Question about 1999 Dodge Durango

1 Answer

Ground Connector "G304" location

I am looking for the Ground Connector "G304" location on a 1999 Dodge Durango. According to the Haynes manual, this is the ground which operates the power windows through the Driver's side master switch for the locks and windows, however I found another location which says that "G304 Left Rear Body Ground (REAR BODY WIRING)" Would the Ground be WAY back there somewhere? And if so, WHERE?! Any help would be appreciated! Thanks!

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 5,498 Answers

Hard to believe the ground would be that far away. I worked on my son's '95 Chrysler sedan, and had to find the power windows ground. It was behind yhe trim of the left kick panel, just below where the bundle of wires from the door entered the cabin. You should check there.
If you have a hot wire at the master switch, you can check the ground right from the master switch. Put positive lead of a voltmeter or testlight on the hot wire (key must be on) and negative lead into the ground terminal for the switch. If the ground is good, meter will show battery voltage or the testlight will light. If the ground is lost, nothing on the meter-The chrysler had a broken ground wire right in the door opening, Maybe you already checked and have no ground...the ground is likely close to where the wires enter the cabin. Good luck.

Posted on Dec 03, 2012

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
motor1258
  • 6674 Answers

SOURCE: 2003 dodge caravan rear door locks

Look for contacts at door jamb & door, that mate when closed.( usually round metal piece) Take a piece of fine steel wool & scrub them and see if that cures it.

Posted on Mar 01, 2009

  • 290 Answers

SOURCE: needing wiring diagram for 1991 dodge dynasty le

here is what I found:
http://www.the12volt.com/installbay/stereodetail/715.html

Posted on Mar 26, 2009

  • 145 Answers

SOURCE: 1999 Dodge Durango driver side window does not roll up nor down.

Remove the door panel and find the window motor Unplug it and using a separate car battery run cables directly to the window motor When you switch the polarity the motor will either bring the window up or down or if noting happened change the window motor and window regulator assembly.

Posted on Jun 08, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is egr valve located on 99 dodge durango 5.9l magnum v8 slt plus? Or does it not have one


Hi, I was unable to locate an EGR valve in any engine diagrams I ran across for your engine. However, if you know what an EGR valve looks like then trace all lines, tubing from your intake manifold. Sometimes they can be located at the back of an engine but more than likely they are at the front or the side of the engine usually with only one electrical connector and two screws that mount the EGR valve to an exhaust tube.

Oct 22, 2017 | 1999 Dodge Durango

1 Answer

Where is the body control module on a 1999 Dodge


The actual name of the part is Central Timer Module or CTM. I would get a Haynes manual. I was unable to get a part location for that. Haynes manuals are very accurate with pics and descriptions.

Aug 29, 2014 | Cars & Trucks

1 Answer

2001 Ford Windstar Van I am losing power to the instrument cluster. The charge l2001 Ford Windstar Van I am losing power to the instrument cluster about 10 seconds after starting. The charge light,air bag,...


All the thing's your having problems with are controlled by the computer's an communication network . (FEM) - front electronic module , insturment cluster , (REM) - rear electronic module. etc... It's probably a loose ground connection somewhere . The headlamp switch is a electronic input to the insturment cluster , the insturment cluster is hooked to the SCP - serial data network . The insturment cluster electronic's (computer ) microprocessor sends a message to the (FEM) to turn on light's , the front electronic module will then suppy a ground to the headlamps circuit turnning on the headlamps. Samething for the wipers an turn signals an horn too .
010 Ford SCP Communications
From looking at a wiring diagram i would look at ground connection G-304 . Do you know what a body ground is ?
This ground is located How to troubleshoot headlights intermittently on and off with headlights...

1down vote Basically your headlamps are controlled by a computer. The Front Electronic Module (FEM) to be exact. The FEM grounds the headlamps when it wants to turn them on. This system was an early Multiplex design that reduced wire and total circuits where the modules communicate on a single serial line, now referred to as the CAN Bus (Controller Area Network). You will likely need a scan tool to diagnosis the car, and not a cheap one, but a professional model. You many even need a factory scan tool, though I doubt if for a Ford. Outside of security theft deterrent systems they allow the aftermarket professional scan tools to access their systems.
So where do you go from here? With or without a scan tool, the grounds are a good place to start.
G303 are the main ground for the FEM.
G304 is connected via C179 (C means connector) and through S139 (S means splice)
G304 is located behind the LH cowl panel C179 is located behind the LH side of the instrument panel S139 Dash panel to headlamp junction, near T/O to C192 Front Electronic Module (FEM)
You can see the FEM, G304, and C179 in the picture below. Outside of checking the connections and wiring there is not much you can do without a scan tool.

Jun 24, 2017 | Cars & Trucks

1 Answer

Durango wont start after replacing heatercore I


check ground wires on both sides of dash

Feb 12, 2011 | 1999 Dodge Durango

1 Answer

1999 dodge durango dash lights are taking turns coming on security, abs, brake, check engine ect. had the battery replaced about 2 mos ago problem since. We did unhook battery to reset but still have...


This happened to me when we got our 99 Durango back from collision work. Looked like a light show at Disney. Check the ground wires on the fire wall . There are alot of them and you'll have to really look for them all but your car is doing exactly what mine did. The body shop missed 4 ground wires during the repair and it drove me nuts but once they were all back on it was fine.

Oct 14, 2010 | 1999 Dodge Durango

1 Answer

1999 dodge durango stalls and a code that reads (no bus)shows up in the odometer what does this mean


try unplugging the crank sensor that is located in the bell housing of the transmission,on top of the bell housing,when these go bad they pull everything to ground including the bus communication,if you unplug it and the message goes away,replace the sensor,hope this helps

Sep 21, 2009 | 1999 Dodge Durango

1 Answer

Need a wiring Diagram for a 1999 Dodge Durango so i can install a remote start system. Or what colors I need to look for.


Most auto parts stores such and advance auto parts and autozone sell repair manuals. I prefer the Haynes manuel wich has the wireing diagrams printed in the back of the book and acuratley tell each color code

Aug 03, 2009 | 1999 Dodge Durango

2 Answers

2000 dodge durango driver side window problem


I have had to replace three of the four window power regulators in my 2000 Durango. They just seem to stop working within a year or two of each other.

Aug 02, 2009 | 1999 Dodge Durango

1 Answer

Fuel filter location 1999 dodge durango


the fuel filter is located on the iner driver or pasenger side frame railing inbetween the front and rear doors. yes it has filter in the tank which is more comely know as the sock or straner. the filter will look like a metal canister .

Jul 29, 2009 | 1999 Dodge Durango

1 Answer

Checking engine grounding cables to make sure that they are working properly


the manual shows them you unhook both ends and hook up a mulitimeter clips itll show if open or closed. i mean if open looped broken wire or closed your fine

May 29, 2009 | 2001 Dodge Durango

Not finding what you are looking for?
1999 Dodge Durango Logo

213 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...