Question about 1994 Nissan Sentra 4-Door

Open Question

How to remove the alternator on my 1994 sentra 1.6 L

I need to replace the alternator on my 1994 nissan sentra 1.6 L

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MNfisherman
  • 11896 Answers

SOURCE: i have a 2001 nissan

  • Disconnect and label the wiring harness connections to the alternator (Painters Masking tape works very well for labeling Automotive wiring).
  • Loosen the alternator pivot bolt.
  • Remove the bolt that attaches the alternator to the adjustment arm.
  • Rotate the alternator to loosen the drive belt and disengage the belt from the pulley. Be careful that any spacers that are used in mounting are kept with their original bolts. This will make correct reinstallation much easier.
  • While supporting the alternator remove the pivot bolt.
  • Remove the alternator from the vehicle.
To reinstall the alternator, reverse the removal procedure.
To adjust the belt tension, leave the pivot and adjusting arms loose. Look up the belt tension specification for the vehicle you are working on. Using a belt tension gauge on the belt apply pressure to the alternator until the correct belt tension registers on the gauge and tighten the mounting and adjustment bolts to the specified torque specification.
CAUTION Over tightening of the alternator drive belt will cause the unit to whine and premature failure of the alternator drive end bearing, the water pump or the engine crankshaft.

Posted on Jan 16, 2009

  • 120 Answers

SOURCE: 2000 nissan sentra alternator removal

take the front mount off the front of the motor jack up or let down futher

Posted on Feb 20, 2009

  • 4369 Answers

SOURCE: NEED TO REPLACE ALTERNATOR MYSELF

here's 96. should be the same. Be very careful not to overtighten any of the belts or you can break the snout off the crankshaft and ruin you engine.

Section 14-02: Generator, Integral Regulator — Internal Fan and Regulator Type 1996 Villager Workshop Manual
REMOVAL AND INSTALLATION Generator Removal

  1. Disconnect the battery ground cable (14301).
  1. Raise and support the vehicle.
  1. Remove the five engine and transmission splash shield bolts and two engine and transmission splash shield screws.




  1. Remove the RH engine and transmission splash shield (6775).
  1. Remove the wire harness bracket bolt.




  1. Remove the B-terminal insulator boot.
  1. Disconnect the generator electrical connector from the generator (GEN) (10346).
  1. Remove the ground wire nut from the generator and position the ground wire aside.
  1. Remove the B-terminal nut from the generator and position the B-terminal wire aside.




  1. Loosen the inner and outer generator-to-bracket bolts.


    61f4d2f.gif

  1. Loosen the generator locking bolt.



    93c9f65.gif
  1. Loosen the generator adjustment bolt.


    6e949fa.gif

  1. Remove the drive belt (8620) from the generator pulley (10344).
  1. Remove the generator locking bolt and washer.
  1. Remove the inner generator-to-bracket bolt and the two washers.
  1. Remove the outer generator-to-bracket bolt and the two washers.
  1. Remove the generator.
Installation
To install, reverse the removal procedure. Tighten the inner generator-to-bracket bolt to 23-26 Nm (17-19 lb-ft). Tighten the outer generator-to-bracket bolt to 23-26 Nm (17-19 lb-ft). Tighten the generator locking bolt to 16-20 Nm (12-15 lb-ft). Adjust the drive belt very carefully. Refer to Section 03-05 for the procedure.

Posted on Jun 17, 2009

blueextc3221
  • 15935 Answers

SOURCE: replace starter on 2005 nissan sentra

  1. Remove or disconnect the following:

    Negative battery cable Air inlet tube Harness bracket Wiring at the starter Starter

To install:
Install or connect the following:

Starter and torque the bolts to 60 inch lbs. (7 Nm) Starter electrical connectors Harness bracket Air inlet tube Negative battery cable




Thanks for using FixYa - a Very Helpful rating is appreciated for answering your FREE question.

