Question about Honda Accord
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
First drain radiator by opening drain valve,"located on bottom corner usualy the right,but not always." If you open the overflow or remove cap this will happen much faster.For safety sake disconnect ground wire from battery,the radiator is locked down by top cover that attaches to body with generaly 4 bolts, upper and lower hoses have to be disconnected and if it is automatic the transmission cooling lines are connected in stacked fashion,"one above the other."The cooling fan has to be unplugged and it should be removable at this point,"when unplugging fan be carefull with connector so it doesn't break.reverse steps to replace making sure the bolts go in the right place and it all fits properly.the thermostat,"located behind the kneck of upper hose," should be replaced after connecting lower hose because in order to fill the block up and prevent damaging thermostat the block shoud be filled with coolant before attaching upper hose.
Posted on Apr 20, 2009
it has a problem with the second gear drum it cracks and does not fully engauge the n shifts to 3rd ..many honda owners also learn the 8 bucks a quart is the only fluid to pour in a honda..but remember 3 qaurts per drain and fill the tranny holds 7q ....it will take a case to do a drain flush...a high pressure flush will ruin a automatic tranny with alot of miles or metal deposits floating around inside..DRAIN AND FILL 3 QUARTS AT A TIME NO GASKET NEEDED ITS BUILT AND DESIGNED LIKE A MANUAL TRANNY
Posted on May 07, 2009
Inside the center console, on the side of the shifter, there is a neutral safety switch. You can replace it, or remove it. If you remove it, you will always be able to shift the gear, even with the car off, so its something to think about. But it can be done.
Posted on Oct 17, 2009
For 1997 Honda Accord 2.2L MFI
4cyl the Vehicle Speed Sensor - Location is located mounted on transmission.
The Vehicle Speed Sensor (VSS) is a magnetic pick-up sensor that sends a signal to the Powertrain Control Module (PCM) and the speedometer. The sensor measures the rotation of the output shaft on the transaxle and sends an AC voltage signal to the PCM that determines the corresponding vehicle speed.
Posted on Jul 16, 2010
Tips for a great answer:
Sep 11, 2014 | 1997 Honda Accord
Oct 13, 2012 | 1993 Honda Accord
Jan 13, 2011 | 1991 Honda Accord
Jul 08, 2010 | 2002 Honda Accord
Jun 08, 2010 | 1992 Honda Accord
Nov 10, 2009 | 2004 Honda Accord
Jun 24, 2009 | 1997 Honda Accord
Jan 11, 2009 | 1997 Honda Accord
44 people viewed this question
Usually answered in minutes!