Question about 2001 Nissan Sentra

Open Question

How do I replace the Shift Knob on the 2001 Nissan Sentra SE 2.0 engine

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
pal03246
  • 726 Answers

SOURCE: 2001 Nissan Sentra Block Heater

You can't find one, because it doesn't have one.

Posted on Dec 17, 2008

Ad
  • 718 Answers

SOURCE: Nissan Sentra shifter lamp replacement

Transmission shift indicator light on center console.
First
make sure the fuse is good.
If the fuse is good then remove the screws holding the center console cover. You will need a long and short phillip screwdriver. Look for screws in the cup holder, under the handbrake handle and where the console runs under the dash. You may have to move seats forward/backward to reach the screws. When you attempt to raise the console cover you will notice you overlook a screws. Remove them also. You may be able to reach the bulb without removing the gear shift handle. DO NOT TOUCH any other electronics you see. The AIRBAG ACTUATOR is located here also. Replace bulb. Test before reassembly. Good Saturday morning project.

Posted on Mar 13, 2009

pal03246
  • 726 Answers

SOURCE: Nissan Sentra 2001 gxe with code p0420

You will need a new catalytic convertor assembly. Yours is below treshold efficiency in other words its "no good".If you have it replaced, ask the garage/dealer to give you the old one back. Its worth some cash if its full. It doesn't matter thet it failed. They are going after the mesh inside of it and that is worth some $$$$. May not be much , but better than nothing.

Posted on Jul 26, 2009

blueextc3221
  • 15935 Answers

SOURCE: replace starter on 2005 nissan sentra

  1. Remove or disconnect the following:

    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter

To install:
Install or connect the following:

Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable




Thanks for using FixYa - a Very Helpful rating is appreciated for answering your FREE question.

Posted on Jul 31, 2009

jturcotte
  • 8531 Answers

SOURCE: where is the coolant sensor located on a nissan

I assume you are referring to the coolant temp sensor. as you look at the front pulleys of the engine, its on the right side behind a bracket just above the alternator. See picture below and let me know if you have questions. If you are referring to the coolant level sensor, it would be on the side of the coolant reservoir.

jturcotte_134.gif

Posted on Nov 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2003 Nissan Sentra SE-R and the engine keeps sputtering while i am driving and the diagnostic pulled the P0335 code indicating that my CKP is malfunctioning but i just replaced it and it is doing...


Note - not a solution..just adding my woes!
I drive a 2003 Nissan Sentra SE-R Spec V.
My car suddenly stalled 1 day and the engine wouldn\'t turn over. Brought it to my mechanic and had the Camshaft position sensor replaced by my mechanic. The car ran fine for about 2 weeks and then the light was back on with the initial symptoms.

Took the car into the dealership and they diagnosed it again as P0335. Said that the mechanic hadn\'t installed the sensor correctly. Charged me a bunch of money to replace the thing and not too long ago the check engine light is on. The Revs bounce around everywhere. Checked the code again and it\'s P0335 yet again! Am in talks with the dealership to get to the bottom of this...

Apr 19, 2010 | 2003 Nissan Sentra

2 Answers

I need the Torque Specs for a Nissan Q-R 2.5 Engine?


Nissan QR 2.5 engine produces a torque of 180 ft·lbf (244 N·m) of torque at 4000 rpm .

Oct 11, 2009 | 2003 Nissan Sentra

2 Answers

My brake light in my 2001 Sentra SE came on. Any


either the park brake switch is stuck open or the master cylinder is low on brake fluid.

Jul 10, 2009 | 2000 Nissan Sentra

1 Answer

Manual 2001 sentra I wanted to replace the shift knob


you may just need to put some more elbow grease in to it. Stock shifters have the tendency to really stick after a while. Be sure though to turn counter clockwise.

Jun 26, 2009 | 2001 Nissan Sentra

1 Answer

1993 Nissan Sentra SE-R stick shift is moving to loose.


check the transmission selector rod, it just happened to my car last week. i could do reverse when i found out it broke. one thing that might caused it is too much pressure applied on the stick shift.

Mar 15, 2009 | 1993 Nissan Sentra 4 Door

1 Answer

Disk Brakes Adjustment/Nissan Sentra 2001


you cant the only thing u can do is bleed them they are self adjusting

Jan 03, 2009 | 2001 Nissan Sentra

1 Answer

Nissan Sentra 2001 2.0/SE Disk Brakes


you cant they are self adjusting the only thing you can do is bleed them and see if that helps

Jan 03, 2009 | 2001 Nissan Sentra

Not finding what you are looking for?
2001 Nissan Sentra Logo

Related Topics:

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...