Question about 2006 Hyundai Sonata

1 Answer

When i start the car, the "key symbol" in the dashboard didn't light and i try several time until the light of the key appear and the engine work.

I use the penetration oil inside the ignition switch and it's work 2 days. and now i wanna to change the ignition switch cylinder

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 151 Answers

You dont want to do that ok its not your suitch let me know and explain little more i can help you

Posted on Dec 03, 2012

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

vatticus
  • 20 Answers

SOURCE: Hyundai Sonata 06 engine runs key out ignition in off position

car should be under warranty .. try having a new key made .if that dosent fix it. it's in the key lock maybe a wire loose .

Posted on Jan 21, 2009

  • 16 Answers

SOURCE: 2000 hyundai tiburon-would not start and bad O2 sensor code

the only way to get your compression back where it should be is changing the rings...and while you're at it; fully service the engine

Posted on Apr 03, 2009

jingB
  • 19 Answers

SOURCE: I own a 1996 Hyundai Accent carburator 1.3 model.

hello, if you car stalls instanly maybe your ignition system has a loose connection or even has a short somewhere. but if it coughing but still trying to idle normally maybe your carb dirty. one thing, some carbs has a solenoid air switch attached on one of its side. if this solenoid is shorted damaged you'll have the same effect. hope this helps.

Posted on Apr 14, 2009

redgs95
  • 15 Answers

SOURCE: My '98 S10 ignition switch will click, then work.

first check all cables for corrosion on the battery. then go under the truck and check all cables that are on the starter. if they are clean then replace the starter because the solenoid is going bad.

Posted on Jul 28, 2009

  • 1 Answer

SOURCE: 2001 Elantra stall, loss of power. Driving at

I am having the exact same problem with my 2001 Hyundai Elantra. I was told that the engine code that comes up when the sensor is on is called "Absolute Pressure In The Manifold". I was told by a "Hyundai Specialist" that when that code comes up it usually means that the seal on the manifold is Fuct. When my mechanic checked that out for me he had noticed that my manifold had 4 cracks in it(can varify cause he showed me). He replaced the manifold and gasket. The car ran fine for about 2-3 days and since then the problem has since come back and my check engine light will no longer go on/off it only stays on. Because of the check engine light always staying on I have noticed that on many occasions my car will hiccup many times in a row. The only way to stop the hiccup I have noticed is to take my foot right of the gas for approx. 2-3 sec then car will continue without hiccup(till it happends all over again). All in all I have been having this problem now for approx. 1 year and if there is somehow someway it could be repaired I would appretiate it.

Posted on Nov 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a MAN TGA 41.360 2003. A key symbol appears on the dashboard which causes the engine to shutdown. Several technicians have attempted to solve the problem but it still persists. I am now lost wi


My daughter has had similar trouble with her hyundai, it ended up being the security module at fault with the passive key not communicating with each other, she had to get a new fob and module and reprogrammed, the temporary fix to it was to press the button 3 times with the ignition on then try and start it again, didn't always work but most times it did, hope this helps, happy holidays.

Nov 29, 2014 | DAF 44 Cars & Trucks

1 Answer

A key symbol on dashboard and lights are not working


Whenever this warning light or any other stays on in the dash it is indicating that the systems control module (or the system sensor in the case of lights like low oil pressure, door open indicators etc.) has detected a fault, it then disables the system (this applies to ABS,TCS, TCM, SRS, TPMS, MIL, CEL and BCM faults and others) as long as the light is on. You must now have the dealer hook up a special electronic diagnostic tool and "scan" the system for the fault code that is stored for the problem(s)

Legend of Abbreviations. ABS Anti-lock brake system. TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module. TPMS Tire Pressure Monitor System, MIL Malfunction Indicator Lamp, CEL Check Engine Light.

Nov 14, 2012 | 2008 Smart fortwo

1 Answer

My 2004 Chevy suburban won't start but there is a locked padlock on dashboard , is this why?


sound like problem in the theft security systm,try this insert another key in the ignition switch, the other key could be worn where pcm and bcm dont recognize it. and switch ignition on engine off watch padlock symbol with ignition switch left on 10 minutes the padlock symbol will extinguish or turn off then you will turn off ignition switch wait 5 seconds then try starting vechicle if start your theft security failing need let dealership check it out.

Aug 27, 2012 | 2004 Chevrolet Suburban

1 Answer

Please read the whole question. It may be long. So I have an 03 Toyota matrix. When I started the car today everything was fine. I went to the gym with a friend and when we got done and was in the car he...


Assuming you were parked on some sort of hill, the jolt was the car moving and applying pressure to the park gear in the transaxle which is normal.
There is a neutral safety switch on the transaxle to prevent you from cranking the car in drive or reverse. Something may have happened to that switch when the transaxle moved.
When you turn the key to on and do not crank the engine, the check engine light stays on until the engine starts.
I would have someone check for voltage at the starter and at that neutral safety switch.

Jul 26, 2012 | Cars & Trucks

1 Answer

I have a spanner symbol on my 407. what does this mean??


You need to carry out the periodical car service due (e.g. engine oil & filter, air filter, fuel filter, cabin air filter). The "service" spanner symbol "reset" button is placed on the lower right corner of the dashboard. See picture below:

tdisline_303.jpg
Then you should reset the "service" spanner symbol by pressing on the "reset" button on dashboard, when ignition key is in OFF position. Hold the button pressed and turn ignition key in ON position. Hold the button pressed and see on the dashboard successive numbers will appear: "10", "9", "8", ... , "1", "0". Then release the button and switch OFF the ignition key. The "service" spanner symbol followed by "20000 km" (or "30000 km" depending of the engine type), will appear for few seconds after turning ignition key in ON position, and will dissapear after engine starting. The car service due was reseted.

Please do rate my response. Thanks!

Feb 21, 2011 | 2005 Peugeot 405

1 Answer

2002 Jeep Grand Cherokee was driving fine, stopped to eat and got back in and it would not start. All dashboard warning symbols came on. I checked the manual and it appeared that the engine had been...


when u turn the key in on poistion do u hear the fuel pump come on it should prime up for three seconds it could be a weak fuel pump leaking down,or look on your key on the sliver part if u have a black piece with a sliver on it that could be wore out u have a extra set of keys try them an see what happens then.

Jul 31, 2010 | 2002 Jeep Grand Cherokee

1 Answer

Yellow engine symbol appeared on the dashboard of my 2005 Ford Taurus.


The engine shaped dash warning icon/symbol represents the "Check Engine Light", CEL for short.
It could be because of several things that can make the light come on. Perform a scan on the car and identify the error codes . Autozone can scan the codes for free.

Mar 04, 2010 | 2005 Ford Taurus

Not finding what you are looking for?
2006 Hyundai Sonata Logo

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...