accurate.

Nov 01, 2014 | 2006 Kia Amanti

1 Answer

Can`t get the hand set to lock or unlock, and i ha...


Open the boot/trunk lid and drivers door. Switch on the ignition to position II but do not start the engine. Wait for the dash lights to extinguish. within 5 seconds of the lights going out, Rock the valet switch, in the centre console, 5 times. The system will chirp to indicate it has entered learning mode.

On models with seat/mirror/steering wheel memory functions, the first key-ring transmitter will be linked to memory 1, second to memory 2 etc

Press and hold the larger, lock, button on the key-ring transmitter whilst watching the Red LED and ether wait for it to stop flashing or for the system to chirp a confirmation it has got the signal. If the system doesn't receive any signals for 15 seconds, it will chirp twice and exit learn mode

To program further key-ring transmitters, rock the valet switch once. The system will chirp twice for remote number two, three times for number three etc, then press the lock button of the key-ring transmitter as above

When finish, wait 15 seconds for the system to time out and chirp twice, turn off the ignition, close the doors and boot lid.

May 21, 2010 | 1995 Jaguar XJ6

1 Answer

Factor disarm wire can not locate it? checked the drivers kick panel, door locks are not disaming the system from the door lock moduel


To turn off the auto locks 1 turn the key on 2 press the unlock button 3 times, 3 turn the key from on to off, 4 press the unlock button 3 times, 5 turn the key back to on and the horn will chirp, 6 press the unlock button, then the lock button. the horn will chirp once if the auto locks are deactivated, or twice one short and one long chirp if activated. 7 turn the key off and the horn will chirp once to confirm exiting the system

Apr 21, 2010 | 1998 Ford Expedition

1 Answer

I bought a new Keyless remote for a 2007 Forester from a Subaru Dealer to replace an original one that went bad after 2 years. I have followed the directions in the owner's manual to program it, but can't...


IMPREZA: 2005, 2006, 2007 and
FORESTER: 2005, 2006, 2007, 2008
Check for Immobilizer key on Forester XT models only.
information is always subject to change and correction imp05keylessremote1.jpg
new remote for 2005 Imprezas.
This is not the same remote as the 05 Legacy/Outback remote which also has truck/gate release on the front and a red panic button on the back.
Lock: press Lock button for 2 seconds or so to lock car, and arm optional security system. The car with chirp once and turn signals flash for locked, 5 short chirps and signal flashes if any door is not fully closed. The dome light goes on for 15 seconds and ignition key ring (if present) will light for 30 seconds when unlocked.
Unlock: press unlock one time for driver's door, press again within 5 seconds to unlock all doors inkling rear gate (wagon). The system does not open the trunk.
Panic mode: press and hold lock button for approx. 3-4 seconds to activate Panic mode. I panic model the horn honks and turn signals flash until either the lock or unlock button is pushed again.
Finder mode: Press lock button 3 times within 5 seconds to activate Vehicle Finder mode. The horn will honk once and the turn signals will flash 3 times
Distance: works within approx. 30 feet depending on battery strength, nearby concrete walls and etc.
Audible Chirp On-Off: the system will chirp when locked or unlocked. To turn OFF the chirps, unlock the door and then push both lock and unlock buttons at the exact same time for 2+ seconds. There will be 2 chirps indicating the the audible is off. To turn the chirp back on, repeat the process and the system will chirp one time when it is back on.
Battery: as the battery ages it will only work as you get closer to the car. When a battery is replaced, the transmitter must be re-synchronized with the Keyless control unit. To synchronize, press the lock or unlock button 6 times.
Programming: 4 codes may be programmed.
Sit in driver's seat and unlock all doors. Open and close the driver's door
Turn the ignition key from LOCK to ON position 10 times within 15 seconds. Be sure to stop at both lock and on. The horn will HONK once to indicate transmitter programming mode is activated. Leave key in LOCK position and don't remove it from ignition.
You now have 45 seconds to complete the programming as below.
Open and close driver's door again.
Push either lock or unlock button on the remote you want to program. The horn will honk 2 times when successful.
To continue and program other remotes at the same time: open and close the driver's door and push lock or unlock on the remote. The driver's door must be opened and closed between each remote you want to program.
Done programming? remove the key from the ignition and the horn will honk 3 times.
DELETE old codes? Reprogram 4 times, it will overwrite old codes.
Alarm Security System: optional on all models. When locked there is one chirp (can be turned off, see above), the turn signals will flash and the red 'security' light will start to flash once every 2 seconds except for STi which flashes twice every 2 seconds.
There will be 5 chirps if a door, hood, and trunk or gate is not fully closed
You can also arm the system by using the power lock button on the driver or passenger door as you get out of the car and then closing the door behind you.
Disarm the system: push unlock for 2 seconds
Lost remote, alarm activated? When you can't use a remote to turn off the system: open the door with a key or try to start the car and the horn will start to honk. Turn the key on-off 3 times within 5 seconds and the alarm will go off and you can start the car. It's simple!
VALET mode: To set valet mode or just to disable the security alarm system: 1. unlock all doors 2. physically open the driver's door 3. hold the UNLOCK button on remote for 2+ seconds. The red 'security' light will then flash 2 times a second until the car is turned on.
System has been Tripped (except for STi): if you unlock the door with the remote and it chirps the signal light flash 4 times, the system has been triggered;
Identification mode: To find out what happened and why the system was triggered:
Open and drivers door, leave it open. Turn ignition key from LOCK to ON 2 times and then leave in LOCK position.
Tripped code: 1 security light flash: a door has been opened, 3 flashes when the impact sensor was triggered, 4 flashes when the ignition was messed with or battery disconnected

Nov 19, 2009 | 2007 Subaru Forester 2.5X L.L. Bean...

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...