Question about Chevrolet Cars & Trucks
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2002 chevy impla v6 esngine
Code p0102, on either the 3.4 or 3.8 (3800) v6 engine is a problem in the Mass Air Flow sensor (MAF). If any work has been done to it just prior to this code, then you need to make sure the air cleaner, duct work, breather tubes, etc. are properly connected and not loose. If that is OK, then may have a bad, or dirty sensor.
Posted on Jan 16, 2009
THIS IS VERY COMMEN IN FACT JUST ABOUT EVERY SINGLE 3.1AND 3.4 AND 3.8 EVER MADE BY CHEVY LEAKS AT THE LOWER INTAKE ALL OF THEM AND USEALLY STARTS AT ABOUT 50000 MILES THE PARTS COST ABOUT 300.00 AT THE DEALER FOR NEW GASKETS AND COOLENT AND SEALENT ALL THE PARTS YOU WILL NEED THE PROBLEM IS ITS ABOUT A SIX HOUR JOB SO THE LABOR KILLS YA BUT IT IS ALOT OF WORK BUT THE GOOD PART IS THERE IS NO NEED TO REMOVE THE PUSH RODS ON A 3.8 LIKE YOU DO ON A 3.4 I CAN GIVE YOU THE STEPS IF YOU LIKE BUT THIS JOB IS BEST TO SEND TO A MECHANIC AS IT HAS A LOT OF LITTLE THINGS THAT MUST BE DONE OR YOU CAN MAKE A BIGGER MESS THEN YOU GOT ALREADY... HOPE THIS WAS HELP FULL LET ME NO IF YOU NEED MORE INFO
Posted on Mar 27, 2009
Gasket = $35 (permatex rubber)
Labor - my manual says 3 hours.
You'll have to be responsible for figuring out the labor price per hour depending on where you are located.
In MI, a garage is about $50/hr, and dealership = $85/hr
CA might be $95/$150/hr.
Parts are minimal on the job - its all labor.
Figure in about $20 for shop supplies... gasket remover, sealant, rags, etc.
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
Posted on Jun 02, 2009
Check to make sure the radiator fan is coming on watch it for ten minute as it runs it should come on if it doesn't replace the fan relay or the fan coolant temp senson located on engine block upper area of engine.
Posted on Jul 14, 2009
Tips for a great answer:
Dec 30, 2015 | Pontiac Cars & Trucks
Dec 28, 2015 | Cars & Trucks
Jan 22, 2013 | Cars & Trucks
Jan 17, 2010 | 2000 Buick LeSabre
Jul 14, 2009 | 1999 Pontiac Firebird
Dec 20, 2008 | 2006 Chevrolet Impala
45 people viewed this question
Usually answered in minutes!