Question about Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You need access to VagCom (the diagnostic software from VW and Audi). You can download it free at www.ross-tech.com, and buy the interface cable for your laptop on eBay for about $20. Or you can pay an hour's labor at a VW/Audi dealer to have them turn off the light.
What probably happened is similar to what happened in my 99 Audi A4. I have side airbags in the seats, and if the front seats are moved all the way back for any reason, it puts tension on the yellow airbag connector under the seat. That pulls it out just enough to open the contact and trip an airbag failure light. What I did was zip-tie the connector tightly (be very careful of the wires, as they're small and you don't want to pinch them), then use VagCom to turn off the light. Using the software is the only way to turn the light off - no ignition cycling or drive cycles, or number of miles driven, nor a battery disconnect, can reset the light.
Use VagCom to find out which airbag is giving you trouble, zip-tie its connector, and have the light turned off. Then you're set.
Posted on Jul 21, 2008
SOURCE: peugeot 1007
get dealer to explain .its a wonderous thing ,can be driven as a manual or auto,and no its new they have been around for years all lnodon buses were like this but worked manually not with electronics
Posted on Jan 17, 2009
if your foult is driver side airbag and it is not blown out, you should check "clock spring" wires behind steering whell.
if foult is driver side belt tensioner, check conector underneeth driver seat.
on the end erase foult/s with diagnostic equipment.
Posted on Oct 09, 2009
have you plugged the air bag wires back in under the seat?
if you have put after market of non genuine seats in you will not be able to turn light off
you could remove the bulb from the dash or just leave it (it will not affect the mot)
Posted on Dec 09, 2009
Tips for a great answer:
Oct 08, 2014 | 2005 Peugeot 1007 1.4
Dec 12, 2013 | 1999 Saturn SL
this warning light or any other stays on in the dash it is indicating
that the systems control module (or the system sensor in the case of
lights like low oil pressure, door open indicators etc.) has detected
a fault, it then disables the system (this applies to ABS,TCS, TCM,
SRS and BCM faults and others) as long as the light is on. You must
now have the dealer hook up a special electronic diagnostic tool and
"scan" the system for the fault code that is stored for the
Legend of Abbreviations. ABS Antilock brake system.TCS Traction control system, TCM Transmission control module, SRS Supplemental restraint system, BCM Body control module
Oct 22, 2012 | Peugeot Cars & Trucks
Dec 13, 2010 | Peugeot Liberte Cars & Trucks
Dec 01, 2009 | 2005 Peugeot 405
Sep 18, 2009 | 1989 Peugeot 405
Jul 21, 2009 | 1991 Peugeot 405
Dec 18, 2017 | Ford Cars & Trucks
147 people viewed this question
Usually answered in minutes!