Question about 2001 Dodge Durango
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Here is a diagram of you vehicle. Good Luck please leave a FIX YA comment if I fixed ya. http://www.2carpros.com/car_repair_information/tec_info/2004/dodge/durango/2004_dodge_durango_drive_belt_routing_diagram.htm
Posted on Dec 27, 2008
SOURCE: egr valve dodge durango
if this is a 4.7l engine, the valve is on the left rear of the intake. loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time and patience.
Posted on Apr 24, 2009
If your blower only worked on high before it quit, or didnt work on high before it quit,
You probably have a faulty blower motor resistor assembly. The part number is 04885635ab If you look on the bottom of the motor housing on the passenger side (about where the passenger toes would point) you will see a wire harness that is a long oval in shape and has 5 or 6 wires in it. You will need a 7 or 8mm 1/4 inch drive socket with a u-joint attachment. on the firewall side of the connector, there is a sliding lock that keeps the connector on the plug. you will have to slide the lock toward the drivers side and the squeeze a small blak tab to pull the connector off of the plug. Once the connector is off, use the socket to remove the 2 screws. It will drop right down once the screws are removed. Once it is removed, it looks like a 2 inch by 3 inch by 16th of an inch thick piece of metal with a plug on it. The resistor pack dissipates ALOT of heat so do not take it out until the truck has been off for 30 minutes or so. I priced the part at a dealership for $12.77
Posted on Aug 04, 2009
Used the bulletin board - swapped out the resistor and it works now.
Thanks for the bulletin boards...
Posted on Dec 17, 2009
Testimonial: "1 problem; 1 solution; 1 fix...great work!!!"
Tips for a great answer:
May 26, 2016 | Dodge Dakota Cars & Trucks
Dec 12, 2015 | 2005 Dodge Dakota Club
Jul 31, 2014 | 2005 Dodge Durango SLT
Feb 20, 2013 | 2003 Dodge Durango
Dec 27, 2009 | 2003 Dodge Durango
Nov 04, 2009 | 2005 Dodge Durango
Aug 01, 2008 | 2001 Dodge Durango
75 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: