Cental locking diagram
SOURCE: cental locking
hi check your fuses before anything else if they are ok check your wiring in the drivers door as it seems the drivers door actuator is faulty be carfull if you try to see if you can test by by-passing the actuator all the switches need to be connected before you can test as one feeds the other and vise -versa if no live going to the switch and its not a fuse check the wiring loom where it passes through the door to the a-post as opening and closing the door breaks the wires yates210456
SOURCE: cental locking, stopped working after batt failed
Relay was probably burnt out when battery went. Refer to manual for the relay location
SOURCE: My Mitsubishi colt CZ1 (07
Central locking works by way of little electric motors that engages and disengages the door lock. The drivers door has an additional set of contacts in the actuator which signal the controller when it changes position. The controller activates the servo motors when a signal is received from the receiver or from the drivers door servo motor. So in your case I suspect the motor part of the drivers door actuator is done for.
To replace you will have to remove the inner driver's door panel to get at the actuator. The actuator itself cannot be repaired and needs to be replaced as a unit.
Testimonial: "Very helpful answer and a prompt response. Thanks"
213 views
Usually answered in minutes!
×