Posted on Jul 31, 2009

  • 24 Answers

SOURCE: How to replace cabin air filter nissan sentra

lOOK BEHIND THE GLOVE COMPARTMENT. Compartmet is probabily plastic and all you have to do is push in real hard to get them past dash board.

Posted on Jan 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 nissan sentra sx 200 knock sensor location


Melvia, Knock sensor located under the intake manifold between cylinder #2-3 I believe, hard to change with out removing intake manifold, but can be done. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
1995 1999 Nissan Maxima 1 2 Knock sensor replacement
KA24DE Knock Sensor Code 34 FREE REPLACEMENT How To
Knock sensor on 1995 Altima
Get the Best Priced Nissan Sentra Knock Sensor

Aug 21, 2016 | Nissan Cars & Trucks

1 Answer

Why does 2006 nissan sentra spec stalls while driving?


That isn't really much to go on, but if your timing is bad that could cause issues so I'd take it into the shop for a check-up. Also check your battery and alternator, mine kept stalling at times and the alternator died shortly thereafter. Replacing that seems to have fixed it.

Jun 12, 2014 | 1994 Nissan Sentra 4-Door

2 Answers

I ve vchanged the battery and alternator on my 94 nissan sentra and the system still wont charge what is the cause


My friend is a Honda Vehicle Technican who owns a 1994 Nissan Sentra which had kept dying on him. He had called the AAA driver who stated that the alternator was good as noted on the print out report when the AAA driver ran the check on the system. It turned the alternator was bad, which somehow also affected the starter. While the AAA driver had jump started the car, the ignition switch relay got broken; and the small positive cable connection got a short; so it all, he replaced the alternator, the starter, the battery and got a new battery cable connectors, ignition switch relay and fuse for the inside of the interior lights -- and he has no problems since after spending 4 days on this problem. It would had been easier had he had a lift and the right equipment but nevertheless he got it done but missed his work -- but at least its fixed.

Jun 08, 2012 | 1994 Nissan Sentra 4-Door

1 Answer

Replacing a starter on a 1994 nissan sentra 1.6 .


please remove the battery terminal for safety purpose,remove the female terminal of the starter,remove the number !2mm bolt on the starter then remove the two bolt upper portion lower portion number 14mm bolt then pullout the starter from the transmission housing

Apr 02, 2011 | 1994 Nissan Sentra 4-Door

2 Answers

Alternator


1996 Nissan/Datsun Sentra 1.6L SFI DOHC 4cyl

Nissan Sentra/Pulsar/NX 1982-1996 Repair Guide
The alternators for Pulsar and Sentra have not changed much over the years. However, the 1987-88 alternators for Pulsar and Sentra have a different internal diode assembly.
  1. Disconnect the negative battery terminal.
  2. Disconnect the 2 lead wires and connector from the alternator.
  3. Loosen the drive belt adjusting bolt and remove the belt.
  4. Unscrew the alternator attaching bolts and remove the alternator from the vehicle.
To install:
  1. Install the alternator and retaining bolts loosely.
  2. Install the belt and connect the wiring.
  3. Adjust the belt as outlined in . Torque the retaining bolts to 25 ft. lbs. (34 Nm).

I hope help you with this (rated this help).

Sep 11, 2009 | 1996 Nissan Sentra

2 Answers

94 nissan sentra brake light/ battery light


Your alternator is dead/dying. Nissan puts both of those lights on to tell you that the alternator isn't charging your battery.

Jun 10, 2009 | 1994 Nissan Sentra 4-Door

1 Answer

1994 Sentra - How to replace alternator?


Nope, but if you turn the alternator just right it almost slides right down. I replaced mine no problem. The bottom bolt you need to tighten from below.

Sep 07, 2008 | 1994 Nissan Sentra 4-Door

Not finding what you are looking for?
1994 Nissan Sentra 4-Door Logo

Related Topics:

323 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...