Question about 2007 Mercury Hybrid 4WD Hybrid

2 Answers

95 Chevy Blazer 4.3 white smoke at idle

I just replaced the fuel injector spider pump under the plenum,but i still have lots of white smoke on cold starts and then it runs out no smoke but will smoke bad at idle,the check engine light comes on and off but no codes,thanks for any assistance,this smoked like this before i replaced the injectors,i was having a stsrt problem and low fuel mileage and the injectors cured that,but still have the access smoke at idle,thanks again

Posted by on

  • carlsurratt Jan 12, 2009

    thanks for the info,i am not losing any anti freeze but it does have a cylinder that misses bad when it is smoking,i think you may have a thought that the fuel portion of the intake may have a leaky gasket,i guess i will take manifold off and then the head,thanks again,



2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

My 1988 chevy blazer 4x4 smokes on cold starts till it warms up then it goes away what is causing it

Posted on Mar 10, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 328 Answers

Are you losing antifreeze? white smoke is usually a sign that antifreeze is getting into the cylinders and the result is the white smoke from the tailpipe. if you do a compression test and inspect the spark plugs for wetness you will find the cylinder that is leaking (you will have to replace the head gasket on the side if the engine if you find antifreeze in the cylinders) some times with blown head gaskets you will notice a lot of pressure in the radiator as well as air bubbles coming out of the radiator (caused by the compression coming from the cylinder through the cooling system and escaping through the radiator overflow or fill cap if you have it removed)
if there is any coolant galleries (water jackets) around the fuel plentum you may be getting the antifreeze into the intake/cylinders that way as well
hope this helps.....and keep me posted with comments here and ill be glad to assist you further.......thanks s60six!

Posted on Jan 11, 2009

  • s60six Jan 13, 2009

    no problem! keep me posted on your progress with a comment or two here in this post or if you need and advice or assistance as well.
    Good Luck!!!



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

My 2001 Chevy blazer 4.3 will idle but when given gas it Boggs down have replaced converter fuel pump plugs wires fist cap air filter checked vacuum leaks

I'm not familiar with Chevy's but a similar problem over the pond that is quite common is the EGR valve clogging up.
Not sure if this is relevant to a 2001 model but worth checking out.
Electricial cleaner is the best to use I have found.
hope this is of some help.

Aug 07, 2015 | Cars & Trucks

2 Answers

1999 Chevy blazer. Changed fuel pump, wont stay running.engine revs up and down, if I try to push in the gas pedal to see if it will clear up, it bogsdown and dies. Could this be the fuel pressure...

Yes sounds like a regulator issue. On the 99 blazer the regulator is under the plastic intake plenum and is a part of the fuel injection spider. I would also check for vacuum leaks and your idle air solenoid.

Oct 28, 2014 | 1999 Chevrolet Blazer

1 Answer


i think id be looking under the plenum at the fuel injection spider if its never been replaced. they get to leaking and make things run pretty badly at times. is it hard starting hot?? if so id look into that. you tube has many vids about this and the new replacement part is a lot better than originals were for sure/

Feb 23, 2018 | 2000 Chevrolet Blazer

1 Answer

Problems with 93 chevy blazer

Your blazer has central fuel injection (CFI). You said you changed injectors, but your injector in inside the intake manifold, and only has one injector and a "spider" of nylon tubes from the central injector to each intake port. It is common for these spiders to break, causing fuel to leak into the inside of the manifold, and cause problems like you described. The spiders are available as reconditioned and are quite expensive,

Jan 08, 2018 | Chevrolet Blazer Cars & Trucks

2 Answers

97 GMC Safari w/ 4.3(W) V6 vortec. 195k miles. Engine is running very rich. 10mpg. Smell of gas sometimes coming from exhaust when running. It has rough idle, and dies, especially when cold. Lacks power,...

your injector spider it look like a spider under the planium its the injector pipe that are broken if you check everything else that it you need to remove the planium you will see that injector module be carefull loosy plastic clip holding those injector in they break easy let me no and thanks for using fixya

Mar 01, 2011 | GMC Safari Cars & Trucks

1 Answer

!997 1500 pickup with 5.7 Vortec Miss Fire on cyl.#3 at Idle and low speeds Code is missfire #3 and internal Vacume leak.Compression seems good but Plags on 3 and 5 and fouled white. Vissual on Valve...

the injector spider assy is under the intake plenum. typically they leak and that causes odd richness and misfiring problems with them. if you pull the plenum off and find a lot of raw fuel thats the issue

Nov 27, 2017 | 1997 Chevrolet K1500

3 Answers

Know if my 95 chevy blazer has a spider CPI?

A spider injector is located underneath the intake plenum and this is multi-port. Otherwise you have a throttle body injector system. Vortec engines have spider injectors and they are super expensive to replace ($400.00- 850.00) each ! There is only one spider injector for each engine it has 6 legs/fuel tubes that go to each cylinder.

Oct 10, 2009 | 1995 Chevrolet Blazer

2 Answers

Replacing the o rings on a 95 chevy s10 2.2

The Injectors are right there in opening of the throttle body. There are not individual injectors for each cylinder.
There 2 or 4 injectors that spray the gas right on top the throttle plate. The entire manifold is filled with the gas/air mixture.

Oct 04, 2009 | 1995 Chevrolet S-10 CA Edition

2 Answers

How to manually get a trouble code out of a 95 blazer with vortec

The vortec motor has been known for the so caller spider assembly which is the fuel injection set up inside the intake manifold going bad.The regulator starts leaking wich puts extra fuel into the motor.If that is it you should change the whole assembly.

Nov 30, 2008 | 1995 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

1,385 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts


Level 3 Expert

78237 Answers


Level 3 Expert

5653 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides