Question about Cars & Trucks

1 Answer

93 honda accord wagon. Replaced ignition coil main relay distributor and vehical has no spark. Checked voltage to ignition coil and both wires show 12v with vehicle is switched on vehicle still has no spark from coil. What have i not checked.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 68 Answers

The coil itself can be bad. is the check engine light on?

Posted on Dec 03, 2012

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
66 chrgr
  • 1011 Answers

SOURCE: 93 honda accord replaced distributor,coil,wires

turn ignition key on to the run posistion engine light should come on then go out within 5 seconds. if it doesn't the main relay for the computer or the computer itself are .bad

Posted on Jan 25, 2009

  • 1 Answer

SOURCE: No Spark from coil

I have problem with coil not working. In the morning,car with not start, but if I run a wire from battery to (+) to coil (+) will start. the rest of day no problem,car will start. but next morning same problem no spark from coil. c

Posted on Jun 14, 2009

  • 1 Answer

SOURCE: 93 corolla 1.8 No start Blown ignition fuse

I had a prolem like this one time a while back. what i did was got the wiring diagram and checked everything that was running through that 30 amp fuse. on the one i was working on it ended up being an injector wire pinched under the valve cover and it didnt short out till the car was driven til it warmed up and expanded after the valve cover gasket was changed. hope this helps!

Posted on Jun 27, 2009

  • 1 Answer

SOURCE: 1990 FORD F 150,SPARK ON THE COIL BUT NO FROM THE DISTRIBUTOR

i had the same problem. there is a group of wires that go by the distributer and branch off to the distributer and go towards the front. when i would jiggle it the van would die. it ended up being a pinched wire.

Posted on Aug 07, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1998 honda accord 2.3 liter vtec wont spark


Check Distributor cap and rotor for wear or cracks, pay special attention to the center point where the coil wire is, it must be clean and make good contact.

Dec 04, 2013 | 1998 Honda Accord

2 Answers

93 Honda Civic DX not getting any spark


its most likely the distribuator igniter

Jan 15, 2013 | 1995 Honda Civic

2 Answers

My 1994 Honda Accord LX engine cut out while driving on highway. I have found no spark at plugs, distributor or coils. Fuses all look good. I "tested" the main relay by watching the check...


The ecm receives a signal from the crankshaft position sensor and sends timing signals to the ignition control module, whick fires the coil. The problem can be the crank sensor or the control module. The crank sensor is inside the distributor. I have pasted a test procedure below to help you troubleshoot.
1994-95 ACCORD EXCEPT V-6
See Figures 8 and 9
Remove the distributor cap, rotor and the inner cover.Disconnect the wires from the igniter.Check for voltage between the black/yellow wire and ground. Battery voltage should be present with the ignition ON . If voltage is not present, check the black/yellow wire between the ignition switch and the igniter.


Fig. Fig. 8: Terminal identification on engines without VTEC
Check for voltage between the green wire ("BLU 2" on VTEC) and ground. Battery voltage should be present with the ignition ON . If voltage is not present, check the ignition coil and the green ("BLU 2" on VTEC) wire between the ignition coil and the igniter.


Fig. Fig. 9: Terminal identification on VTEC engines
Turn the ignition switch OFF .Check the yellow/green wire between the engine control module and the igniter for continuity. Then check the BLU 1 wire between the tachometer and the igniter for continuity.If the wiring is OK and a problem still exists, the igniter is probably at fault.
Vtec engine
0900c1528005f3bb-ijxbmznl12gbdzghpr4ujmh5-2-1.gif


Non -vtec engine
0900c1528005f3bc-ijxbmznl12gbdzghpr4ujmh5-2-4.gif

Jul 08, 2017 | 1994 Honda Accord

2 Answers

I have no spark in my 1987 honda accord i have replaced the coil and a new distributor also the main relay fuse is good as well as all the other fuses look good it turns over just fine seems to want to...


I would check the crank sensor located on the bell housing. This senses that the engine is turning and allows a spark to be produced. No sensor no spark.

Oct 09, 2010 | 1987 Honda Accord

2 Answers

I have no spark in my 1987 honda accord i replaced the coil and distributor all main fuses are good and the fuses are good as well where is my main ignition relay located ? or is that the problem


there is no relay. test the coil circuit by turning the key on and momentarily grounding the negative terminal to see if the coil will release a spark. If yes, suspect your ignition module is bad. If no, suspect your ignition switch or wire is bad.

9a3082e.gif

Oct 09, 2010 | 1991 Honda Accord

2 Answers

What is a ignition output signal on a 1990 honda accord , recently replaced entire distributor thats the coil , sensors, cap, rotor, ignitor. etc. i have power at the distributor, power at the coil , but...


Most of the time these distributor come with the ignition module did your, if it did and it has not been that long and is still under warranty, have it replace, if it did not come with one replace module.

Jun 11, 2010 | 1990 Honda Accord

3 Answers

95 Honda Accord Won't Start


well seems i would normaly says its the coil but i have my fellings after reading all your info that you may have a dead short leadings to your coil, a dead ecu or a bad coil... hear is why if you replaced the relay and found 2 clicks then the system arched voltage back through the wire untill it fried your relay so i feel that your problem is after the relay, not before you will need a wireing diagram to test your wires, this is where i would start simply because its the cheapest thing to start with. once you have checked the wires if that is not it I can get you a test procidure to eliminating the ecu as the fualt I will have to have a little more info than just the modle and year... Modle, year, engine size, sohc, dohc ????
good luck let me know if you need more help

Aug 22, 2009 | 1995 Honda Accord

2 Answers

1990 FORD F 150,SPARK ON THE COIL BUT NO FROM THE DISTRIBUTOR


Replace the wires from the the ingnition module from the coil.

Jul 12, 2009 | 1990 Ford F150

1 Answer

93 honda accord replaced distributor,coil,wires and plugs. can hear fuel pump. still wont start.


turn ignition key on to the run posistion engine light should come on then go out within 5 seconds. if it doesn't the main relay for the computer or the computer itself are .bad

Jan 16, 2009 | 1993 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...