Question about 1996 Honda Accord
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
If the engine is running without any problems then The fault code which has flagged the checked engine light will either pertain to the upstream O2 sensor, a drop in catalytic efficiency, an EGR issue, or maybe even an EVAP issue.
A lot of EVAP issues can be resolved by simply ensuring that the fuel filler cap is on securely, otherwise a vacuum leak will be detected in the system and the check engine light will come on.
A drop in catalytic efficiency (P0420) is usually temporary and will stay away after a reset.
EGR issues can sometimes be rectified by removing the EGR valve and cleaning it, and the ports on the intake where it was sat, but there are occasions when it has to be renewed.
The O2 sensor issues are a wee bit different. There are a number of fault codes which relate to the O2 sensor, and which make the O2 sensor look faulty, when the O2 sensor is actually attempting to rectify a problem from elsewhere and isn't faulty at all. However, they could also be due to a fault with the O2 sensor. Basically, further checks should be made before condemning the O2 sensor should the fault code relate to the sensor.
Have a code read done and then have the codes reset and see what comes up.
Posted on Jun 23, 2008
First drain radiator by opening drain valve,"located on bottom corner usualy the right,but not always." If you open the overflow or remove cap this will happen much faster.For safety sake disconnect ground wire from battery,the radiator is locked down by top cover that attaches to body with generaly 4 bolts, upper and lower hoses have to be disconnected and if it is automatic the transmission cooling lines are connected in stacked fashion,"one above the other."The cooling fan has to be unplugged and it should be removable at this point,"when unplugging fan be carefull with connector so it doesn't break.reverse steps to replace making sure the bolts go in the right place and it all fits properly.the thermostat,"located behind the kneck of upper hose," should be replaced after connecting lower hose because in order to fill the block up and prevent damaging thermostat the block shoud be filled with coolant before attaching upper hose.
Posted on Apr 20, 2009
stand infront of your car, open hood and look at transmission assembly, Vss is neardown the throttle body, and for sure , it is two wired sensor, yellow and orange,,(yellow wire connected to ignition on)
Posted on Jun 26, 2010
Tips for a great answer:
Dec 22, 2016 | 1997 Honda Accord
Sep 30, 2012 | 1997 Honda Accord
Jun 04, 2011 | 1997 Honda Accord
May 06, 2011 | 1997 Honda Accord
Apr 22, 2010 | 1997 Honda Accord
Dec 31, 2009 | 1997 Honda Accord
Sep 25, 2009 | 1997 Honda Accord
Jun 06, 2009 | 1997 Honda Accord
Jun 19, 2008 | 1997 Honda Accord
72 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: